2017 Peugeot 208 key

39
Changing the battery
Battery ref.: CR1,620 / 3 volts.If the battery is flat, you are informed
by lighting of this warning lamp in
the instrument panel, an audible
signal and a message in the screen.
F

U
nclip the cover using a small screwdriver
at the cut-out.
F

R
emove the cover.
F

R
emove the discharged battery from its
housing.
F

F
it the new battery into its housing
observing the polarity.
F

C
lip the cover onto the casing.Do not throw away the remote control
batteries, they contain metals which are
harmful to the environment.
Take them to an approved collection
point. Lost keys
Go to a PEUGEOT dealer, taking with you
the vehicle's registration certificate, your
personal identification documents and if
possible, the label bearing the key code.
The PEUGEOT dealer will be able to look
up the key code and the transponder code
required to order a new key.
Closed vehicle
Driving with the doors locked could make it
difficult for the emergency services to enter
the vehicle in an emergency.
As a safety precaution, never leave children
alone in the vehicle, except for a very short
period.
In all cases, it is essential to remove the key
from the ignition switch when leaving the
vehicle.
Remote control
The high frequency remote control is a
sensitive system; do not operate it while
it is in your pocket as there is a possibility
that it may unlock the vehicle, without you
being aware of it.
Do not repeatedly press the buttons of your
remote control out of range and out of sight
of your vehicle. It may become inoperative.
It will then be necessary to reinitialise it
again.
No remote control can operate when the
key is in the ignition switch, even when
the ignition is switched off, except for
reinitialisation. Anti-theft protection
Do not make any modifications to the
electronic engine immobiliser system; this
could cause malfunctions.
Second-hand vehicle
Have the pairing of all of the keys in your
possession checked by a PEUGEOT dealer,
to ensure that only your keys can be used to
open and start the vehicle.
2
Access

40
Central locking
This function allows the doors and boot to be
locked or unlocked simultaneously from inside
the vehicle.
Locking
F Press this button.
This locks the doors and the boot.The indicator lamp comes on.
If one of the doors is open, the central
locking from the inside does not take
place.
Release
F Press this button again. The indicator lamp goes off. When locking / deadlocking from the
outside
When the vehicle is locked or deadlocked
from outside, the switch does not operate.
F

A
fter normal locking, pull one of the
interior door levers to unlock the
vehicle.
F
A
fter deadlocking, it is necessary to
use the remote control, or the key to
unlock the vehicle.
Automatic central locking
The doors lock automatically while driving
(speed above 6 mph [10 km/h]).
F

T
o activate or deactivate this
function (activated by default),
press this button until a buzzer
sounds and/or a message
appears in the screen.
Driving with the doors locked may render
access by the emergency services to the
interior difficult in an emergency.
Boot
Opening
Unlock the vehicle.
F

P

ress the tailgate opening button to
release it, and then guide it open.
Closing
F Lower the tailgate using the interior grab handle.
F

I
f necessary, press down on the tailgate to
fully close it.
Access

43
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the key in the driver's door lock.
Triggering of the alarm
When the alarm is triggered, the siren sounds
and the direction indicators flash for thirty
seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times
consecutively.
When the vehicle is unlocked using
the remote control, rapid flashing
of the indicator lamp in the button
informs you that the alarm was
triggered during your absence.
Upon ignition, this flashing stops
immediately.
Deactivate the monitoring
functions
To stop the alarm, for example if the remote
control is not working:
F

U
nlock the vehicle using the key in the
driver's door lock.
F

o
pen the door; the alarm is triggered,
F

S
witch on the ignition; this stops the alarm.
The indicator lamp goes off.
Malfunction
When the ignition is switched on,
fixed illumination of the button’s
indicator lamp indicates a fault in the
system.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
Electric windows
Manual mode
Open
Press the control, without passing
the point of resistance. The window
stops as soon as you release the
switch.
Close
Pull the control without going past
the point of resistance. The window
stops as soon as you release the
switch.
2
Access

44
Automatic mode
(depending on version)
Open
Press the control, beyond the
resistance point: the window opens
completely when the switch is
released. Pressing the switch again
stops the movement of the window.
Close
Pull the control, beyond the
resistance point: the window closes
completely when the switch is
released. Pressing the switch again
stops the movement of the window.
The electric window controls remain
operational for approximately 1


minute
after the key has been removed.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.
Anti-pinch
Deactivating the rear door
electric windows
For the safety of your children, press
the switch to prevent operation of
the electric windows of the rear
doors, irrespective of their position.
With the warning lamp on, the rear switches
are deactivated. With the warning lamp off, the
switches are active.
Reinitialisation
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch is not active during these
operations:
-

b
ring the window down completely, then
bring it back up. It will go up by a few
centimetres with each press. Repeat the
operation until the window is fully closed,
-

c
ontinue to pull the switch upwards for at
least 1
second after reaching this position,
window closed.
Always remove the key when leaving the
vehicle, even for a short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this, press
the switch concerned.
When operating the passenger electric
window switches, the driver must ensure
that no one is preventing correct closing of
the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be aware of children when operating the
windows.
(depending on version)
When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening
of the window when closing
automatically, press the switch until
the window opens completely, then
pull the switch immediately until the
window closes. Continue to hold the
control for approximately 1

second
after the window has closed.
The safety anti-pinch function is not active
during this operation.
Access

61
Rear screen demist –
defrost
The control button is located on the air
conditioning or heating system control panel.
Rear screen demisting – defrosting can only be
operated when the engine is running.
Switching on
F Press this button to demist /defrost the rear screen and,
depending on version, the
electric door mirrors. The
indicator lamp associated with
the button comes on.
Switching off
Demisting / defrosting switches off automatically
to prevent excessive electrical consumption.
F It is possible to stop the demisting/defrosting operation
before it is switched off
automatically by pressing the
button again. The indicator lamp
associated with the button goes
of f.
Courtesy lampTo demist or defrost the electric door
mirrors, with the engine running
press the heated rear window
switch.
Switch off the demisting/defrosting of
the rear screen and electric door mirrors
as soon as appropriate, as lower current
consumption results in reduced fuel
consumption.
1.Courtesy lamp
2. Map reading lamps
In this position, the light comes
on gradually:
-

w
hen you unlock the vehicle,
-

w
hen the key is removed from the ignition,
-
w

hen opening a door,
-
w

hen unlocking remotely.
3
Ease of use and comfort

85
Front airbags
This system protects the driver and front
passenger in the event of a severe frontal
impact in order to limit the risk of injury to the
head and chest.
The driver's airbag is fitted in the centre of the
steering wheel; the front passenger's airbag is
fitted in the dashboard above the glove box.
Deployment
The airbags are deployed, except the
passenger's front airbag if it has been
deactivated, in the event of a serious front
impact to all or part of the front impact zone A,
in the longitudinal centreline of the vehicle on a
horizontal plane and directed from the front to
the rear of the vehicle.
The front airbag inflates between the thorax
and head of the front occupant of the vehicle
and the steering wheel, driver's side, and the
dashboard, passenger's side, to cushion their
for ward movement.
Deactivation
Only the passenger's front airbag can be
deactivated.
F

W
ith the ignition off , insert the key into the
passenger airbag deactivation switch.
F

T
urn it to the "OFF" position.
F

R
emove the key keeping the switch in this
position.
When the ignition is on, this warning
lamp comes on in the instrument
panel and stays on while the airbag is
deactivated.
To assure the safety of your child,
the passenger's front airbag must be
deactivated when you install a "rear ward
facing" child seat on the front passenger
seat. Otherwise, the child risks being
seriously injured or killed if the airbag is
deployed.
Reactivation
When you remove the rear ward facing child
seat, with the ignition off , turn the switch to
the ON position to reactivate the airbag and so
assure the safety of your front passenger in the
event of an impact.
Malfunction
If this warning lamp on the
instrument panel comes on, you
must contact a PEUGEOT dealer
or a qualified workshop to have the
system checked. The airbags may
no longer be deployed in the event
of a serious impact.
5
Safety

90
Deactivating the passenger's
front airbag
F With the ignition off, insert the key in the
passenger airbag deactivation switch.
F

T
urn it to the OFF position.
F

R
emove the key keeping the switch in the
new position.
To assure the safety of your child,
the passenger's front airbag must be
deactivated when you install a rear ward
facing child seat on the front passenger
seat.
Otherwise, the child would risk being
seriously injured or killed if the airbag
were deployed.
Reactivating the passenger's
front airbag
When you remove a rear ward facing child seat,
with the ignition off , turn the switch to the ON
position to reactivate the airbag and so assure
the safety of your front passenger in the event
of an impact.
When the ignition is switched on,
this warning lamp comes on in the
instrument panel, for approximately
one minute to signal that the front
airbag is activated.
When the ignition is switched on,
this warning lamp comes on in the
instrument panel. It stays on while
the airbag is deactivated.
Safety

102
Advice
The incorrect installation of a child seat in a
vehicle compromises the child's protection in
the event of an accident.
Check that there is no seat belt or seat belt
buckle under the child seat as this could
make it unstable.
Remember to fasten the seat belts or the
child seat harnesses keeping the slack
relative to the child's body to a minimum,
even for short journeys.
When installing a child seat using the seat
belt, ensure that the seat belt is tightened
correctly on the child seat and that it secures
the child seat firmly on the seat of your
vehicle. If your passenger seat is adjustable,
move it for wards if necessary.
At rear seating positions, always leave
sufficient space between the front seat and:
-
a "
rear ward facing" child seat,
-

t
he feet of a child seated in a "for ward
facing" child seat.
For this, move the seat for ward and if
necessary straighten its backrest too. For optimal installation of the "forward facing"
child seat, verify that its backrest is as close
as possible to the backrest of the vehicle
seat, if possible in contact with it.
The head restraint must be removed before
installing a child seat with a backrest on a
passenger seat.
Ensure that the head restraint is stored or
attached securely to prevent it from being
thrown around the vehicle in the event of
sharp braking. Refit the head restraint once
the child seat has been removed.
Children in front
The legislation on carrying children on the
front passenger seat is specific to each
country. Refer to the legislation in force in
your country.
Deactivate the passenger's front airbag when
a rear ward facing child seat is installed on the
front passenger seat.
Otherwise, the child risks being seriously
injured or killed if the airbag is deployed. Installing a booster seat
The chest part of the seat belt must be
positioned on the child's shoulder without
touching the neck.
Ensure that the lap part of the seat belt
passes correctly over the child's thighs.
PEUGEOT recommends using a booster seat
with a backrest, equipped with a belt guide at
shoulder level.
As a safety precaution, do not leave:
-

a c
hild or children alone and unattended in
a vehicle,
-

a c
hild or an animal in a vehicle exposed
to the sun, with the windows closed,
-

t
he keys within the reach of children inside
the vehicle.
To prevent accidental opening of the doors
and rear windows, use the child lock.
Take care not to open the rear windows by
more than one third.
To protect young children from the rays of the
sun, fit side blinds on the rear windows.
Safety