2017 Ram 3500 Chassis Cab wheel torque

Do not oil wheel studs. For chrome wheels, do not substi-
tute with chrome plated wheel nuts.Retighten the wheel nuts in the same sequence to the
torques listed in the table. Go through the sequence a
second time to verify that specific torque has been
achieved. Retighten to specifications after 25 miles (40 km)
and check the lug nut/bolt torque to be sure that all the lug
nuts/bolts are properly seated against the wheel.
Two-Piece Lug NutWheel Mounting Surface
432 WHAT TO DO IN EMERGENCIES

1 — 10 Bolt Pattern
2 — 8 Bolt Pattern
WARNING!
To avoid the risk of forcing the vehicle off the jack, do
not tighten the lug nuts fully until the vehicle has been
lowered. Failure to follow this warning may result in
personal injury.
JACKING AND TIRE CHANGING
WARNING!
•Do not attempt to change a tire on the side of the
vehicle close to moving traffic, pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.
• Being under a jacked-up vehicle is dangerous. The
vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack.
• Never start or run the engine while the vehicle is on
a jack. If you need to get under a raised vehicle, take
it to a service center where it can be raised on a lift.
• The jack is designed to use as a tool for changing
tires only. The jack should not be used to lift the
vehicle for service purposes. The vehicle should be
jacked on a firm level surface only. Avoid ice or
slippery areas.
8/10 Lug Nuts/Bolts Torque Patterns
6
WHAT TO DO IN EMERGENCIES 433

Before raising the wheel off the ground, make sure that
the jack will not damage surrounding truck parts and
adjust the jack position as required.
NOTE:If the jack will not lower by turning the dial
(thumbwheel) by hand, it may be necessary to use the jack
drive tube in order to lower the jack.
4. By rotating the wheel wrench clockwise, raise the ve- hicle until the wheel just clears the surface.
WARNING!
Raising the vehicle higher than necessary can make the
vehicle unstable. It could slip off the jack and hurt
someone near it. Raise the vehicle only enough to
remove the tire.
5. Remove the wheel nuts and pull the wheel off. Install the spare wheel and wheel nuts with the cone shaped
end of the nuts toward the wheel on single rear wheel
(SRW) models. On dual rear wheel models (DRW) the
lug nuts are a two-piece assembly with a flat face.
Lightly tighten the nuts. To avoid risk of forcing the
vehicle off the jack, do not fully tighten the nuts until the
vehicle has been lowered.
6. Using the wheel wrench, finish tightening the nuts using a crisscross pattern. For the proper lug nut torque
specifications refer to “Wheel and Tire Torque Specifi-
cations” in this section. If in doubt about the correct
tightness, have them checked with a torque wrench by
your authorized dealer or at a service station.
Rear Jacking Location
6
WHAT TO DO IN EMERGENCIES 437

CAUTION!
•Use a pulling motion to remove the hub cap. Do not
use a twisting motion when removing the hub cap,
damage to the hub cap; finish may occur.
• The rear hub caps on the dual rear wheel has two
pull off notches. Make sure that the hook of the jack
handle driver is located squarely in the cap notch
before attempting to pull off.
You must use the flat end of the lug wrench to pull off the
wheel skins. Locate the hub cap pull notches (2 notches on
each cap). Insert the flat tip completely and using a back
and forth motion, loosen the wheel skin. Repeat this
procedure around the tire until the skin pops off.
Replace the wheel skins first using a rubber mallet. When
replacing the hub caps, tilt the cap retainer over the lug nut
bolt circle and strike the high side down with a rubber
mallet. Be sure that the hub caps and wheel skins are firmly
seated around the wheel.
Dual Rear Wheels
Slots in the wheels will assist in properly orienting the
inner and outer wheels. Align these slots when assembling
the wheels for best access to the tire valve on the inner wheel. The tires of both dual wheels must be completely off
the ground when tightening to insure wheel centering and
maximum wheel clamping.
Dual wheel models require a special heavy-duty lug nut
tightening adapter (included with the vehicle) to correctly
tighten the lug nuts. Also, when it is necessary to remove
and install dual rear wheels, use a proper vehicle lifting
device.
NOTE:
When installing a spare tire (if equipped) as part of
a dual rear wheel end combination, the tire diameter of the
two individual tires must be compared. If there is a
significant difference, the larger tire should be installed in
a front location. The correct direction of rotation for dual
tire installations must also be observed.
It is recommended that wheel stud nuts be kept torqued to
specifications at all times. Torque wheel stud nuts to
specifications at each lubrication interval.
Wheel Nuts
All wheel nuts should be tightened occasionally to elimi-
nate the possibility of wheel studs being sheared or the bolt
holes in the wheels becoming elongated. This is especially
important during the first few hundred miles/kilometers
of operation to allow the wheel nuts to become properly
6
WHAT TO DO IN EMERGENCIES 439

set. All wheel nuts should first be firmly seated against the
wheel. The wheel nuts should then be tightened to recom-
mended torque. Tighten the wheel nuts to final torque in
increments. Progress around the bolt circle, tightening the
wheel nut opposite to the wheel nut just previously
tightened until final torque is achieved.
To Stow The Flat Or Spare — If Equipped
Refer to Upfitters Body Builders Guide for information on
stowing your spare tire (if equipped).
HOISTING
A conventional floor jack may be used at the jacking
locations. Refer to the graphics that show jacking locations.
However, a floor jack or frame hoist must never be used on
any other parts of the underbody.
CAUTION!
Never use a floor jack directly under the differential
housing of a loaded truck or damage to your vehicle
may result.
JUMP-STARTING PROCEDURES
If your vehicle has a discharged battery, it can be jump-
started using a set of jumper cables and a battery in another
vehicle or by using a portable battery booster pack. Jump-
starting can be dangerous if done improperly, so please
follow the procedures in this section carefully.
NOTE:When using a portable battery booster pack, follow
the manufacturer ’s operating instructions and precautions.
WARNING!
Do not attempt jump-starting if the battery is frozen. It
could rupture or explode and cause personal injury.
CAUTION!
Do not use a portable battery booster pack or any other
booster source with a system voltage greater than
12 Volts or damage to the battery, starter motor, alter-
nator or electrical system may occur.
440 WHAT TO DO IN EMERGENCIES

Tires...........................96, 381, 386, 394
Aging (Life Of Tires) ..................... .389
Air Pressure ........................ .376, 381
Chains ............................... .390
Compact Spare ......................... .386
Dual .......................... .393, 431, 439
General Information ...................381, 386
High Speed ............................ .383
Inflation Pressures ....................... .382
Life Of Tires ........................... .389
Load Capacity ...................... .376, 378
Pressure Monitor System (TPMS) .............395
Pressure Warning Light ....................212
Quality Grading ........................ .394
Radial ............................... .384
Replacement ........................... .389
Rotation .............................. .392
Safety ............................ .370, 381
Sizes ................................ .372
Snow Tires ............................ .385
Spare Tire ......................... .386, 387
Spinning .............................. .388
Tread Wear Indicators .....................388
Wheel Nut Torque ....................... .437
Tire Safety Information ...................... .370Tongue Weight/Trailer Weight
.................413
Torque Converter Clutch .....................339
Tow Hooks, Emergency ..................... .444
Towing ............................. .409, 446
Disabled Vehicle ........................ .446
Guide ................................ .413
Recreational ........................... .423
Weight ............................... .413
Towing Vehicle Behind A Motorhome ............423
Traction ................................ .351
T
raction Control .......................... .362
Trailer Sway Control (TSC) ....................367
Trailer Towing ............................ .409
Cooling System Tips ..................... .421
Hitches ............................... .412
Minimum Requirements ....................414
Mirrors ................................111
Trailer And Tongue Weight ..................413
Wiring ............................... .419
Trailer Towing Guide ....................... .413
Trailer Weight ............................ .413
Transfer Case ............................ .483
Electronically Shifted ..................... .346
Fluid ................................ .510
Transmission ............................. .484
536 INDEX

Automatic......................... .331, 484
Fluid ................................ .510
Shifting .............................. .329
Transporting Pets ...........................91
Tread Wear Indicators ...................... .388
Turn Signals ....................... .135, 220, 501
Uconnect Customer Programmable Features .........250, 270
Operation ............................. .276
Uconnect Settings ....................... .240
Uconnect Settings .....................250, 270
Uconnect 8.4/8.4 NAV ...................... .319
Uconnect 8.4 Settings Customer Programmable Features — Units ......262
Uconnect Access Vehicle Health Alert .......................311
Uconnect Settings Customer Programmable Features .......34, 248, 268
Passive Entry Programming ...........34, 248, 268
Uconnect Settings .....................248, 268
Uconnect Voice Command ....................298
Uniform Tire Quality Grades ..................394 Universal Garage Door Opener (HomeLink)
Programming HomeLink ............166, 168, 169
Unleaded Gasoline ........................ .402
Untwisting Procedure, Seat Belt .................47
Vehicle Identification Number (VIN) ...............7
Vehicle Loading ....................... .378, 407
Vehicle Modifications/Alterations .................7
Vehicle Storage ........................ .295, 500
Viscosity, Engine Oil ....................... .459
Voice Recognition System (VR) .................298
Warnings And Cautions .......................6
Warranty Information ...................... .521
Washers, Windshield .....................137, 474
Washing Vehicle .......................... .487
Water Driving Through ........................ .352
Wheel And Wheel Trim ..................... .488
Wheel And Wheel Trim Care ..................488
Wheel

Cover ............................. .438
Wheel Nut Torque ..................... .437, 439
Wind Buffeting .............................40
10
INDEX 537