2017 TOYOTA PRIUS V door lock

5218-2. Steps to take in an emergency
PRIUS v_OM_OM47B23U_(U)
8
When trouble arises
Once
Sounds
once for
5
seconds
• An attempt was made to lockthe doors using the smart key
system while the electronic
key was still inside the vehi-
cle.
• An attempt was made to lock either front door by opening a
door and putting the inside
lock button into the lock posi-
tion, then closing the door
with the electronic key still
inside the vehicle.
 Retrieve the electronic key
from the vehicle and lock
the doors again.
Once
• When the doors were
unlocked with the mechanical
key and then the power
switch was pressed, the elec-
tronic key could not be
detected in the vehicle.
• The electronic key could not
be detected in the vehicle
even after the power switch
was pressed two consecu-
tive times.
 Touch the electronic key to
the power switch while
depressing the brake
pedal.
Interior
buzzerExterior buzzerWarning messageDetails/Actions
(Flashes)
(Flashes)

539
PRIUS v_OM_OM47B23U_(U)
8
When trouble arises
8-2. Steps to take in an emergency
If the electronic key does not operate
properly
Use the mechanical key (P. 11 7 )
in order to perform the following
operations:
Locks all the doors
Unlocks the door
Turning the key rearward unlocks
the driver’s door. Turning the key
once again within 3 seconds
unlocks the other doors.
Ensure that the shift position is in P and depress the brake pedal.
Touch the Toyota emblem side
of the electronic key to the
power switch.
When the electronic key is
detected, a buzzer sounds and the
power switch will turn to ON mode.
When the smart key system is
deactivated in customization set-
ting, the power switch will turn to
ACCESSORY mode.
Firmly depress the brake pedal and check that the smart key sys-
tem indicator light (green) turns on (vehicles without multi-informa-
tion display) or is shown on the multi-information display
(vehicles with multi-information display).
If communication between the electronic key and vehicle is
interrupted ( P. 133) or the electronic key cannot be used
because the battery is depleted, the smart key system and
wireless remote control cannot be used. In such cases, the
doors can be opened and the hybr id system can be started by
following the procedure below.
Locking and unlocking the doors
1
2
Starting the hybrid system
1
2
3

5438-2. Steps to take in an emergency
PRIUS v_OM_OM47B23U_(U)
8
When trouble arises
Make sure the “READY” indicator comes on. If the indicator light
does not come on, contact your Toyota dealer.
Once the hybrid system has started, remove the jumper cables in
the exact reverse order from which they were connected.
Close the exclusive jump starting terminal cover, and reinstall the
fuse box cover to its original position.
When installing, first hook the fuse box cover onto the two rear tabs.
Once the hybrid system starts, have the vehicle inspected at your
Toyota dealer as soon as possible.
■ Starting the hybrid system when th e 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
■ To prevent 12-volt battery discharge
●Turn off the headlights and the audio system while the hybrid system is off.
● Turn off any unnecessary electrical components when the vehicle is running
at a low speed for an extended period, such as in heavy traffic.
■ Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when
the vehicle is not in use, due to natural discharge and the draining effects of
certain electrical appliances. If the vehicle is left for a long time, the 12-volt
battery may discharge, and the hybrid system may be unable to start. (The
12-volt battery recharges automatically while the hybrid system is operating.)
■ When recharging or repl acing the 12-volt battery
● In some cases, it may not be possible to unlock the doors using the smart
key system when the 12-volt battery is discharged. Use the wireless remote
control or the mechanical key to lock or unlock the doors.
● The hybrid system may not start on the first attempt after the 12-volt battery
has recharged but will start normally after the second attempt. This is not a
malfunction.
● The power switch mode is memorized by the vehicle. When the 12-volt bat-
tery is reconnected, the system will return to the mode it was in before the
12-volt battery was discharged. Before disconnecting the 12-volt battery,
turn the power switch off. If you are unsure what mode the power switch was
in before the 12-volt battery discharged, be especially careful when recon-
necting the 12-volt battery.
● If the 12-volt battery discharges while the shift position is in P, it may not be
possible to shift the shift position to other positions. In this case, the vehicle
cannot be towed without lifting both front wheels because the front wheels
will be locked. ( P. 486)
● When the 12-volt battery is reconnected, start the hybrid system and con-
firm that the shift position can be changed to each position using the shift
position indicator.
6
7
8

578
PRIUS v_OM_OM47B23U_(U)
9-2. Customization
■Changing using the Entune Premium Audio with Navigation (if
equipped)
Press the “APPS” button on the navigation system.
Select “Setup” on the “APPS” screen.
Select “Vehicle” on the “Setup” screen and select “Vehicle Cus-
tomization”.
Various settings can be changed. Refer to the list of settings that
can be changed for details.
Vehicles with multi-information display: Settings that can be
changed using the multi-information display
Vehicles with Entune Audio or Entune Premium Audio with Naviga-
tion: Settings that can be changed using the Entune Audio or
Entune Premium Audio with Navigation
Settings that can be changed by your Toyota dealer
Definition of symbols: O = Available, – =Not available
■Door lock ( P. 120, 539)
Customizable features
1
2
3
1
2
3
FunctionDefault
settingCustomized setting
Automatic door lockingShift position linkedSpeed linked–OO
Off–OO
Automatic door unlock-
ingShift position linkedDriver’s door linked–OO
Off–OO
123

PRIUS v_OM_OM47B23U_(U)
5799-2. Customization
9
Vehicle specifications
■Smart key system and wireless remote control (P. 130, 116)
■Smart key system ( P. 130)
FunctionDefault
settingCustomized setting
Operation signal
(buzzer) 5Off
–OO
1 to 7
Operation signal (emer-
gency flashers) On Off – O O
Open door reminder
buzzer (when locking the
vehicle)
OnOff––O
Time elapsed before the
automatic door lock
function is activated if a
door is not opened after
being unlocked
60 seconds
Off
–OO30 seconds
120 seconds
123
FunctionDefault
settingCustomized setting
Smart door unlocking Driver’s door All the doors – O O
Number of consecutive
door lock operations2 timesAs many as desired––O
123

580
PRIUS v_OM_OM47B23U_(U)
9-2. Customization
■Wireless remote control (P. 116)
■Automatic light control system ( P. 191)
*1: This function cannot be customized for vehicles sold in Canada.
*2: Entune Premium Audio with Navigation only.
FunctionDefault
settingCustomized setting
Wireless remote control On Off – – O
Unlocking operation
Driver’s door
unlocked in first
step, all doors
unlocked in sec-
ond step
All doors
unlocked in first
step
–OO
Panic function OnOff––O
123
FunctionDefault
settingCustomized setting
Time elapsed before the
headlights turn off 30 secondsOff
–OO
60 seconds
90 seconds
Light sensor sensitivityLevel 0Level -2 to 2–OO
Daytime running lights*1OnOff–O*2O
123

PRIUS v_OM_OM47B23U_(U)
5819-2. Customization
9
Vehicle specifications
■Illumination (P. 375)
*: if equipped
FunctionDefault
settingCustomized setting
Time elapsed before the
interior lights turn off 15 secondsOff
–OO
7.5 seconds
30 seconds
Operation after the
power switch is turned
off
OnOff––O
Operation when the
doors are unlocked with
the smart key system or
the wireless remote con-
trol function or the
mechanical key
OnOff––O
Operation when you
approach the vehicle
with the electronic key
on your person
OnOff––O
Footwell lighting*OnOff––O
Footwell lighting control*OnOff––O
123

PRIUS v_OM_OM47B23U_(U)
5839-2. Customization
9
Vehicle specifications
■Automatic air conditioning system (P. 366)
■Panoramic roof shades* ( P. 391)
*: If equipped
■
Seat belt reminder ( P. 496)
■Reverse buzzer ( P. 185)
FunctionDefault
settingCustomized setting
A/C auto switching oper-
ationOffOn–OO
Heating/cooling opera-
tion minimized in Eco
drive mode
OnOff––O
Switching between out-
side air and recirculated
air mode linked to A/C
auto switch operation
OnOff––O
123
FunctionDefault
settingCustomized setting
Door lock linked auto-
matic closing functionOnOff––O
123
FunctionDefault settingCustomized setting
Vehicle speed linked
seat belt reminder
buzzer
OnOff––O
123
FunctionDefault settingCustomized setting
Signal (buzzer) when the
shift position is in RIntermittentSingle––O
123