2017 TOYOTA C-HR display

4434-5. Using the driving support systems
4
Driving
C-HR_OM_Europe_OM10528E
■Using the exit parallel parking assist mode to depart
Press the S-IPA switch and
check that the display on the
multi-information display
switches to exit parallel park-
ing assist mode.
Operate the turn signal lever
to select whether you would
like to depart to the left or
right.
If there are any obstacles in the
direction the vehicle is departing
in, the system determines that it
is not possible to depart, and
assist control is stopped.
1
2

4444-5. Using the driving support systems
C-HR_OM_Europe_OM10528E
Shift the shift lever to R.
The multi-information display will change, S-IPA indicator will come on
and automatic steering will begin. While taking care not to get your
hands caught up in the steering wheel and checking the safety of the
surrounding area, reverse the vehicle slowly by operating the accelera-
tor and brake pedals. During automatic steering, maintain a vehicle
speed of 7 km/h (4 mph) or less.
When the multi-information
display changes, reduce the
vehicle speed.
While checking the safety of the
area behind the vehicle and
assistance level indicator,
reverse the vehicle slowly.
3
4

4454-5. Using the driving support systems
4
Driving
C-HR_OM_Europe_OM10528E
When the buzzer sounds,
completely stop the vehicle
immediately.
The multi-information display
will change when the buzzer
starts sounding.
Shift the shift lever to D (Multidrive) or 1 (manual transmission).
While the steering wheel is turning, keep the vehicle at a complete stop.
When the steering wheel stops turning, move the vehicle forward slowly
while checking the safety of the area in front of the vehicle and assis-
tance level indicator.
5
6

4464-5. Using the driving support systems
C-HR_OM_Europe_OM10528E
When the buzzer sounds,
completely stop the vehicle
immediately.
The multi-information display
will change when the buzzer
starts sounding.
Shift the shift lever to R.
While the steering wheel is turning, keep the vehicle at a complete stop.
When the steering wheel stops turning, move the vehicle forward slowly
while checking the safety of the area in front of the vehicle and assis-
tance level indicator.
Repeat steps through until the parking assist operation
has completed.
When the vehicle has nearly reached the take-off point, the buzzer
sounds and assist control finishes. From there, grasp the steering wheel
and proceed forward.
7
8
948

4484-5. Using the driving support systems
C-HR_OM_Europe_OM10528E
Multi-information display messages
MessageCauseWhat to do
“IPA Malfunction. Visit
Your Dealer.”System malfunction.
Have the vehicle
inspected by any
authorized Toyota
retailer or Toyota autho-
rized repairer, or any
reliable repairer imme-
diately.
“IPA Space Not
Detected, Speed Too
High.”
The vehicle speed
exceeded.
Reduce vehicle speed.
• Perpendicular park-
ing assist mode:
20 km/h (12 mph) or
less
• Parallel parking
assist mode: 30 km/h
(18 mph) or less

4514-5. Using the driving support systems
4
Driving
C-HR_OM_Europe_OM10528E
“IPA Cancelled, Take
Over. TRC/VSC is Off.”
The VSC off switch was
turned off.
Turn the VSC off switch
on.
“IPA Cancelled, Take
Over. TRC/ABS/VSC
Activated.”
The TRC, VSC or ABS
operated.
• If the operation was
canceled during
detection of a parking
space, turn the S-IPA
switch on again.
• If the operation was
canceled during
automatic steering,
park the vehicle man-
ually or detect
another parking
space.
“IPA Cancelled, Take
Over. Timeout.”
More than 6 minutes
have elapsed since the
S-IPA switch was
turned on before auto-
matic steering could
begin.
Park the vehicle manu-
ally or detect another
parking space.
More than 6 minutes
have elapsed since the
shift lever was shifted
to R and automatic
steering began, before
the parking assist oper-
ation could complete.
Park the vehicle manu-
ally or detect another
parking space.
More than 3 minutes
have passed with “Wait
For Room To
Maneuver” displayed.
Park the vehicle manu-
ally or detect another
parking space.
MessageCauseWhat to do

4604-5. Using the driving support systems
C-HR_OM_Europe_OM10528E
WARNING
●In the following situations, the sensors may not operate normally and may
lead to an accident. Drive carefully.
• Obstacles cannot be detected in the side areas until a scan of the side
areas is completed. ( P. 415)
• Even after the scan of the side areas is completed, obstacles such as
other vehicles, people or animals that approach from the sides cannot
be detected.
• The sensor is frozen (if it thaws, the system returns to normal).
A warning message may display at particularly low temperatures due to
the sensor freezing and it may not detect parked vehicles.
• The sensor is blocked by someone’s hand.
• The vehicle is tilted a large amount.
• The temperature is extremely hot or cold.
• The vehicle is driven on undulating roads, slopes, gravel roads, in areas
with tall grass, etc.
• An ultrasonic wave source is nearby, such as the horn or sensors of
another vehicle, a motorcycle engine or the air brake of a large vehicle.
• Heavy rain or a water strikes the vehicle.
• Do not install any accessories within the sensor detection range.

4644-5. Using the driving support systems
C-HR_OM_Europe_OM10528E
If the vehicle gets stuck in mud, dirt or snow, the TRC system may
reduce power from the engine to the wheels. Pressing to turn
the system off may make it easier for you to rock the vehicle in order
to free it.
To turn the TRC system off,
quickly press and release .
A message will be shown on the
multi-information display.
Press again to turn the sys-
tem back on.
■ Turning off both TRC and VSC systems
To turn the TRC and VSC systems off, press and hold for more than 3
seconds while the vehicle is stopped.
The VSC off indicator light will come on and the message will be shown on
the multi-information display.*
Press again to turn the system back on.
*: On vehicles with pre-collision system, pre-collision brake assist and pre-
collision braking will also be disabled. The PCS warning light will come on
and the message will be shown on the multi-information display. ( P. 696)
■ When the message is displayed on the multi-information display show-
ing that TRC has been disabled even if has not been pressed
TRC cannot be operated. Contact any authorized Toyota retailer or Toyota
authorized repairer, or any reliable repairer.
Disabling the TRC system