2017 Peugeot 301 ECU

95
(a)Universal child seat: child seat that can be
installed in all vehicles using the seat belt.
(b) Group 0: from birth to 10 kg. Carry-cots
and car beds cannot be installed in the
front passenger seat.
(c) Refer to the current legislation in your
country before installing your child on this
seat.
(d) When installing a child seat on a rear seat
in a rearward or forward-facing position,
move the front seat for ward then adjust
the backrest to an upright position to allow
enough room for the child seat and the
child's legs. (e)
When you install a "rear ward facing" child
seat in the front passenger seat , the
passenger air bag must be deactivated.
Otherwise, the child would risk being
seriously injured or killed if the air
bag were deployed . When a "for ward
facing" child seat is installed on the front
passenger seat , the passenger's air bag
must remain activated.
U: Seat suitable for the installation of a
child seat secured using a seat belt and
universally approved, rearward facing and/
or forward facing.
X: Seat not suitable for the installation of a
child seat of the weight group indicated. Remove and stow the head restraint
before installing a child seat with backrest
on a passenger seat. Refit the head
restraint once the child seat has been
removed.
5
Safety

96
Advice
The incorrect installation of a child seat in a
vehicle compromises the child's protection in
the event of an accident.
Ensure that there is no seat belt or seat belt
buckle under the child seat, as this could
destabilise it.
Remember to fasten the seat belts or the
child seat harnesses keeping the slack
relative to the child's body to a minimum,
even for short journeys.
When installing a child seat using the seat
belt, ensure that the seat belt is tightened
correctly on the child seat and that it secures
the child seat firmly on the seat of your
vehicle. If your passenger seat is adjustable,
move it for wards if necessary.
At rear seating positions, always leave
sufficient space between the front seat and:
-
a r
ear ward facing child seat,
-

t
he child's feet for a child seat fitted
forward facing.
To do this, move the front seat for wards
and, if necessary, move its backrest into the
upright position. For optimal installation of the forward-facing
child seat, verify that its backrest is as close
as possible to the backrest of the vehicle
seat, or if possible in contact with it.
The head restraint must be removed before
installing a child seat with a backrest on the
passenger seat.
Ensure that the headrest is stowed or
attached securely so that it is not thrown
around the vehicle in the event of sharp
braking. Refit the head restraint once the
child seat has been removed.
Children in front
The legislation on carrying children on the
front passenger seat is specific to each
country. Consult the legislation in force in
your country.
Deactivate the passenger's front airbag
when a rear ward facing child seat is installed
on the front passenger seat.
Otherwise, the child risks being seriously
injured or killed if the airbag is deployed.
Installing a booster seat
The chest part of the seat belt must be
positioned on the child's shoulder without
touching the neck.Ensure that the lap part of the seat belt
passes correctly over the child's thighs.
PEUGEOT
recommends using a booster seat
with a backrest equipped with a belt guide at
shoulder level.
As a safety precaution, do not leave:
-

a c
hild or children alone and
unsupervised in a vehicle,
-

a c
hild or an animal in a vehicle which
is exposed to the sun, with the windows
closed,
-

t
he keys within reach of children inside
the vehicle.
To prevent accidental opening of the doors
and rear windows, use the child lock.
Take care not to open the rear windows by
more than one third.
To protect young children from the rays of
the sun, fit side blinds on the rear windows.
Safety

97
"ISOFIX" mountings
Your vehicle has been approved in accordance
with the latest ISOFIX regulation.
The seats, shown below, are fitted with
regulation ISOFIX mountings:
There are three rings for each seat:
-
T
wo rings A , located between the vehicle
seat back and cushion, indicated by a
marking. -

A r
ing B, located under a cover on the back
of the top of the seat backrest, referred to
as the TOP TETHER for fixing the upper
strap. Its position is indicated by a marking.
The TOP TETHER is used to secure the upper
strap of child seats that have them. This device
limits for ward tipping of the child seat, in the
event of a front impact.
This ISOFIX mounting system provides fast,
reliable and safe fitting of the child seat in your
vehicle.
The ISOFIX child seats are fitted with two
latches which are easily secured on the two
rings A .
Some also have an upper strap which is
attached to ring B . To secure the child seat to the TOP TETHER :
-
P ass the child seat strap over the centre of
the vehicle's seat backrest.
-

L
ift the TOP TETHER cover.
-

S
ecure the upper strap fixing to the ring B.
-

T
ighten the upper strap.
When installing an ISOFIX child seat on the
right hand rear seat, before securing the seat,
first move the centre rear seat belt towards the
middle of the vehicle, so as to not inter fere with
the operation of the seat belt.
The incorrect installation of a child seat
in a vehicle compromises the child's
protection in case of accident.
Strictly observe the fitting instructions
provided with the child seat.
For information on the possibilities for installing
ISOFIX child seats in your vehicle, refer to the
summary table.
5
Safety

98
ISOFIX child seats recommended by PEUGEOT and approved
for your vehicle
"RÖMER Baby- Safe Plus and its
ISOFIX base"
(size category: E )
Group 0+: from bir th to 13 kg
Installed rearward facing using an ISOFIX base attached to rings A .
The base has a support leg, height-
adjustable, which rests on the vehicle's floor. This child seat can also be secured with a
seat belt. In this case, only the shell is used and must be attached to the vehicle seat using the three-point seat belt. "RÖMER Duo Plus ISOFIX"
(size category: B1 )
Group 1: from 9 to 18kg
Is installed only in the forward facing position. Attaches to anchorage rings A and upper anchorage ring B , referred to as the Top
Tether, using an upper strap.
Three seat body angles: sitting, reclining, lying down. This child seat can also be used on seats
not equipped with ISOFIX mountings.
In this case, it must be secured to the
vehicle seat using the three-point seat
belt.
Adjust the front seat of the vehicle so that
the child's feet do not touch the backrest.
Follow the instructions for fitting
child seats contained in the seat
manufacturer's installation guide.
Safety

100
I UF:seat suitable for the installation of
an Isofix U niversal seat, " For ward
facing", secured using the top tether.
IL- SU: seat suitable for the installation of
an Isofix S emi-Universal seat which
is either:
-

"
rear ward facing" fitted with a
top tether or a support leg,
-

"
for ward facing" fitted with a
support leg.
For advice on securing of the
upper strap, refer to the "ISOFIX
mountings" section.
X: seat which is not suitable for the
installation of an ISOFIX seat of the
size category indicated.
Mechanical child lock
Mechanical system to prevent opening of a rear door using its interior control.
The control is located on the edge of each rear door.
Locking Unlocking
F With the ignition key, turn the red control
one quarter of a turn:
-

T
o the right on the left-hand rear door.
-

T
o the left on the right-hand rear door. F

W
ith the ignition key, turn the red control
one quarter of a turn:
-
T
o the left on the left-hand rear door.
-
T
o the right on the right-hand rear door.
Safety

121
Exceeding programmed
speed
Pressing the accelerator pedal in order to
exceed the programmed speed will have
no effect unless you press the pedal firmly
beyond the point of resistance .
The speed limiter is deactivated temporarily
and the programmed speed, which is still
displayed, flashes, accompanied by an audible
signal.
Returning to the programmed speed, by means
of intentional or unintentional deceleration of
the vehicle, automatically cancels the flashing
of the programmed speed and the audible
signal stops.
Existing the limiter mode Malfunction
In the event of a speed limiter fault, the speed
is cleared resulting in flashing of the dashes.
Have them checked by a PEUGEOT
dealer or a
qualified workshop.
On a steep descent or in the event of
sharp acceleration, the speed limiter will
not be able to prevent the vehicle from
exceeding the programmed speed.
To avoid any risk of jamming the pedals:
-

e
nsure that the mat is secured
c o r r e c t l y,
-

d
o not fit one mat on top of another.
F

T

urn thumb wheel 1 to the 0 position:
the speed limiter mode is deselected.
The display returns to the total mileage
recorder.
6
Driving

124
Exceeding the programmed
speed
Intentional or unintentional exceeding of the
programmed speed results in flashing of this
speed on the display.
Returning to the programmed speed, by means
of intentional or unintentional deceleration of
the vehicle, automatically cancels the flashing
of the programmed speed.
Leaving cruise control modeMalfunction
When cruise control is active, be careful
when holding one of the speed setting
buttons: this may result in a very rapid
change in the speed of your vehicle.
Do not use the cruise control on slippery
roads or in heavy traffic.
When descending a steep hill, the cruise
control system cannot prevent the vehicle
from exceeding the programmed speed.
To avoid any risk of jamming the pedals:
-

E
nsure that mats are secured
c o r r e c t l y.
-

D
o not fit one mat on top of another.
In the event of a cruise control fault, the speed
is cleared resulting in flashing of the dashes.
Have them checked by a PEUGEOT
dealer or a
qualified workshop.
F

T

urn thumb wheel 1 to the 0 position:
the cruise control mode is deselected.
The display returns to the total mileage
recorder.
Driving

149
Temporary puncture repair kit
Comprising a compressor and a sealant
cartridge, it allows the temporary repair of
a tyre so that you can drive to the nearest
garage.
It is designed to repair most punctures which
could affect the tyre, located on the tyre tread
or shoulder.Access to the kit
The vehicle's electric system allows the
connection of the compressor for long
enough to inflate a tyre after a puncture
repair.
This kit is installed in the storage box, under
the boot floor.
Composition of the kit
Do not exceed a speed of 50 mph
(80 km/h) when driving with a tyre repaired
using this type of kit.
1.
12 V compressor, with built-in pressure
gauge.
2. Bottle of sealant, with with built-in hose.
3. Speed limit sticker.
The speed limit sticker must be secured
to the interior of the vehicle in the driver's
field of vision, to remind you that a wheel
is in temporary use.
8
In the event of a breakdown