2017 Ram ProMaster ignition switch

WARNING!
Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around the
washer solution.
After the engine has warmed, operate the defroster for a
few minutes to reduce the possibility of smearing or
freezing the fluid on the cold windshield. MOPAR All
Weather Windshield Washer Solution or equivalent, used
with water as directed on the container, aids cleaning
action, reduces the freezing point to avoid line clogging,
and is not harmful to paint or trim.
Cooling System
WARNING!
• When working near the radiator cooling fan, discon-
nect the fan motor lead or turn the ignition switch to
the OFF position. The fan is temperature controlled
and can start at anytime the ignition switch is in the
ON position.
(Continued)
WARNING! (Continued)
•You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had time
to cool. Never try to open a cooling system pressure
cap when the radiator is hot.
Coolant Checks
Check the engine coolant (antifreeze) protection every 12
months (before the onset of freezing weather, where appli-
cable). If the engine coolant (antifreeze) is dirty, the system
should be drained, flushed, and refilled with fresh OAT
coolant (conforming to MS-12106) only by an authorized
dealer. Check the front of the A/C condenser for any
accumulation of bugs, leaves, etc. If dirty, clean by gently
spraying water from a garden hose vertically down the face
of the condenser.
Cooling System — Drain, Flush And Refill
NOTE: Some vehicles require special tools to add coolant
properly. Failure to fill these systems properly could lead to
severe internal engine damage. If any coolant is needed to
be added to the system, please contact your local autho-
rized dealer.
290 MAINTAINING YOUR VEHICLE

liner thoroughly under warm running water. Shake the
excess water from the liner and dry the outer surfaces with
a clean soft cloth.
Installation
Place the liner into the cupholder drawer and push the
liner into place so that the retention tabs seat into the
corresponding openings in the drawer.
FUSES
WARNING!
•When replacing a blown fuse, always use an appro-
priate replacement fuse with the same amp rating as
the original fuse. Never replace a fuse with another
fuse of higher amp rating. Never replace a blown
fuse with metal wires or any other material. Failure
to use proper fuses may result in serious personal
injury, fire and/or property damage.
• Before replacing a fuse, make sure that the ignition is
off and that all the other services are switched off
and/or disengaged.
(Continued)
WARNING! (Continued)
•If the replaced fuse blows again, contact an autho-
rized dealer.
• If a general protection fuse for safety systems (air
bag system, braking system), power unit systems
(engine system, gearbox system) or steering system
blows, contact an authorized dealer.
Underhood Fuses
The Front Power Distribution Center is located on the
driver ’s side of the engine compartment. To access the
fuses, remove the cover.
302 MAINTAINING YOUR VEHICLE

Right Central Pillar Fuses
The right central pillar fuse panel is located on the interior
side at the base of the passenger side B pillar.
CavityMini Fuse Description
F81 7.5 Amp Brown Seat Heater
F83 20 Amp Yellow Rear Left Windows Heater
F84 20 Amp Yellow Rear Right Windows Heater
F86 20 Amp Yellow Auxiliary Switch (From Battery) – If Equipped
F87 20 Amp Yellow Auxiliary Switch (From Ignition) – If Equipped
Fuse Panel Location
Fuse Panel
310 MAINTAINING YOUR VEHICLE

Tank Capacity.......................... .315
Fueling ................................. .227
Fuses .................................. .302
Gas Cap (Fuel Filler Cap) ..............227, 228, 279
Gasoline, Clean Air ........................ .223
Gasoline (Fuel) ........................... .223
Gasoline, Reformulated ..................... .223
Gear Ranges ............................. .180
Gear Select Lever Override ....................272
General Information .....................157, 222
Glass Cleaning ........................... .300
Gross Axle Weight Rating .................229, 231
Gross Vehicle Weight Rating ...............229, 230
Guide, Body Builders .........................6
GVWR ................................. .229
Hazard Driving Through Flowing, Rising, Or Shallow
Standing Water ......................... .187
Hazard Warning Flasher ..................... .242
Headlights Cleaning .............................. .300
High Beam ..............................76
High Beam/Low Beam Select Switch ...........76Passing
................................76
Switch .................................74
Head Restraints ............................69
Heated Mirrors .............................59
Heated Seats ...............................68
Heater, Engine Block ....................... .177
High Beam/Low Beam Select (Dimmer) Switch ......76
Hill Start Assist ........................... .197
Hitches Trailer Towing .......................... .232
Hood Release ..............................72
Ignition ..................................11
Key ...................................11
Ignition Key Removal ........................11
Illuminated Entry ...........................14
Immobilizer (Sentry Key) ......................12
Inside Rearview Mirror .......................58
Instrument Cluster ..................... .100, 118
Instrument Cluster Display Instrument Cluster Display ..................120
Instrument Panel And Controls .................
99
Instrument Panel Lens Cleaning ................301
Interior Appearance Care .....................299
Intermittent Wipers (Delay Wipers) ...............80
338 INDEX