Page 664 of 734

Cooling System
WARNING!
You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If you
see or hear steam coming from under the hood, do not
open the hood until the radiator has had time to cool.
Never try to open a cooling system pressure cap when
the radiator is hot.
Engine Coolant Checks
Check the engine coolant (antifreeze) protection every 12
months (before the onset of freezing weather, where appli-
cable). If the engine coolant (antifreeze) is dirty or rusty in
appearance, the system should be drained, flushed and
refilled with fresh coolant. Check the front of the A/C
condenser (if equipped) or radiator for any accumulation
of bugs, leaves, etc. If dirty, clean by gently spraying water
from a garden hose vertically down the face of the A/C
condenser (if equipped) or the back of the radiator core.
Check the engine cooling system hoses for brittle rubber,
cracking, tears, cuts and tightness of the connection at the
coolant recovery bottle and radiator. Inspect the entire
system for leaks.DO NOT REMOVE THE COOLANT PRESSURE CAP
WHEN THE COOLING SYSTEM IS HOT.
Cooling System — Drain Flush And Refill
If the engine coolant (antifreeze) is dirty or contains a
considerable amount of sediment, clean and flush with a
reliable cooling system cleaner. Follow with a thorough
rinsing to remove all deposits and chemicals. Properly
dispose of old engine coolant (antifreeze).
Refer to the “Maintenance Schedule” for the proper main-
tenance intervals.
Selection Of Coolant
Refer to “Fluids, Lubricants, And Genuine Parts” in “Main-
taining Your Vehicle” for further information.
CAUTION!
•Mixing of engine coolant (antifreeze) other than speci-
fied Organic Additive Technology (OAT) engine cool-
ant (antifreeze), may result in engine damage and may
decrease corrosion protection. Organic Additive Tech-
nology (OAT) engine coolant is different and should
(Continued)
662 MAINTAINING YOUR VEHICLE
Page 692 of 734

BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmospheric
conditions. This will usually clear as atmospheric condi-
tions change to allow the condensation to change back into
a vapor. Turning the lamps on will usually accelerate the
clearing process.
Base Quad / Premium Bi-Halogen: Low Beam
Headlamp, High Beam Headlamp, Front Park And
Turn — If Equipped
1. Open the hood.
2. Disconnect and isolate the negative battery cable.
3. Remove the six plastic push-in fasteners that secure the upper radiator seal to the grille support and both fender
ledges.
4. Remove the two plastic push-in rivets that secure the upper radiator seal to the radiator.
5. Remove the upper radiator seal from the vehicle. 6. Remove the two headlamp assembly attachment screws.
7. Reach into the front wheel house ahead of the front
wheel, remove the fastener, and lift the cover over the
access hole in the front of the wheel house splash shield.
Access to the rear of the lamp can be gained through this
access hole.
Headlamp Assembly Attachment Screw Locations
690 MAINTAINING YOUR VEHICLE
Page 723 of 734

Fuel, Flexible............................. .545
Fuses .................................. .679
Garage Door Opener (HomeLink) ............175, 180
Gas Cap (Fuel Filler Cap) .................549, 637
Gasoline, Clean Air ........................ .542
Gasoline (Fuel) ........................... .541
Gasoline, Reformulated ..................... .542
Gear Ranges .......................... .396, 405
Gear Select Lever Override ....................623
General Information ........................ .540
Glass Cleaning ........................... .677
Grocery Bag Retainer ....................... .200
Gross Axle Weight Rating .....................552
Gross Vehicle Weight Rating ...................551
Guide, Body Builders .........................6
GVWR ................................. .550
Hazard Driving Through Flowing, Rising, Or
Shallow Standing Water ....................472
Hazard Warning Flasher ..................... .580
Headlights .............................. .690
Automatic ............................ .139
Cleaning .............................. .677High Beam
............................ .147
High Beam/Low Beam Select Switch ...........147
Passing ............................... .147
Switch ............................... .139
Head Restraints ........................... .129
Heated Mirrors .........................115,200
Heater ................................. .330
Heater, Engine Block ....................... .385
High Beam/Low Beam Select (Dimmer) Switch .....147
Hill Descent Control ....................... .505
Hill Descent Control Indicator .................505
Hill Start Assist ........................... .498
Hitches Trailer Towing .......................... .558
Hoisting ................................ .618
HomeLink
(Garage Door Opener) ...............175
Hood Release ............................ .136
Hub Caps ............................... .617
Ignition ..................................15
Key.................................11,15
Ignition Key Removal ........................15
Illuminated Entry ...........................21
Immobilizer (Sentry Key) ......................17
Inside Rearview Mirror ...................104, 110
10
INDEX 721