Page 40 of 308
BASIC INFORMATION BEFORE OPERATION
38
BASIC INFORMATION BEFORE OPERATION
INITIAL SCREEN
INITIAL SCREEN
WARNING
OWhen the vehicle is stopped with the engine running, always
apply the parking brake for safety.
1.When the ignition switch is in the “ACC” or “ON”
position, the initial screen will be displayed and the
system will begin operating.
”After a few seconds, the “CAUTION (CAUTION)”
screen will be displayed.
2.SelectI Agree (I Agree).
”
After about 5 seconds, the “CAUTION (CAUTION)”
screen automatically switches to the next screen.
” With navigation function: Select
Language
(Language) to select a language.
X With navigation function
3.SelectAccept (Accept).
” & R Q ¿ U P W K H H Q G X V H U O L F H Q V H D J U H H P H Q W
Page 45 of 308
BASIC INFORMATION BEFORE OPERATION
43
BASIC FUNCTION
2
1.Turn the ignition switch to the “OFF” position.
2.Open the SD card slot cover.
3.Insert the SD card.
”Make sure that the SD card is fully inserted.
4.Close the SD card slot cover.
NOTE
O & R P S D W L E O H 6 ' F D U G : 3
O You can enjoy music/video by inserting an SD card containing
D X G L R
Page 46 of 308
BASIC INFORMATION BEFORE OPERATION
44
REMOVING AN SD CARD
CAUTION
OWhen removing an SD card from the unit, pull it out
horizontally. Do not pull it out upward or downward with force.
Doing so may damage the SD card.
O Do not remove an SD card during playback. Doing so may
corrupt the data. Please understand that no compensation will
be given for corrupted data.
O Do not pull the SD card slot cover with force. By doing so, the
SD card slot cover may come off, or be damaged. If the SD
card slot cover comes off, it can be reattached by inserting the
cover clip into the hole.
O Avoid touching the SD card terminals to prevent
contamination. Doing so may cause card read failure.
NOTE
O The system is reset and the initial screen appears if the map SD
card is removed during use, however, this is not a malfunction.
The map screen appears again approximately 7 seconds after
reinserting the map SD card.
O When removing an SD card from the unit and “Auto Adjust by
GPS (Auto Adjust by GPS)” is selected in the Clock Settings
: 3 W K H W L P H R Q W K H & O L P D W H & R Q W U R O Z L O O F K D Q J H W R
Greenwich Mean Time (GMT).
1.Turn the ignition switch to the “OFF” position.
2.Open the SD card slot cover.
3.Remove the SD card.
” Press in the SD card until you hear it “click”, let go of
the card, and then pull it straight out.
4.Close the SD card slot cover.
Page 56 of 308
BASIC OPERATION
54
BASIC OPERATION
SOME BASICS
This section describes some of the basic features of the
audio/visual system. Some information may not pertain to
your system.
Your audio/visual system works when the ignition switch is
turned to the “ACC” or “ON” position.
CAUTION
OTo prevent the battery from being discharged, do not leave
the audio/visual system on longer than necessary when the
engine is not running.
TURNING THE SYSTEM ON AND OFF
“POWER/VOLUME” knob: Press to turn the audio/visual
system on and off. The system turns on in the last mode
used. Turn this knob to adjust the volume. Note that the
voice guidance volume can be adjusted during guidance.
“AUDIO/TUNE” knob: Press to display screen buttons for
the audio/visual system.
”A function that enables automatic return to the split
screen from the audio/visual screen can be selected.
: 3
Page 72 of 308
RADIO OPERATION
70
No.Information/Function
6 H O H F W W R G L V S O D \ W K H V R X Q G V H W W L Q J V F U H H Q : 3
6 H O H F W W R G L V S O D \ D O L V W R I F D W H J R U L H V : 3
Select to search subscribed channels by category.
By turning TuneScan Enable ON with channels
registered in Smart Favorites,
Tune Scan (Tune
6 F D Q L V G L V S O D \ H G : 3
6 H O H F W W R U H F H L Y H W D J L Q I R U P D W L R Q : 3
Select to tune to a preset channel.
is displayed for channels registered in Smart
Favorites.
6 H O H F W W R W X U Q W K H 6 ; 0 ) H D W X U H G R Q R I I : 3
Select to show information such as channel name, song
title, and artist name.
6 H O H F W W R W X U Q W K H 7 X Q H 6 F D Q R Q R I I : 3
Select to display the “Edit Favorites (Edit Favorites)”
V F U H H Q : 3
6 H O H F W W R W X U Q W K H 7 X Q H 6 W D U W R Q R I I : 3
NOTE
O A clear line of sight is required from the satellite to the SiriusXM®
Satellite Radio antenna. Obstacles such as trees, tall buildings,
and tunnels can block the SiriusXM signal, causing the SiriusXM
radio reception to cut in and out.
O If the ignition switch is turned “OFF” and then set to the “ACC\
”
or “ON” position when listening to an XL channel, broadcasting
from the XL channel will not begin. If so, the SXM001 channel
will be broadcast.
O XL channels may include frequent explicit language or mature
programming.
HOW TO SUBSCRIBE TO SiriusXM® Satellite
Radio
To listen to a satellite radio broadcast in the vehicle, a
subscription to the SiriusXM® Satellite Radio service is
necessary.
A SiriusXM
® Satellite Radio is a tuner designed exclusively
to receive broadcasts provided under a separate
subscription. SiriusXM U.S. satellite and data services
are available only in the 48 contiguous USA and DC.
SiriusXM satellite service is also available in Canada; see
www.siriusxm.ca.
Page 148 of 308
BEFORE USING THE APPLICATION
146
BEFORE USING THE APPLICATION
BEFORE USING THE APPLICATION
Precautions to be aware of when using the application are
shown below.
In this chapter, iPhone or Android devices will be referred to
as a smartphone.
WARNING
ODo not connect or operate the smartphone while driving.
O Be sure to park the vehicle in a safe location before
connecting or operating the smartphone.
CAUTION
ODo not leave your smartphone in the car. In particular, high
temperatures inside the vehicle may damage the smartphone.
O Do not push down on or apply unnecessary pressure to the
smartphone while it is connected as this may damage the
smartphone or its terminal.
O If connecting your smartphone via USB, do not insert foreign
objects into the USB port as this may damage the smartphone
or its terminal.
NOTE
O Depending on the application, certain functions are not available
while driving for reasons of safety.
O In order to maximize signal reception, performance and precision
of the smartphone, please ensure the smartphone is placed as
close to the system as possible, while ensuring it is stowed and
secure while driving.
O When connecting your smartphone via USB, use the original
cables provided with your smartphone or equivalent third-party
F H U W L ¿ H G F D E O H V
O When the ignition switch is in the “ACC” or “ON” position, t\
he
battery of the connected smartphone is charged.
O If connecting your smartphone via USB, smartphone may not
be recognized when the ignition switch is in the “ACC” or “ON”\
position. In this case, remove the smartphone and reconnect it.
O The accuracy of the displayed information or the signal reception
performance depends on the smartphone or the connected
device, and its wireless connection.
O For operating the smartphone, see the instruction manual that
comes with it.
O ) R O O R Z W K H V S H F L
Page 189 of 308
SETTINGS
7
Bluetooth® SETTINGS
187
CHANGING “Bluetooth Power (Bluetooth Power)”
1.SelectBluetooth Power (Bluetooth Power).
Q WHEN “Bluetooth Power (Bluetooth Power)” IS ON
The Bluetooth device is automatically connected when
the ignition switch is turned to the “ACC” or “ON” position.\
Q WHEN “Bluetooth Power (Bluetooth Power)” IS OFF
The Bluetooth device is disconnected, and the system will
not connect to it next time.
NOTE
O While driving, the auto connection state can be changed from off
to on, but cannot be changed from on to off.
EDITING THE Bluetooth NAME
1.SelectBluetooth Name (Bluetooth Name).
2.Enter a name and then select OK (OK).
EDITING THE PIN-CODE
1.SelectBluetooth PIN (Bluetooth PIN).
2.Enter a PIN-code and then select OK (OK).
Page 291 of 308
WHAT TO DO IF
289
APPENDIX/WHAT TO DO IF/INDEX
10
XWhen registering/connecting a cellular phone
Symptom Likely cause SolutionPage
Cellular phone This
system
A cellular phone cannot be
registered. An incorrect passcode was entered
on the cellular phone.
Enter the correct passcode on the
cellular phone.
*-
The registration operation has not
been completed on the cellular phone
side. Complete the registration operation
on the cellular phone (approve
registration on the phone).
*-
Old registration information remains
on either this system or the cellular
phone. Delete the existing registration
information from both this system and
the cellular phone, then register the
cellular phone you wish to connect to
this system.
* 181
A Bluetooth connection cannot be
made. Another Bluetooth device is already
connected.
Manually connect the cellular phone
you wish to use to this system.
-182
Bluetooth function is not enabled on
the cellular phone. Enable the Bluetooth function on the
cellular phone.
*-
Automatic Bluetooth connection on
this system is set to off. Set automatic Bluetooth connection
on this system to on when the ignition
switch is turned to the “ACC” or “ON”
position.
-187
*: For details, refer to the owner’s manual that came with the cellular phone.
