2017 Ram 5500 Chassis Cab wheel torque

NOTE:Dual wheels are flat mounted, center piloted. The
lug nuts are a two-piece assembly. When the tires are being
rotated or replaced, clean these lug nuts and add two drops
of oil at the interface between the hex and the washer.
Do not oil wheel studs. For chrome wheels, do not substi-
tute with chrome plated wheel nuts. Retighten the wheel nuts in the same sequence to the
torques listed in the table. Go through the sequence a
second time to verify that specific torque has been
achieved. Retighten to specifications after 25 miles (40 km)
check the lug nut/bolt torque to be sure that all the lug
nuts/bolts are properly seated against the wheel.
Two-Piece Lug Nut
Wheel Mounting Surface
428 WHAT TO DO IN EMERGENCIES

1 — 10 Bolt Pattern
2 — 8 Bolt Pattern
WARNING!
To avoid the risk of forcing the vehicle off the jack, do
not tighten the lug nuts fully until the vehicle has been
lowered. Failure to follow this warning may result in
personal injury.
JACKING AND TIRE CHANGING
WARNING!
•Do not attempt to change a tire on the side of the
vehicle close to moving traffic, pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.
• Being under a jacked-up vehicle is dangerous. The
vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack.
• Never start or run the engine while the vehicle is on
a jack. If you need to get under a raised vehicle, take
it to a service center where it can be raised on a lift.
• The jack is designed to use as a tool for changing
tires only. The jack should not be used to lift the
vehicle for service purposes. The vehicle should be
jacked on a firm level surface only. Avoid ice or
slippery areas.
8/10 Lug Nuts/Bolts Torque Patterns
6
WHAT TO DO IN EMERGENCIES 429

WARNING!
Raising the vehicle higher than necessary can make the
vehicle unstable. It could slip off the jack and hurt
someone near it. Raise the vehicle only enough to
remove the tire.
5. Remove the wheel nuts and pull the wheel off. Install the spare wheel and wheel nuts with the cone shaped
end of the nuts toward the wheel on single rear wheel
(SRW) models. On dual rear wheel models (DRW) the
lug nuts are a two-piece assembly with a flat face.
Lightly tighten the nuts. To avoid risk of forcing the
vehicle off the jack, do not fully tighten the nuts until the
vehicle has been lowered.
6. Using the wheel wrench, finish tightening the nuts using a crisscross pattern. For the proper lug nut torque
specifications refer to “Wheel and Tire Torque Specifi-
cations” in this section. If in doubt about the correct
tightness, have them checked with a torque wrench by
your authorized dealer or at a service station.
WARNING!
A loose tire or jack thrown forward in a collision or
hard stop could injure someone in the vehicle. Always
stow the jack parts and the extra tire and wheel in the
places provided.
7. Install wheel center cap (if equipped) and remove wheel blocks. Do not install chrome or aluminum wheel center
caps on the spare wheel. This may result in cap damage.
8. Lower the jack to its fully closed position. If the jack will not lower by turning the dial (thumbwheel) by hand, it
may be necessary to use the jack drive tube in order to
lower the jack. Stow the replaced tire, jack, and tools as
previously described.
9. Adjust the tire pressure when possible.
6
WHAT TO DO IN EMERGENCIES 433

wheel. The tires of both dual wheels must be completely off
the ground when tightening to insure wheel centering and
maximum wheel clamping.
Dual wheel models require a special heavy-duty lug nut
tightening adapter (included with the vehicle) to correctly
tighten the lug nuts. Also, when it is necessary to remove
and install dual rear wheels, use a proper vehicle lifting
device.
NOTE:When installing a spare tire (if equipped) as part of
a dual rear wheel end combination, the tire diameter of the
two individual tires must be compared. If there is a
significant difference, the larger tire should be installed in
a front location. The correct direction of rotation for dual
tire installations must also be observed.
It is recommended that wheel stud nuts be kept torqued to
specifications at all times. Torque wheel stud nuts to
specifications at each lubrication interval.
Wheel Nuts
All wheel nuts should be tightened occasionally to elimi-
nate the possibility of wheel studs being sheared or the bolt
holes in the wheels becoming elongated. This is especially
important during the first few hundred miles/kilometers
of operation to allow the wheel nuts to become properly set. All wheel nuts should first be firmly seated against the
wheel. The wheel nuts should then be tightened to recom-
mended torque. Tighten the wheel nuts to final torque in
increments. Progress around the bolt circle, tightening the
wheel nut opposite to the wheel nut just previously
tightened until final torque is achieved.
To Stow The Flat Or Spare — If Equipped
Refer to Upfitters Body Builders Guide for information on
stowing your spare tire (if equipped).
HOISTING
A conventional floor jack may be used at the jacking
locations. Refer to the graphics that show jacking locations.
However, a floor jack or frame hoist must never be used on
any other parts of the underbody.
CAUTION!
Never use a floor jack directly under the differential
housing of a loaded truck or damage to your vehicle
may result.
6
WHAT TO DO IN EMERGENCIES 435

Aging (Life Of Tires)..................... .383
Air Pressure ........................ .371, 376
Chains ............................... .385
Compact Spare ......................... .381
Dual .......................... .387, 427, 434
General Information ...................376, 380
High Speed ............................ .378
Inflation Pressures ....................... .377
Life Of Tires ........................... .383
Load Capacity ...................... .371, 373
Pressure Monitor System (TPMS) .............389
Pressure Warning Light ....................212
Quality Grading ........................ .388
Radial ............................... .378
Replacement ........................... .384
Rotation .............................. .386
Safety ............................ .365, 376
Sizes ................................ .367
Snow Tires ............................ .379
Spare Tire ...................... .380, 381, 382
Spinning .............................. .382
Tread Wear Indicators .....................383
Wheel Nut Torque ....................... .433
Tire Safety Information ...................... .365
Tongue Weight/Trailer Weight .................408Torque Converter Clutch
.....................335
Tow Hooks, Emergency ..................... .440
Towing ............................. .403, 442
Disabled Vehicle ........................ .442
Guide ................................ .407
Recreational ........................... .418
Weight ............................... .407
Towing Vehicle Behind A Motorhome ............418
Traction ................................ .347
T

raction Control .......................... .357
Trailer Sway Control (TSC) ....................362
Trailer Towing ............................ .403
Cooling System Tips ..................... .415
Hitches ............................... .407
Minimum Requirements ....................408
Mirrors ................................113
Trailer And Tongue Weight ..................408
Wiring ............................... .414
Trailer Towing Guide ....................... .407
Trailer Weight ............................ .407
Transfer Case ............................ .478
Electronically Shifted ..................... .342
Fluid ................................ .502
Transmission ............................. .478
Automatic ......................... .327, 478
528 INDEX

Fluid................................ .502
Shifting .............................. .325
Transporting Pets ...........................93
Tread Wear Indicators ...................... .383
Turn Signals ....................... .137, 220, 494
Uconnect Customer Programmable Features .........249, 266
Operation ............................. .273
Uconnect Settings ....................... .239
Uconnect Settings .....................249, 266
Uconnect 8.4/8.4 NAV ...................... .314
Uconnect 8.4 Settings Customer Programmable Features — Units ......258
Uconnect Access Vehicle Health Alert ...................... .307
Uconnect Settings Customer Programmable Features .......34, 247, 264
Passive Entry Programming ...........34, 247, 264
Uconnect Settings .....................247, 264
Uconnect Voice Command ....................294
Uniform Tire Quality Grades ..................388
Universal Garage Door Opener (HomeLink) Programming HomeLink .........166, 167, 168, 169
Unleaded Gasoline ........................ .396Untwisting Procedure, Seat Belt
.................47
Vehicle Identification Number (VIN) ...............7
Vehicle Loading ....................... .373, 401
Vehicle Modifications/Alterations .................7
Vehicle Storage ........................ .292, 493
Viscosity, Engine Oil ....................... .453
Voice Recognition System (VR) .................294
Warnings And Cautions .......................6
Warranty Information ...................... .513
Washers, Windshield .....................139, 469
Washing Vehicle .......................... .481
Water Driving Through ........................ .348
Wheel And Wheel Trim ..................... .483
Wheel And Wheel Trim Care ..................483
Wheel Cover ............................. .434
Wheel

Nut Torque ..................... .433, 435
Wind Buffeting .............................40
Window Fogging .......................... .292
Windows .................................37
Power .................................37
Rear Sliding ........................... .187
Reset Auto-Up ...........................39
10
INDEX 529