Page 8 of 661

8
UK AURIS_HB_EE (OM12K97E)Please note that this manual applies to all models and explains all equipment,
including options. Therefore, you may find some explanations for equipment
not installed on your vehicle.
All specifications provided in this manual are current at the time of printing.
However, because of the Toyota policy of continual product improvement, we
reserve the right to make changes at any time without notice.
Depending on specifications, the vehicle shown in the illustrations may differ
from your vehicle in terms of equipment.
Both genuine Toyota and a wide variety of other spare parts and accessories
for Toyota vehicles are currently available on the market. Should it be deter-
mined that any of the genuine Toyota parts or accessories supplied with the
vehicle need to be replaced, Toyota recommends that genuine Toyota parts
or accessories, be used to replace them. Other parts or accessories of
matching quality can also be used. Toyota cannot accept any liability or guar-
antee spare parts and accessories which are not genuine Toyota products,
nor for replacement or installation involving such parts. In addition, damage
or performance problems resulting from the use of non-genuine Toyota spare
parts or accessories may not be covered under warranty.
For your information
Main Owner’s Manual
Accessories, spare parts and modification of your Toyota
UK AURIS_HB_OM_Europe_OM12K97E.book 8 ページ 2016年6月27日 月曜日 午後5時42分
Page 35 of 661

351-1. For safe use
1
For safety and security
UK AURIS_HB_EE (OM12K97E)
WARNING
Observe the following precautions.
Failure to do so may cause the driver’s floor mat to slip, possibly interfering
with the pedals while driving. An unexpectedly high speed may result or it may
become difficult to stop the vehicle. This could lead to an accident, resulting in
death or serious injury.
■When installing the driver’s floor mat
●Do not use floor mats designed for other models or different model year
vehicles, even if they are Toyota Genuine floor mats.
●Only use floor mats designed for the driver’s seat.
●Always install the floor mat securely using the retaining hooks (clips) pro-
vided.
●Do not use two or more floor mats on top of each other.
●Do not place the floor mat bottom-side up or upside-down.
■Before driving
●Check that the floor mat is securely
fixed in the correct place with all the
provided retaining hooks (clips). Be
especially careful to perform this check
after cleaning the floor.
●With the engine stopped and the shift
lever in P (Multidrive) or N (manual
transmission), fully depress each pedal
to the floor to make sure it does not
interfere with the floor mat.
UK AURIS_HB_OM_Europe_OM12K97E.book 35 ページ 2016年6月27日 月曜日 午後5時42分
Page 52 of 661
521-1. For safe use
UK AURIS_HB_EE (OM12K97E)
“PASSENGER AIR BAG” indi-
cator
Vehicles without a smart entry &
start system: The “PASSENGER
AIR BAG” and “ON” indicator light
turns on when the airbag system is
on, and about after 60 seconds
they go off (only when the engine
switch is in the “ON” position).
Vehicles with a smart entry & start
system: The “PASSENGER AIR
BAG” and “ON” indicator light turns
on when the airbag system is on,
and about after 60 seconds they go
off (only when the engine switch is
in IGNITION ON mode).
Airbag manual on-off switch
Airbag manual on-off system
This system deactivates the front passenger airbag.
Only deactivate the airbag when using a child restraint system
on the front passenger seat.
1
2
UK AURIS_HB_OM_Europe_OM12K97E.book 52 ページ 2016年6月27日 月曜日 午後5時42分
Page 94 of 661

942. Instrument cluster
UK AURIS_HB_EE (OM12K97E)
*1: These lights, except those shown on the multi-information display, turn on
when the engine switch is turned to the “ON” position (vehicles without a
smart entry & start system) or IGNITION ON mode (vehicles with a smart
entry & start system) to indicate that a system check is being performed.
They will turn off after the engine is started, or after a few seconds. There
may be a malfunction in a system if a light does not come on, or turn off.
Have the vehicle inspected by any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
*2: The light flashes to indicate a malfunction.
*3: The light flashes quickly to indicate that the steering lock has not been
released.
*4: This light illuminates on the center panel.
*3
(Green)
(if equipped)
Smart entry & start sys-
tem indicator (P. 213)
*4
(if equipped)
Rear passengers’ seat
belt reminder lights
(P. 545)
(Yellow)
(if equipped)
Smart entry & start sys-
tem indicator (P. 545)*1
(if equipped)
Tire pressure warning
light (P. 546)
Low fuel level warning
light (P. 545)*1
(if equipped)
Master warning light
(P. 546)
Driver’s and front pas-
senger’s seat belt
reminder light (P. 545)
UK AURIS_HB_OM_Europe_OM12K97E.book 94 ページ 2016年6月27日 月曜日 午後5時42分
Page 96 of 661

962. Instrument cluster
UK AURIS_HB_EE (OM12K97E)
*1: These lights, except those shown on the multi-information display, turn on
when the engine switch is turned to the “ON” position (vehicles without a
smart entry & start system) or IGNITION ON mode (vehicles with a smart
entry & start system) to indicate that a system check is being performed.
They will turn off after the engine is started, or after a few seconds. There
may be a malfunction in a system if a light does not come on, or turn off.
Have the vehicle inspected by any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
*2: The light flashes to indicate that the system is operating.
*3: Vehicles with a 3-ring meter
*4: Vehicles with a 2-ring meter
*5: The light does not turn on when the system is disabled.
*6: This light illuminates on the center panel.
*7: When the outside temperature is approximately 3°C (37°F) or lower, the
indicator will flash for approximately 10 seconds, then stay on.
*1, 3
(if equipped)
Gear Shift Indicator
(P. 231)
(if equipped)
Engine preheating indi-
cator (P. 209, 213)
*4
(if equipped)
Gear Shift Indicator
(P. 231)
(Green)
(if equipped)
Smart entry & start sys-
tem indicator (P. 213)
*1, 5
(if equipped)
Eco Driving Indicator
Light (P. 105, 115)
*7
(if equipped)
Low outside tempera-
ture indicator (P. 98)
*6Security indicator
(P. 75, 87)*1, 6“PASSENGER AIR
BAG” indicator (P. 52)
(if equipped)
“SPORT” indicator
(P. 224)
UK AURIS_HB_OM_Europe_OM12K97E.book 96 ページ 2016年6月27日 月曜日 午後5時42分
Page 104 of 661
1042. Instrument cluster
UK AURIS_HB_EE (OM12K97E)
The following display items can be customized:
◆Customizable items
■Eco Driving Indicator Light (if equipped)
Can be enabled or disabled
■Stop & Start system operation time pop-up display (if
equipped)
Current Stop & Start system operation time can be enabled or dis-
abled.
◆Customizing the display
To change to the customizing mode screen, display the odometer
and then press and hold the display change switch or the “DISP”
switch for 5 seconds or more.
To change the setting, press the display change switch or the
“DISP” switch.
Each time the switch is pressed, the setting will be changed.
After customization, press the display change switch or “DISP”
switch for 2 seconds or more to return to the odometer.
Display customization
1
2
UK AURIS_HB_OM_Europe_OM12K97E.book 104 ページ 2016年6月27日 月曜日 午後5時42分
Page 105 of 661

1052. Instrument cluster
UK AURIS_HB_EE (OM12K97E)
2
Instrument cluster
■Eco Driving Indicator (if equipped)
Eco Driving Indicator will not operate under the following conditions:
●The shift lever is in any position other than D.
●A paddle shift switch (if equipped) is operated.
●Sport mode is selected.
●The vehicle speed is approximately 130 km/h (80 mph) or higher.
■Stop & Start system operation time pop-up display (if equipped)
When enabled (P. 104), the current Stop & Start system operation time will
be displayed on the multi-information display.Eco Driving Indicator Light
During Eco-friendly acceleration (Eco
driving), the Eco Driving Indicator Light
will turn on. When the acceleration
exceeds the Zone of Eco driving, or
when the vehicle is stopped, the light
turns off.
Eco Driving Indicator Zone Display
Suggests the Zone of Eco driving with
current Eco driving ratio based on
acceleration.
Eco driving ratio based on acceleration
If the acceleration exceeds the Zone of Eco driving, the right side of the
Eco Driving Indicator Zone Display blinks and the Eco Driving Indicator
light will turn off.
Zone of Eco driving
1
2
3
4
UK AURIS_HB_OM_Europe_OM12K97E.book 105 ページ 2016年6月27日 月曜日 午後5時42分
Page 109 of 661

1092. Instrument cluster
UK AURIS_HB_EE (OM12K97E)
2
Instrument cluster
◆Changing the display
To change the displayed item,
press the “TRIP” switch.
Each time the switch is pressed,
the displayed item will be
changed.
◆Display items
■Odometer
Displays the total distance the vehicle has been driven.
■Trip meter A/trip meter B
Displays the distance the vehicle has been driven since the meter
was last reset. Trip meters A and B can be used to record and dis-
play different distances independently.
To reset, display the desired trip meter and press and hold the “TRIP”
switch.
■
Distance until next engine oil change (if equipped)
Displays the distance the vehicle can be driven until an oil change
is necessary.
The distance until the next engine oil change will also be displayed in
the following situations:
• When the engine switch is turned to the “ON” position (vehicles with-
out a smart entry & start system) or IGNITION ON mode (vehicles
with a smart entry & start system).
• When a warning message indicating that oil maintenance should be
performed soon or is required is displayed.
• Resetting: P. 472
Trip information/Distance until next engine oil change
UK AURIS_HB_OM_Europe_OM12K97E.book 109 ページ 2016年6月27日 月曜日 午後5時42分