Page 17 of 118
1.11
ELECTRIC VEHICLE: charging (4/5)
Recharging the traction
battery
Ignition switched off:
– open flap 3;
– take out the entire charging cord 2 located in the storage compartment
at the front of your vehicle, pulling it
by the plug using reasonable force.
The maximum length of the charging
cord is approximately 3 metres;
– plug in the end of the cord to the power supply (domestic plug socket,
etc);
– make sure that the stretch limiter 8 of the charging cord 2 is not exceeded
during charging. NB:
It is not necessary to wait:
– until you reach reserve levels in
order to recharge your vehicle;
– for a full charge of the traction bat- tery in order to use the vehicle.
3
2
4
5
67
When charging, the following informa-
tion is displayed:
– warning light 4. This flashes to indi-
cate that the traction battery is re-
ceiving energy;
– the completed charge percentage 5;
– warning light 6 indicates that the
cord is attached to the power supply;
– the battery 7 indicates the amount of
energy stored in the traction battery.
At the end of a full charge, the instru-
ment panel switches off.
8
2
The vehicle can only be charged
with the ignition switched off.
In the absence of any protection
against overvoltage, you are ad-
vised not to charge the vehicle in
stormy weather (lightning, etc).
Page 39 of 118
1.33
WARNING LIGHTS (2/3)
®STOP light
This lights up when the ignition
is switched on and goes out as soon as
the engine is started. It lights up at the
same time as other warning lights, and
is accompanied by a beep.
It requires you to stop immediately, for
your own safety, as soon as traffic con-
ditions allow. Switch off the engine and
do not restart it.
Contact an approved Dealer.
Special feature: On steep slopes, a
warning light will come on and a beep
will sound if the vehicle is travelling
at excessive speed. You must then
reduce your speed. Risk of damage to
the engine. The warning light goes out
once the vehicle speed drops below the
maximum set level.
Windscreen de-icing warn-
ing light .
Ú12 V battery charge warning
light
If it comes on, limit the non-essential
use of any energy-consuming equip-
ment and accessories.
If it stays on, see an authorised dealer
as soon as possible.
If it comes on together with the warning
light
® and a beep, this indicates a
fault in the 12V battery charging circuit.
Stop as soon as traffic conditions allow
and contact an authorised dealer.
DHandbrake on and brake cir-
cuit incident warning light
This comes on when the ignition is
switched on and goes out as soon as
the handbrake is released.
If it comes on during braking and is ac-
companied by the
® warning light
and a beep, it indicates that the fluid
level in the circuit is low or that there is
a braking system fault.
Stop as soon as traffic conditions allow
and contact an approved Dealer.
The presence and operation of the warning lights DEPEND ON THE EQUIPMENT\
AND COUNTRY.
A
øWarning light
This lights up when the ignition
is switched on and goes out as soon as
the engine is started. It may comes on
in conjunction with other warning lights
on the instrument panel.
It means you should drive very care-
fully to an approved dealer as soon as
possible. If you fail to follow this recom-
mendation, you risk damaging your ve-
hicle.
Page 40 of 118
1.34
Low traction battery level
warning light
This comes on when the traction bat-
tery charge level has reached the re-
serve threshold. Please see the infor-
mation on “Displays and indicators” in
Section 1.
\bElectrotechnical system
warning light
If it lights up while driving, this means
there is an electrotechnical fault in the
“58 volt” electrical circuit. Please see an
authorised dealer as soon as possible.
When the vehicle is started or while
driving, if it flashes accompanied by
the
® warning light and a beep,
this indicates that the charging flap is
open or not correctly closed. Stop and
switch off the ignition, make sure that
the charging cord is disconnected and
that the flap is fully closed.
©Not used
ERROR Not used
+ Not used
WARNING LIGHTS (3/3)
Electrotechnical system
warning light
When the warning light comes on, this
indicates the traction battery or the
engine temperature is too high. Opt for
a calmer driving style.
The warning light can be accompa-
nied by a drop in vehicle perform-
ance. The presence and operation of the warning lights DEPEND ON THE EQUIPMENT\
AND COUNTRY.
A
Gear selector 1 position indicator (N,
D or R).
1
Page 41 of 118
1.35
DISPLAYS AND INDICATORS (1/2)
Charge level 1
The gauge indicates the level of energy
remaining.
NB: Each time you switch off the igni-
tion, the remaining energy level will be
calculated.
Once you switch on the ignition again,
you will see a slight change in the level
display. The presence and operation of the display and indicators DEPENDS ON THE \
LEVEL OF EQUIPMENT AND THE COUNTRY.
Immobilisation threshold imminent
When the battery reaches less than 6%
charge, a beep repeats every 20 sec-
onds and warning light
Ṏ flashes on
and off.
Motor performance gradually de-
creases until the vehicle comes to a
stop.
Please see the information on “Towing:
in the event of energy loss” in Section 5.
Charge meter 2
Please refer to the information on the
“Charge meter” in Section 2.
Speedometer 3
In kilometres or miles per hour.
1
2
3
Reserve level
When the battery reaches approxi-
mately 12% charge, warning light
Ṏ
comes on, along with a beep.
To optimise your range, please see the
information on “Recommendations:
saving energy” in Section 2.
Page 42 of 118
1.36
Forecast range display features
– Sporty driving will strongly affect the forecast range value. Once you
return to a calmer driving style, you
will need to drive for several miles to
return to an estimate that is closer to
the real situation;
– the forecast range displayed after charging the traction battery is calcu-
lated based on the power consump-
tion over the last 93 miles (150 kilo-
metres) travelled.
Instrument panel in miles
It is possible to switch to km/h.
Press button 5 and switch on the igni-
tion.
The speed measurement unit indica-
tor flashes for approximately three sec-
onds, then the new unit flashes on the
display and is then lit up continuously:
release button 5.
To return to miles, proceed in the same
manner.Display 4
Press and hold button 5 to reset the trip
mileage recorder. The display must be
set to “Trip mileage recorder”. Zones
6 of the instrument panel dis-
play the information detailed below by
pressing button 5 repeatedly:
– estimated range;
– total mileage recorder;
– trip mileage recorder;
– Eco score;
– clock (CS : Clock setting).
Note: resetting is automatic when
the maximum capacity of any of the
memories is exceeded.
4
5
6
DISPLAYS AND INDICATORS (2/2)
Page 52 of 118
2.4
Parking the vehicle
With the vehicle at a standstill, press
switch N.
Warning light 3 comes on the instru-
ment panel.
Engage the handbrake (please see the
“Handbrake” information in Section 2).
GEAR CONTROL (2/2)
In the event of an impact to the underside of the vehicle (e.g.: striki\
ng a
post, raised kerb or other street furniture), this may result in damage\
to
the vehicle (e.g.: twisted axle), the electrical circuit or the tracti\
on battery.
Do not touch the circuit elements or any fluids or liquids.
To prevent any risk of accident, have your vehicle checked by an authoris\
ed
dealer.
Risk of serious injury or electric shock.
N
3
NB: when the ignition is switched
off, the gear control automatically
switches to position N.
Temporary stop
At a standstill and with the engine run-
ning, when position D or R is engaged,
a beep will sound and warning light
Ṑ
flashes until one of the following condi-
tions is met:
– brake pedal pressed;
– accelerator pedal pressed;
– N switch pressed;
– the handbrake is secured.
Page 53 of 118
2.5
Handbrake
To release:
With the ignition on:
– support on the brake pedal and maintain it sunk ;
– press 2 ;
– gently pull lever 1 towards you, keep-
ing the 2 button pressed down;
– push the lever down as far as it will go.When stationary and de-
pending on the slope and/or
vehicle load, it may be nec-
essary to pull up the hand-
brake at least two extra notches.
Make sure that the hand-
brake is properly released
when driving (red indicator
light off), otherwise over-
heating may occur.
1
2
HANDBRAKE
To apply:
Pull lever 1 upwards and make sure the
vehicle is immobilised. Warning light 3
D will come on on the instrument
panel.
3
Special conditions
It is not possible to release the hand-
brake when the 12 volt battery is dis-
charged.
You must recharge it (see “12V battery”
in Section 4) before you can release the
handbrake, or have the 12V battery re-
placed by an authorised dealer.
The handbrake is a vehicle safety
measure. It cannot be released
unless the ignition is switched on.
Page 56 of 118
2.8
ENVIRONMENT
Please make your own
contribution towards
protecting the environment
too.
– Worn parts replaced in the course of routine vehicle maintenance (vehi-
cle battery, etc.) must be disposed of
through specialist bodies.
– At the end of the vehicle’s service life, it should be sent to approved
centres to ensure that it is recycled.
– In all cases, comply with local legis- lation.
Recycling
Your vehicle is 85% recyclable and
95% recoverable.
To achieve these objectives, many of
the vehicle components have been de-
signed to enable them to be recycled.
The materials and structures have
been carefully designed to allow these
components to be easily removed and
reprocessed by specialist companies.
In order to preserve raw material re-
sources, this vehicle incorporates nu-
merous parts made from recycled plas-
tics or renewable materials (vegetable
or animal-derived materials such as
cotton or wool).
Your vehicle has been designed with
respect for the environment in mind for
its entire service life: during production,
use and at the end of its life.
Manufacture
Your vehicle has been manufactured at
an industrial site which uses a progress
policy to reduce environmental impacts
on rivers and natural areas (reduc-
tion of water and energy consumption,
visual and noise pollution, atmospheric
emissions and waste water, sorting and
reusing waste).