2017 SUBARU CROSSTREK oil capacity

Driving tips/Winter driving
Winter driving
&Operation during cold
weather
!Maintenance
Carry some emergency equipment, such
as a window scraper, a bag of sand,
flares, a small shovel and jumper cables.
Check the battery and cables. Cold
temperatures reduce battery capacity.
The battery must be in good condition to
provide enough power for cold winter
starts.
It normally takes longer to start the engine
in very cold weather conditions. Use an
engine oil of a proper grade and viscosity
for cold weather. Using heavy summer oil
will make it harder to start the engine.
Keep the door locks from freezing by
squirting them with deicer or glycerin.
Forcing a frozen door open may damage
or separate the rubber weather strips
around the door. If the door is frozen,
use hot water to melt the ice, and after-
wards thoroughly wipe the water away.
Use a windshield washer fluid that con-
tains an antifreeze solution. Do not use
engine antifreeze or other substitutes
because they may damage the paint ofthe vehicle.
SUBARU Windshield Washer Fluid con-
tains 58.5% methyl alcohol and 41.5%
surfactant, by volume. Its freezing tem-
perature varies according to how much it
is diluted, as indicated in the following
table.
Washer Fluid Con-
centrationFreezing Temperature
30% 10.48F(−128C)
50%−48F(−208C)
100%−498F(−458C)
In order to prevent freezing of washer
fluid, check the freezing temperatures in
the table above when adjusting the fluid
concentration to the outside temperature.
If you fill the reservoir tank with a fluid with
a different concentration from the one
used previously, purge the old fluid from
the piping between the reservoir tank and
washer nozzles by operating the washer
for a certain period of time. Otherwise, if
the concentration of the fluid remaining in
the piping is too low for the outside
temperature, it may freeze and block the
nozzles.
CAUTION
.Adjust the washer fluid concen-
tration appropriately for the out-
side temperature. If the concen-
tration is inappropriate, sprayed
washer fluid may freeze on the
windshield and obstruct your
view, and the fluid may freeze in
the reservoir tank.
.State or local regulations on
volatile organic compounds may
restrict the use of methanol, a
common windshield washer anti-
freeze additive. Washer fluids
containing non-methanol anti-
freeze agents should be used
only if they provide cold weather
protection without damaging
your vehicle’s paint, wiper blades
or washer system.
!Before driving your vehicle
Before entering the vehicle, remove any
snow or ice from your shoes because that
could make the pedals slippery and
driving dangerous.
While warming up the vehicle before
driving, check that the accelerator pedal,
brake pedal, and all other controls operate
smoothly.
8-8

!Alternative engine oil
If the SUBARU approved oil is unavailable, the following alternative oil can be used.
NOTEEach quantity indicated here is only a guideline. The necessary quantity for replacement may differ slightly depending on the
temperature and other factors.
Oil gradeSAE viscosity No. and
applicable temperatureEngine oil capacity
API (American Petroleum Insti-
tute) classificationSNwith the
words“RESOURCE CONSER-
VING”orILSAC (International Lubricant
Specification Advisory Commit-
tee)GF-5, which can be identi-
fied with the ILSAC certification
mark (Starburst mark)0W-20 syntheticoil is the required oil
for optimum engine performance and
protection. Conventional oil may be
used if synthetic oil is unavailable.
*: If 0W-20 synthetic oil is not available,
5W-30 or 5W-40 conventional oil may
be used if replenishment is needed but
should be changed to 0W-20 synthetic
oil at the next oil change.
–Adding the oil from low level to
full level:
1.1 US qt (1.0 liter, 0.9 Imp qt)
–Changing the oil and oil filter:
5.1 US qt (4.8 liters, 4.2 Imp qt) Specifications/Specifications
–CONTINUED–
12-5

Specifications/Specifications
&Manual transmission, front differential and rear differential gear oil
Oil Manual transmission oilFront differential gear oil (CVT
models)Rear differential gear oil
Oil grade.SUBARU Extra MT*
3
.API classification GL-5
(75W-90)*4
.SUBARU Extra MT*3
.API classification GL-5
(75W-90)API classification GL-5
SAE viscosity No.
and applicable tem-
perature—.75W-90*
.90
*: Recommended
Oil capacity*13.7 US qt (3.5 liters, 3.1 Imp qt) 1.3 US qt (1.2 liters, 1.1 Imp qt) 0.8 US qt (0.8 liters, 0.7 Imp qt)
Remarks*
2“Manual transmission oil”F11 -
14“Front differential gear oil (CVT
models) and rear differential
gear oil”F11-15“Front differential gear oil (CVT models) and rear differential
gear oil”F11-15
*1: The indicated oil quantity is only a guideline. The necessary quantity for replacement may differ slightly depending on the temperature and other
factors. After refilling the gearbox with oil, the oil level should be checked.
*2: For more details about maintenance and service, refer to the indicated section.
*3: The vehicle is filled at the factory with this type of oil.
*4: You may use this type of manual transmission oil. However, using this type of oil will detract from driveability and fuel efficiency.
12-6

crease in temperature could cause
tread separation, and failure of the
tire(s). Possible resulting loss of
vehicle control could lead to an
accident.
!Measuring and adjusting air
pressure to achieve proper in-
flation
Check and, if necessary, adjust the
pressure of each tire (including the
spare) at least once a month and
before any long journey. Check the
tire pressures when the tires are
cold. Use a pressure gauge to
adjust the tire pressures to the
specific values. Driving even a
short distance warms up the tires
and increases the tire pressures.
Also, the tire pressures are affected
by the outside temperature. It is
best to check tire pressure out-
doors before driving the vehicle.
When a tire becomes warm, the air
inside it expands, causing the tire
pressure to increase. Be careful not
to mistakenly release air from a
warm tire to reduce its pressure.
&Glossary of tire terminology
.Accessory weight
The combined weight (in excess of
those standard items which may be
replaced) of automatic transmis-
sion, power steering, power brakes,
power windows, power seats, radio,
and heater, to the extent that these
items are available as factory-in-
stalled equipment (whether in-
stalled or not).
.Bead
The part of the tire that is made of
steel wires, wrapped or reinforced
by ply cords and that is shaped to fit
the rim.
.Bead separation
A breakdown of the bond between
components in the bead.
.Bias ply tire
A pneumatic tire in which the ply
cords that extend to the beads are
laid at alternate angles substantially
less than 90 degrees to the center-
line of the tread.
.Carcass
The tire structure, except tread andsidewall rubber which, when in-
flated, bears the load.
.Chunking
The breaking away of pieces of the
tread or sidewall.
.Cold tire pressure
The pressure in a tire that has been
driven less than 1 mile or has been
standing for three hours or more.
.Cord
The strands forming the plies in the
tire.
.Cord separation
The parting of cords from adjacent
rubber compounds.
.Cracking
Any parting within the tread, side-
wall, or inner liner of the tire
extending to cord material.
.Curb weight
The weight of a motor vehicle with
standard equipment including the
maximum capacity of fuel, oil and
coolant, and if so equipped, air
conditioning and additional weight
optional engine.
Consumer information and Reporting safety defects/Tire information
–CONTINUED–13-5

14-10Index
T
Tachometer............................................................... 3-11
Temperature warning light
AT OIL TEMP........................................................ 3-19
Coolant................................................................. 3-17
Temporary spare tire.................................................... 9-2
Tether (child restraint system).............................. 1-33, 1-36
Tie-down hooks/holes................................................. 9-13
Tire ................................................................. 11-21, 12-8
Chains.................................................................. 8-11
Inspection............................................................ 11-23
Pressures and wear.............................................. 11-23
Replacement........................................................ 11-26
Rotation............................................................... 11-26
Size and pressure.................................................. 12-8
Types.................................................................. 11-21
Tire pressure monitoring system (TPMS)....... 7-37, 9-8, 11-21
Warning light......................................................... 3-19
Tires and wheels....................................................... 11-21
Tools.......................................................................... 9-3
Top tether anchorages........................................ 1-33, 1-36
Towing...................................................................... 9-13
All wheels on the ground........................................ 9-16
Flat-bed truck........................................................ 9-15
Hooks................................................................... 9-13
Weight.................................................................. 8-18
Trailer
Connecting............................................................ 8-16
Hitch............................................................ 8-15, 8-21
Towing tips............................................................ 8-23
Trailer towing............................................................. 8-17Trip meter.................................................................. 3-10
Turn signal
Indicator lights........................................................ 3-31
Lever.................................................................... 3-92
V
Valet mode................................................................ 2-31
Vanity mirror............................................................... 6-5
Vehicle
Capacity weight...................................................... 8-13
Identification........................................................ 12-16
Symbols.................................................................... 4
Vehicle Dynamics Control
OFF indicator light.................................................. 3-25
OFF switch............................................................ 7-36
Operation indicator light........................................... 3-24
System.................................................................. 7-34
Warning light.......................................................... 3-24
Ventilator.................................................................... 4-2
Voice command operation........................................... 5-80
W
Warning and indicator lights......................................... 3-13
Warning chimes
Keyless access with push-button start system............ 3-25
Seatbelt................................................................. 3-14
Warning light
ABS...................................................................... 3-21
Access key............................................................ 3-25
All-Wheel Drive...................................................... 3-23
AT OIL TEMP......................................................... 3-19

GAS STATION REFERENCE
&
Fuel:
Use onlyunleaded gasolinewith an octane rating of87 AKI
(90 RON) or higher.
&Fuel octane rating:
!RON
This octane rating is the Research Octane Number.
!AKI
This octane rating is the average of the Research Octane and
Motor Octane numbers and is commonly referred to as the Anti
Knock Index (AKI).
&Fuel capacity:
15.9 US gal (60 liters, 13.2 Imp gal)
&Engine oil:
Use only the following oils.
.API classification SN with the words“RESOURCE CON-
SERVING”
.or ILSAC GF-5, which can be identified with the ILSAC
certification mark (Starburst mark)
For the complete viscosity requirements, refer to“Engine oil”
F12-4.
&Engine oil capacity:
5.1 US qt (4.8 liters, 4.2 Imp qt)
The indicated oil quantity is only a guideline and is estimated
based on a case when the engine oil is changed with an oil
filter. After refilling the engine with oil, the oil level should be
checked using the oil level gauge. For more details about
maintenance and service, refer to“Engine oil”F11-8.
&Cold tire pressure:
Refer to“Tires”F12-8.