2017 Ram ProMaster hood release

Turn the adjuster wheel to the right or left to adjust the
height of the armrest up or down.
TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released.
1. Open the drivers door to gain access to the hood releaselever. Pull the hood release lever located on the side of
the instrument panel. 2. Move to the outside of the vehicle, reach into the
opening beneath the center of the hood and push the
safety latch lever to the right to release it, before raising
the hood.
Adjuster Wheel
Hood Release
72 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

INSTRUMENT PANEL FEATURES
Instrument Panel Features Will Vary As Equipped
1 — Air Outlet10 — Lower Glove Compartment19 — Uconnect Phone Buttons
2 — Multifunction Lever (External Lights) 11 — Cup Holder 20 — Tilt Steering Column Release Lever
3 — Instrument Cluster 12 — USB Charger/12V21 — Horn
4 — Multifunction Lever (Front Wiper, Trip
Computer) 13 — Climate Controls
22 — Mute/Uconnect Voice Command
Buttons
5 — Radio (As Equipped) 14 — Lower Switch Ban23 — Cruise Control Switches
6 — Clip Board 15 — Cup Holders24 — Fuse Box Lid
7 — Upper Glove Compartment 16 — Gear Selector25 — Instrument Cluster Display Controls
8 — Passenger Air Bag 17 — USB / AUX26 — Hood Release
9 — Storage Compartment 18 — Ignition Switch
4
UNDERSTANDING YOUR INSTRUMENT PANEL 99

Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, decklid, sliding doors and hood hinges, should be
lubricated periodically with a lithium based grease, such as
MOPAR Spray White Lube to assure quiet, easy operation
and to protect against rust and wear. Prior to the applica-
tion of any lubricant, the parts concerned should be wiped
clean to remove dust and grit; after lubricating excess oil
and grease should be removed. Particular attention should
also be given to hood latching components to ensure
proper function. When performing other underhood ser-
vices, the hood latch, release mechanism and safety catch
should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR Lock
Cylinder Lubricant directly into the lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumulations
of salt or road film.Operation of the wipers on dry glass for long periods may
cause deterioration of the wiper blades. Always use washer
fluid when using the wipers to remove salt or dirt from a
dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
NOTE:
Life expectancy of wiper blades varies depending
on geographical area and frequency of use. Poor perfor-
mance of blades may be present with chattering, marks,
water lines or wet spots. If any of these conditions are
present, clean the wiper blades or replace as necessary.
Adding Washer Fluid
The fluid reservoir is located in the engine compartment
and should be checked at regular intervals. Fill the reser-
voir with windshield washer solvent (not radiator anti-
freeze) and operate the system for a few seconds to flush
out any residual water.
The washer fluid reservoir will hold a full gallon of fluid
when the Low Washer Fluid Light illuminates.
7
MAINTAINING YOUR VEHICLE 289

Tank Capacity.......................... .315
Fueling ................................. .227
Fuses .................................. .302
Gas Cap (Fuel Filler Cap) ..............227, 228, 279
Gasoline, Clean Air ........................ .223
Gasoline (Fuel) ........................... .223
Gasoline, Reformulated ..................... .223
Gear Ranges ............................. .180
Gear Select Lever Override ....................272
General Information .....................157, 222
Glass Cleaning ........................... .300
Gross Axle Weight Rating .................229, 231
Gross Vehicle Weight Rating ...............229, 230
Guide, Body Builders .........................6
GVWR ................................. .229
Hazard Driving Through Flowing, Rising, Or Shallow
Standing Water ......................... .187
Hazard Warning Flasher ..................... .242
Headlights Cleaning .............................. .300
High Beam ..............................76
High Beam/Low Beam Select Switch ...........76Passing
................................76
Switch .................................74
Head Restraints ............................69
Heated Mirrors .............................59
Heated Seats ...............................68
Heater, Engine Block ....................... .177
High Beam/Low Beam Select (Dimmer) Switch ......76
Hill Start Assist ........................... .197
Hitches Trailer Towing .......................... .232
Hood Release ..............................72
Ignition ..................................11
Key ...................................11
Ignition Key Removal ........................11
Illuminated Entry ...........................14
Immobilizer (Sentry Key) ......................12
Inside Rearview Mirror .......................58
Instrument Cluster ..................... .100, 118
Instrument Cluster Display Instrument Cluster Display ..................120
Instrument Panel And Controls .................
99
Instrument Panel Lens Cleaning ................301
Interior Appearance Care .....................299
Intermittent Wipers (Delay Wipers) ...............80
338 INDEX