Page 226 of 289
224Vehicle careFront turn signal (3)
1. Rotate bulb socket anticlockwiseto disengage. Withdraw the bulb
socket from the reflector housing.
2. Remove the bulb from the socket by turning anticlockwise and
pulling.
3. Replace and insert new bulb into socket and turn clockwise.
4. Insert the bulb socket into the reflector housing and turn
clockwise.
LED headlights
Headlights for low and high beam,
sidelights, daytime running lights and turn signal lights are designed as
LEDs and can not be changed.
Have lights repaired by a workshop in
case of failure.
Fog lights
The bulbs are accessible from
beneath the vehicle.
1. Remove the outer screws of the cover, as shown in the illustration.
Page 233 of 289
Vehicle care231No.Circuit1Engine control module2Lambda sensor3Fuel injection/Ignition system4Fuel injection/Ignition system5–6Exterior mirror heating/Anti-
theft alarm system7Fan control/Engine control
module/Transmission control
module8Lambda sensor/Engine cooling9Rear window sensor10Battery sensor11Tailgate release12Adaptive forward lighting/Auto‐
matic light control13ABS14Rear window wiper15Engine control moduleNo.Circuit16Starter17Transmission control module18Heated rear window19Front power windows20Rear power windows21Rear electrical centre22Left high beam (Halogen)23–24Right headlight (LED)25Left headlight (LED)26Front fog lights27Diesel fuel heating28Stop-start system29Electric parking brake30ABS31Adaptive cruise control32Airbag
Page 254 of 289

252Vehicle careLead connection order:1. Connect the red lead to the positive terminal of the booster
battery.
2. Connect the other end of the red lead to the positive terminal of the
discharged battery.
3. Connect the black lead to the negative terminal of the boosterbattery.
4. Connect the other end of the black
lead to a vehicle grounding point
of your vehicle in the engine
compartment.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump.
2. After five minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of one
minute.3. Allow both engines to idle for approx. three minutes with the
leads connected.
4. Switch on electrical consumers (e.g. headlights, heated rear
window) of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle
Disengage cap at bottom and removedownwards.
The towing eye is stowed with the
vehicle tools 3 235.
Page 257 of 289

Vehicle care255If using a vehicle wash, comply with
the vehicle wash manufacturer's
instructions. The windscreen wiper and rear window wiper must be
switched off. Remove antenna and
external accessories such as roof
racks etc.
If you wash your vehicle by hand,
make sure that the insides of the
wheel housings are also thoroughly
rinsed out.
Clean edges and folds on opened
doors and the bonnet as well as the
areas they cover.
Clean bright metal mouldings with a
cleaning solution approved for
aluminium to avoid damages.Caution
Always use a cleaning agent with
a pH value of four to nine.
Do not use cleaning agents on hot surfaces.
Do not clean the engine compartmentwith a steam-jet or high-pressure jet
cleaner.
Thoroughly rinse and leather-off the vehicle. Rinse leather frequently. Use
separate leathers for painted and
glass surfaces: remnants of wax on
the windows will impair vision.
Have the door hinges of all doors
greased by a workshop.
Do not use hard objects to remove
spots of tar. Use tar removal spray on
painted surfaces.
Exterior lights
Headlight and other light covers are
made of plastic. Do not use any
abrasive or caustic agents, do not use an ice scraper, and do not clean them
dry.
Polishing and waxing
Wax the vehicle regularly (at the
latest when water no longer beads).
Otherwise, the paintwork will dry out.
Polishing is necessary only if the paint
has become dull or if solid deposits
have become attached to it.
Paintwork polish with silicone forms a
protective film, making waxing
unnecessary.Plastic body parts must not be treated with wax or polishing agents.
Windows and windscreen wiper
blades
Use a soft lint-free cloth or chamois
leather together with window cleaner and insect remover.
When cleaning the rear window from
inside, always wipe in parallel to the
heating element to prevent damage.
For mechanical removal of ice, use a
sharp-edged ice scraper. Press the
scraper firmly against the glass so
that no dirt can get under it and
scratch the glass.
Remove dirt residues from smearing wiper blades by using a soft cloth and window cleaner. Also make sure to
remove any residues such as wax,
insect residues and similar from the
window.
Ice residues, pollution and continuous
wiping on dry windows will damage or
even destroy the wiper blades.
Page 286 of 289

284GGauges ....................................... 104
Gear shifting ............................... 114
General information ...................208
Glass panel .................................. 34
Glovebox ..................................... 66
H Halogen headlights ....................222
Hand brake ................................. 166
Hazard warning flashers ............137
Headlight flash ........................... 134
Headlight range adjustment ......134
Headlights................................... 132 Headlights when driving abroad 135
Head restraint adjustment .............8
Head restraints ............................ 36
Heated mirrors ............................. 30
Heated rear window ..................... 33
Heated steering wheel .................97
Heating ........................................ 43
Heating and ventilation system . 142
High beam ......................... 116, 133
High beam assist ................116, 133
Hill start assist ........................... 168
Horn ....................................... 14, 98
I
Identification plate .....................262
Ignition switch positions .............151
Immobiliser .......................... 28, 116Indicators.................................... 104
Info display ................................. 121
Information displays.................... 117
Instrument cluster ......................104
Instrument panel fuse box .........232
Instrument panel illumination .....229
Instrument panel illumination control .................................... 139
Instrument panel overview ........... 10
Interactive driving system ...........171
Interior care ............................... 256
Interior lighting ............................ 139
Interior lights ...................... 139, 228
Interior mirrors .............................. 30
Interruption of power supply ......164
Introduction .................................... 3
J
Jump starting ............................. 251
K Keys ............................................. 20
Keys, locks ................................... 20
L Lane departure warning .....114, 197
Lashing eyes ............................... 88
LED headlights ...........116, 136, 224
Lighting features .........................140
Light switch ................................ 132
Load compartment ................25, 79Load compartment cover .............81
Load compartment fuse box ......233
Loading information .....................94
Load rails and hooks ...................88
Low fuel ..................................... 116
M Malfunction indicator light ..........112
Manual anti-dazzle ......................30
Manual mode ............................. 163
Manual seat adjustment ...............39
Manual transmission .................. 165
Manual windows ..........................31
Memorised settings ......................22
Mirror adjustment ........................... 8
Misted light covers .....................138
N
New vehicle running-in ..............151
Number plate light .....................228
O Object detection systems ...........188
Odometer ................................... 104
Oil, engine .................. 216, 259, 264
OnStar ........................................ 128
Operate pedal ............................. 113
Outside temperature ..................100
Overhead console .......................68
Overrun cut-off ........................... 153
Page:
< prev 1-8 9-16 17-24