2017 Ram ProMaster windshield wipers

▫Lane Change Assist ......................76
▫ High Beam/Low Beam Select Switch .........76
▫ Flash-To-Pass ..........................76
▫ Follow Me Home/Headlight Delay ...........76
▫ Overhead Lights ........................77
▫ Ambient Light ..........................78
▫ Cargo Lamp ...........................78
 WINDSHIELD WIPERS AND WASHERS ........80
▫ Windshield Wipers ......................80
▫ Intermittent Wiper System .................80
▫ Low Speed ............................80
▫ High Speed ............................80
▫ Mist Feature ...........................80
▫ Windshield Washer Operation ...............81
 TELESCOPING STEERING COLUMN ..........81
 ELECTRONIC SPEED CONTROL .............82
▫ To Activate ............................82 ▫
To Set A Desired Speed ...................83
▫ To Deactivate ..........................83
▫ To Resume Speed .......................83
▫ To Vary The Speed Setting .................83
▫ To Accelerate For Passing .................84
 PARKSENSE REAR PARK ASSIST — IF
EQUIPPED .............................85
▫ ParkSense Rear Park Assist Sensors ...........85
▫ ParkSense Rear Park Assist Alerts ............86
▫ ParkSense Rear Park Assist Failure Indications . . .88
▫ Cleaning The ParkSense Rear Park Assist System .88
▫ ParkSense Rear Park Assist System Usage
Precautions ............................88
 PARKVIEW REAR BACK UP CAMERA — IF
EQUIPPED .............................89
 OVERHEAD SHELF— IF EQUIPPED ..........91
 POWER OUTLETS — IF EQUIPPED ...........92
 AUXILIARY SWITCHES — IF EQUIPPED .......94
56 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WINDSHIELD WIPERS AND WASHERS
Windshield Wipers
The windshield wiper/washer lever is located on the right
side of the steering column. There are five different modes
of operation for the front windshield wipers. The wind-
shield wiper lever can be raised or lowered to access the
modes.
NOTE:The windshield wipers/washers will only operate
with the ignition in the ON/RUN position.
Intermittent Wiper System
Push the lever downward to the first detent and rotate the
center ring to use one of the four intermittent wiper
settings when weather conditions make a single wiping
cycle, with a variable delay between cycles, desirable.
Low Speed
Push the lever downward to the second detent. The wipers
will operate at low speed.
High Speed
Push the lever downward to the third detent. The wipers
will operate at high speed.
Mist Feature
Use the Mist feature when weather conditions make occa-
sional usage of the wipers necessary. Push the lever up-
ward to the Mist position and release for a single wiping
cycle.
NOTE: The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed on the
windshield. The wash function must be used in order to
spray the windshield with washer fluid.
Windshield Wiper/Washer Lever
80 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Windshield Washer Operation
To use the washer, pull the windshield wiper/washer lever
toward the steering wheel to activate the washers. The
wipers will activate automatically for three cycles after the
lever is released. and then resume the intermittent interval
previously selected.
If the lever is pulled while in the off position, the wipers
will operate for three cycles, then turn off.
WARNING!
Sudden loss of visibility through the windshield could
lead to a collision. You might not see other vehicles or
other obstacles. To avoid sudden icing of the wind-
shield during freezing weather, warm the windshield
with the defroster before and during windshield
washer use.
TELESCOPING STEERING COLUMN
This feature allows you to lengthen or shorten the steering
column. The telescoping control handle is located below
the steering wheel at the end of the steering column.To unlock the steering column, pull the control handle up.
To lengthen or shorten the steering column, pull the
steering wheel outward or push it inward as desired. To
lock the steering column in position, push the control
handle down until fully engaged.WARNING!
Do not adjust the steering column while driving.
Adjusting the steering column while driving or driv-
ing with the steering column unlocked, could cause the
(Continued)
Telescoping Control Handle
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 81

Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, decklid, sliding doors and hood hinges, should be
lubricated periodically with a lithium based grease, such as
MOPAR Spray White Lube to assure quiet, easy operation
and to protect against rust and wear. Prior to the applica-
tion of any lubricant, the parts concerned should be wiped
clean to remove dust and grit; after lubricating excess oil
and grease should be removed. Particular attention should
also be given to hood latching components to ensure
proper function. When performing other underhood ser-
vices, the hood latch, release mechanism and safety catch
should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR Lock
Cylinder Lubricant directly into the lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumulations
of salt or road film.Operation of the wipers on dry glass for long periods may
cause deterioration of the wiper blades. Always use washer
fluid when using the wipers to remove salt or dirt from a
dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
NOTE:
Life expectancy of wiper blades varies depending
on geographical area and frequency of use. Poor perfor-
mance of blades may be present with chattering, marks,
water lines or wet spots. If any of these conditions are
present, clean the wiper blades or replace as necessary.
Adding Washer Fluid
The fluid reservoir is located in the engine compartment
and should be checked at regular intervals. Fill the reser-
voir with windshield washer solvent (not radiator anti-
freeze) and operate the system for a few seconds to flush
out any residual water.
The washer fluid reservoir will hold a full gallon of fluid
when the Low Washer Fluid Light illuminates.
7
MAINTAINING YOUR VEHICLE 289

TransaxleAutomatic ..............................11
Transmission Automatic ............................ .177
Fluid ............................. .295, 317
Tread Wear Indicators ...................... .215
Turn Signals ..............................118
Uconnect Operation ............................. .144
Uconnect Voice Command ....................166
Uniform Tire Quality Grades ..................331
Unleaded Gasoline ........................ .223
Untwisting Procedure, Seat Belt .................26
Vehicle Certification Label ....................228
Vehicle Identification Number (VIN) ...............7
Vehicle Loading .....................205, 228, 230
Vehicle Modifications/Alterations .................7
Vehicle Storage ........................ .164, 311
Viscosity, Engine Oil ....................... .282
Voice Recognition System (VR) .................166Warnings And Cautions
.......................6
Warranty Information ...................... .329
Washer Adding Fluid .......................... .289
Washing Vehicle .......................... .297
Water Driving Through ........................ .187
Wind Buffeting .............................20
Window Fogging .......................... .164
Windows .................................18
Power .................................18
Windshield Defroster .........................51
Windshield Washers ..................... .80, 289
Fluid ..................................80
Windshield Wiper Blades .....................289
Windshield Wipers ..........................80
Wiper Blade Replacement .....................289
Wipers, Intermittent .........................80
344 INDEX