Page 86 of 106

Conventional Cruise Control
83
CAUTION
When shifting the select lever to the   position, Conventional Cruise Control
will be automatically canceled. Do not shift the lever to the   position unless
it is an emergency. Otherwise the engine brake may not operate, which could
cause an accident.
 NOTE
 xIf EyeSight is malfunctioning, the EyeSight warning indicator is displayed
on the multi information display and the Pre-Collision Braking System OFF
indicator light and Lane Departure Warning OFF indicator light illuminate. If
this occurs, stop the vehicle in a safe location and then stop the engine
and restart it. If the indicators remain illuminated after restarting the
engine, Conventional Cruise Control cannot be used. This will not interfere
with ordinary driving; however the system should be inspected by a
SUBARU dealer as soon as possible.
 Ÿ Refer to page 86.
 x When operation of Conventional Cruise Control has been automatically
canceled, perform the set operation again after the condition that caused
the cancellation has been eliminated. If cruise control cannot be set even
after the condition has been corrected, EyeSight may be malfunctioning.
This will not interfere with ordinary driving; however the system should be
inspected by a SUBARU dealer as soon as possible.
N
N 
         
        
        
     
        
        Page 89 of 106

86
EyeSight malfunction and temporary stop
If a malfunction is detected in the EyeSight system, the indicators in the instrument panel
and the multi information display inform the driver of the malfunction. Check the displayed
contents and take the appropriate action.
■Malfunction (including position/angle misalignment of stereo
cameras)
The buzzer sounds 1 short beep and the
EyeSight warning indicator   (yellow)
flashes or illuminates. At the same time, the
Pre-Collision Braking System OFF indicator
light and the Lane Departure Warning OFF
indicator light will illuminate. A message will
also be displayed on the multi information
display.
Displayed screen Cause Action An EyeSight malfunction or
position/angle misalignment
of stereo cameras has
occurred. Inspection and adjustment is
necessary.
Contact your SUBARU dealer.
CAUTION
If both the EyeSight warning indicator and the CHECK ENGINE warning
light/malfunction indicator light illuminate at the same time while driving, have
your vehicle checked/repaired by a SUBARU dealer as soon as possible.
EyeSight cannot be used if there is an abnormality with the engine, etc.
 NOTE
 x
If the EyeSight warning indicator illuminates or flashes, stop the vehicle in
a safe location, turn off the engine and then restart it.
 x If the EyeSight warning indicator illuminates or flashes, the RAB system
will not operate.
 x If the indicator continues illuminating or flashing even after the engine has
been restarted, the EyeSight system has a malfunction. In this case, all
EyeSight functions will be stopped. Normal driving will still be possible.
However, contact a SUBARU dealer for an inspection.
S01134
S00699 
         
        
        
     
        
        Page 90 of 106

EyeSight malfunction and temporary stop
87
■Temporary stop
The buzzer will sound one short beep, and the
EyeSight temporary stop indicator 
(white), Pre-Collision Braking System OFF
indicator light and Lane Departure Warning
OFF indicator light will illuminate at the same
time.
A message will also be displayed on the multi
information display.
When the cause has been eliminated, tempo-
rary stop will be canceled and the EyeSight
system will automatically restart.
Displayed screen Cause Action It is difficult for the stereo
cameras to detect objects in
front
 xThe front windshield is 
dirty or fogged up
 x Poor weather conditions
 x Strong light from the front  x
Clean the front windshield.
 x In bad weather or if there is 
strong light from the front, 
the EyeSight system will 
restart once you have driven 
your vehicle for a period of 
time and the conditions 
affecting the system have 
improved.
If the system does not 
restart, even after the condi-
tions have improved and a 
period of time has elapsed, 
contact your SUBARU 
dealer for an inspection.
In low or high temperatures The system will restart once the temperature is within the
operational range of the
EyeSight system.
If the system does not restart,
even when the temperature
inside the vehicle is normal,
contact your SUBARU dealer
for an inspection.
S01135
S00700
S00701 
         
        
        
     
        
        Page 96 of 106

Troubleshooting
93
Troubleshooting
Adaptive Cruise control cannot be set.
Did you remember to press the   (CRUISE) switch?
If you have not pressed the   (CRUISE) switch,   (Adaptive Cruise 
Control) will not be shown.
Is EyeSight operation temporarily stopped?
When EyeSight is temporarily stopped,   is displayed on the multi information 
display.
Set cruise control again after the reason for the temporary stop has been cor-
rected.
Is  displayed?
Cruise control cannot be set when   is not displayed. Set cruise control when  is displayed.
 is not displayed.
Are the requirements for setting cruise control met?
In any of the following cases,   will not be displayed.  xThe brake pedal is depressed.
 x The vehicle speed is not between approximately 0 MPH (0 km/h) and 90
MPH (145 km/h) (when Adaptive Cruise Control is operating).
 x The vehicle speed is not between approximately 25 MPH (40 km/h) and 90
MPH (145 km/h) (when Conventional Cruise Control is operating).
 x The combination meter indicates a position other than  . (The select
lever or paddle shift switches are manually operated.)
 x The driver’s seatbelt is unfastened.
 x Any door is opened (except the rear gate/trunk).
 x The electronic parking brake is applied (The brake system warning light is
illuminated or flashing.)
*.
 x The vehicle is on a steep grade.
 x The X-mode is turned on. (The X-mode indicator illuminates.)
 x The steering wheel is turned significantly in either direction.
*For details of how to release the Electronic Parking Brake, refer to the
Owner’s Manual for your vehicle.
D 
         
        
        
     
        
        Page 98 of 106

Troubleshooting
95
EyeSight does not restart after a temporary stop.
Is the X-mode turned on?
EyeSight cannot be activated when the X-mode is turned on.
Are you driving in the rain with old wipers or is there an oily film on the windshield?
Replace the wipers with new ones, or clean the oily film off the windshield.
Are you driving in poor weather conditions with heavy rain, snow, fog, or dust? In 
these cases, EyeSight may temporarily stop operating while visibility is very low.
Is your vehicle subject to sunlight from the front (sunset or sunrise, etc.) or to 
bright headlights from oncoming vehicles at nighttime?
In these cases, EyeSight may temporarily stop operating.
Has the vehicle been parked in a cold or hot place? In either of these cases, 
EyeSight may temporarily stop operating until the temperature increases or 
decreases to a temperature at which the camera is operable.
The timing of the “brake more” warning is sometimes earlier and sometimes later 
than what seems to be normal operation.
The “brake more” warning sounds when the system determines that more braking 
is necessary, based on conditions such as the distance from the vehicle in front 
and the difference in speed compared to it. As a result, timing may vary depend-
ing on how the brakes are applied in relation to the vehicle in front, and your rela-
tive speed to that vehicle.
When the vehicle in front has turned off the road away or the distance from the 
vehicle in front has increased, acceleration is sometimes slower or faster.
Depending on the timing of when the detection of the vehicle in front is lost, 
EyeSight’s ability to react may be slower, causing the start of acceleration to feel 
delayed and braking time to feel longer than what seems to be normal operation. 
         
        
        
     
        
        Page 100 of 106
Troubleshooting
97
Lane Keep Assist was unexpectedly canceled
Did you take your hands off the steering wheel? Did you just lightly put your hands 
on the steering wheel while driving?
If the system cannot detect the steering operation of the driver, it will temporarily 
cancel Lane Keep Assist.
Did you turn a tight corner?
Lane Keep Assist does not operate while turning a tight corner.
Did you perform one of the following operations? xOperating the turn signal lever
 x Operating the steering wheel to depart from a lane
 x Depressing the accelerator pedal deeply
 x Operating the windshield wiper in a high speed
 x Driving your vehicle at a speed less than approximately 37 MPH (60 km/h)
or more than approximately 93 MPH (150 km/h)
 x Depressing the brake pedal
 x Turning on the hazard warning flasher switch