2017 TOYOTA GT86 engine

JOBNAME: 2372396-en-2017_SCIO PAGE: 36 SESS: 4 OUTPUT: Thu Jun 23 13:07:16 2016
/InfoShareAuthorCODA/InfoShareAuthorCODA/TS_Warr_Maint/2372396-en-2017_S\
CION-FRS.00505-17WMG-FRS_/TS_Warr_Maint_v3
Severe Operating Conditions
In addition to standard maintenance items,
the maintenance log indicates services that
should be performed on vehicles that are
driven under especially demanding
conditions. These “severe operating
conditions” and their required maintenance
items are clearly indicated in the chart.
NOTE:
You should perform these additional
maintenance services if you drive
primarilyunder any of the severe
operating conditions indicated. If you
drive only occasionally under these
conditions, it is not necessary to
perform the additional services.
Engine Oil Selection
Please refer to yourOwner’s Manualfor
the specific oil viscosity rating
recommended for your vehicle/engine
type.
Additional Maintenance
In addition to scheduled maintenance,
your Toyota requires ongoing general
maintenance such as fluid checks and
visual inspections. These procedures are
explained in the “Maintenance and Care”
section of the
Owner’s Manual. Be sure to
perform these procedures regularly to
ensure the most trouble-free operation of
your vehicle.
SuperChrome and Alloy Wheel
Care
If you purchased genuine Toyota
accessory Aluminum Alloy Wheels, follow
these cleaning guidelines to maintain the
appearance of your alloy wheels:
•If wheels are hot, wait for them to cool
before washing.
•Use a soft sponge or cotton cloth to
apply the same mild car-wash soap as
used for the vehicle body. Quickly rinse
off with water. Use a soft cloth to apply
the same car wax as used for the
vehicle body.
•DO NOT USE: Any kind of chemical
based cleaners, alcohol, solvents,
gasoline, steam cleaners, scouring
pads, wire brushes, or coarse abrasives
to clean your wheels.
Using the Maintenance Log Charts
Maintenance Log36
MAINTENANCE

JOBNAME: 2372396-en-2017_SCIO PAGE: 38 SESS: 4 OUTPUT: Thu Jun 23 13:07:16 2016
/InfoShareAuthorCODA/InfoShareAuthorCODA/TS_Warr_Maint/2372396-en-2017_S\
CION-FRS.00505-17WMG-FRS_/TS_Warr_Maint_v3
Maintenance ItemMaintenance Interval (Miles or Number of months, whichever occurs first)
After the described period, continue to follow the described maintenance at the recommended
intervals.
I = Inspect; R = Replace, Change, Tire Rotate or lubricate; T= Tighten to specified torque
Miles (000) 7.5 15 22.5 30 37.5 45 52.5 60 67.5 75 82.5 90
Months 7.5 15 22.5 30 37.5 45 52.5 60 67.5 75 82.5 90Clutch fluid and system operations
IIIIII
Drive belt III
Drive shaft boots Normal IIIIII
Driving on dirt
or dusty roads IIIIIIIIIIII
Severe Repeated short driving distance; driving on rough and/or muddy roads; when operating on rough and/or muddy roads; driving in extremely cold weather; in areas where road salts or other corrosive materialsare used; if living in coastal areas, inspect every 7,500 miles or 7.5 months, whichever occurs first
Engine oil and oil filter Normal RRRRRRRRRRRR
Severe Repeated short distance driving; driving in extremely cold weather, replace every 3,750 miles or 3 and
3/4 months, whichever occurs firstEngine coolant Inspect III
Replace First replace at 135,000 miles or 132 months, then replace at every 75,000 miles or 72 months,
whichever occurs first
Note: See the “Explanation of Maintenance Items” section in the back of this guide for more information.
Engine air filter Normal RRR
Driving on dirt
or dusty roads IIIRIIIRIIIR
Note: When the vehicle is used in extremely dusty conditions, the air filter cleaner element should be replace more often
Scheduled Maintenance
MAINTENANCE
38Maintenance Log

JOBNAME: 2372396-en-2017_SCIO PAGE: 42 SESS: 4 OUTPUT: Thu Jun 23 13:07:16 2016
/InfoShareAuthorCODA/InfoShareAuthorCODA/TS_Warr_Maint/2372396-en-2017_S\
CION-FRS.00505-17WMG-FRS_/TS_Warr_Maint_v3
Drive Shaft Boots
Check the drive shaft boots and clamps
for cracks, deterioration and damage.
Replace any deteriorated or damaged parts
and, if necessary, repack the grease. A
qualified technician should perform these
operations.
Driver’s Floor Mat
•Only use the driver’s floor mat
designed specifically for the model and
model year of your vehicle.
•Always properly secure the driver’s
floor mat using the retaining hooks.
•Never install another floor mat on top
of the existing driver’s floor mat.
•Never install the driver’s floor mat
upside down.
Engine Air Filter
Replace at specified intervals. When
performing inspections, check for damage,
excessive wear and oiliness, and replace if
necessary.
Engine Coolant, Radiator and
Condenser
Drain the cooling system and refill with an
ethylene-glycol type coolant. Inspect the
radiator, condenser and/or intercooler for
leaves, dirt and insects, and clean if
necessary. Inspect hoses and connections
for corrosion and leaks. Tighten
connections and replace parts when
necessary. A qualified technician should
perform these operations. (For further
details, refer toRadiator, Condenser and
Hoses in theVehicle Maintenance and
Care section of the
Owner’s Manual).
Your Toyota is equipped with Genuine
Toyota Super Long-Life Coolant (SLLC)
BLUE. The replacement intervals for
engine coolant recommended in this
booklet are based on replacement with
Genuine Toyota Super Long-Life Coolant
(SLLC) BLUE or similar high-quality
non-silicate, non-amine, non-borate
ethylene-glycol coolant with long-life
hybrid organic acid technology (i.e., a
combination of low phosphates and
organic acids). If another type of
ethylene-glycol coolant is used,
replacement intervals may be different.
Do not use plain water.
Explanation of Maintenance Items
Maintenance Log42
MAINTENANCE

JOBNAME: 2372396-en-2017_SCIO PAGE: 43 SESS: 4 OUTPUT: Thu Jun 23 13:07:16 2016
/InfoShareAuthorCODA/InfoShareAuthorCODA/TS_Warr_Maint/2372396-en-2017_S\
CION-FRS.00505-17WMG-FRS_/TS_Warr_Maint_v3
Engine Oil and Oil Filter
Replace the oil filter and drain and refill
the engine oil at specified intervals. For
recommended oil grade and viscosity,
refer to the
Owner’s Manual.
Exhaust Pipes and Mountings
Visually inspect the exhaust pipes, muffler
and hangers for cracks, deterioration and
damage. Start the engine and listen
carefully for any exhaust gas leakage.
Tighten connections or replace parts as
necessary.
Fuel Lines and Connections,
Fuel Tank Vapor Vent System
Hoses and Fuel Tank Band
Visually inspect for corrosion, damage,
cracks, and loose or leaking connections.
Tighten connections or replace parts as
necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks, deterioration
and damage and replace if necessary.
Nuts and Bolts on Chassis and
Body
Re-tighten the seat-mounting bolts and
front/rear suspension member retaining
bolts to specified torque.
Spark Plugs
Replace at specified intervals. Install new
plugs of the same type as originally
equipped. A qualified technician should
perform this operation.
Steering Gear
Inspect for signs of leakage. If you
discover any leakage, have it repaired
immediately by a qualified technician.
Steering Linkage and Boots
With the vehicle stopped, check for
excessive freeplay in the steering wheel.
Inspect the linkage for bending and
damage and the dust boots for
deterioration, cracks and damage. Replace
any damaged parts. A qualified technician
should perform these operations.
Tire Rotation
Tires should be rotated according to the
instructions in the Owner’s Manual. When
rotating tires, check for damage and
uneven wear. Replace if necessary.
Automatic Transmission Fluid or
Manual Transmission Oil
Inspect or replace at specified intervals.
When performing inspections, check each
component for signs of leakage. If you
discover any leakage, have it repaired by a
qualified technician immediately.
Explanation of Maintenance Items
Maintenance Log43
MAINTENANCE