GB.24
SYSTEM SETTINGS (2/2)Security code
Your audio system is protected by a
security code (supplied by the manu-
facturer’s dealer). This is used to elec-
tronically lock the audio system when
the power is cut (battery disconnected,
system disconnected, fuse blown etc.).
To operate the audio system, you must
enter the secret four-digit code.
Make a note of the code and keep it in
a safe place. Contact one of the manu-
facturer’s agents if you lose it.
Entering the code
Press 1 to switch on the audio system.
The message CODE followed by 0000
is displayed. Set the value of the first flashing figure,
by pressing button 1 on keypad
7 until
the desired number is reached. Adjust
the subsequent figures using buttons 2,
3, and 4 on keypad 7 in the same way.
After selecting the fourth figure, press
and hold button 6 on keypad 7.
The system is unlocked automatically
once the full code has been entered.
Entering the code incorrectly
If an error is made whilst entering the
code, the message “CODE ERROR...
WAIT” is displayed.
Wait 60 minutes and then re-enter the
code.
Each time the code is entered incor-
rectly, the time required before the code
can be re-entered is doubled.
Phone settings
Display the settings menu by press-
ing 8.
After a few seconds, the previous
screen will be displayed automatically,
without any action on your part.
You can also exit the settings mode by
pressing 8 or 9.
GB.25
OPERATING FAULTS (1/3)
DescriptionPossible causes Solutions
No sound can be heard. The volume is set to minimum or pause. Increase the volume or deactivate pause.
The audio system does not work and
the display does not light up. The audio system is not switched on. Switch the audio system on.
The audio system fuse has blown. Replace the fuse (see “fuses” in the vehicle’s
driver’s handbook).
The audio system does not work but
the display lights up. The volume is set to minimum.
Press 16.
Speaker short circuit. Contact a representative from the manufac-
turer.
No sound comes out of the left- or
right-hand speakers when using the
radio or a CD. The sound balance setting (left/right) is
incorrect.
Correct the sound balance setting.
Speaker disconnected. Contact a representative from the manufac-
turer.
Poor radio reception or no reception. The vehicle is too far from the transmitter to which the radio is tuned (background
noise and interference). Find another transmitter with better reception
in your area or deactivate the “RDS-AF” func-
tion.
The reception is disrupted by interfer-
ence from the engine. Contact a representative from the manufac-
turer.
The aerial is damaged or not connected. Contact a representative from the manufac-
turer.
