Page 203 of 247

Vehicle care201
6. Press SET/CLR to begin the
sensor matching process. A
message requesting acceptance
of the process should be
displayed.
7. Press SET/CLR again to confirm
the selection. The horn sounds
twice to signal that the receiver is
in relearn mode.
8. Start with the left side front wheel.
9. Place the relearn tool against the tyre sidewall, near the valve stem.Then press the button to activate
the tyre pressure sensor. A horn
chirp confirms that the sensor
identification code has been
matched to this tyre and wheel
position.
10. Proceed to the right side front wheel, and repeat the procedure
in Step 9.
11. Proceed to the right side rear wheel, and repeat the procedure
in Step 9.
12. Proceed to the left side rear wheel, and repeat the procedure
in Step 9. The horn sounds twice
to indicate the sensor
identification code has been
matched to the left side rear
wheel, and the tyre pressure
sensor matching process is no
longer active.
13. Turn off the ignition.
14. Set all four tyres to the recommended air pressure level
as indicated on the tyre pressure
information label.
15. Ensure the tyre loading status is set according to the selected tyre
pressure 3 97.Tread depth
Check tread depth at regular
intervals.
Tyres should be replaced for safety
reasons at a tread depth of 2-3 mm
(4 mm for winter tyres).
For safety reasons it is recommended
that the tread depth of the tyres on
one axle should not vary by more than 2 mm.
The legally permissible minimum
tread depth (1.6 mm) has been
reached when the tread has worn
down as far as one of the tread wear
Page 214 of 247

212Vehicle careTowingTowing the vehicle
Disengage cap by using a
screwdriver and remove.
The towing eye is stowed with the vehicle tools 3 195.
Screw in the towing eye as far as it will
go until it stops in a horizontal
position.
Attach a tow rope – or better still a tow
rod – to the towing eye.
The towing eye must only be used for towing and not for recovering the
vehicle.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.
Transmission in neutral.
Caution
Never tow a vehicle equipped with All Wheel Drive (AWD) with the
front or rear tyres on the road. If
you tow a vehicle equipped with
AWD while the front or rear tyres
are rolling on the road, the drive
system in the vehicle could be
severely damaged. When towing
vehicles equipped with AWD, all
four tyres must not be in contact
with the road.
Caution
Drive slowly. Do not drive jerkily.
Excessive tractive force can
damage the vehicle.
When the engine is not running,
considerably more force is needed to
brake and steer.
To prevent the entry of exhaust gases from the towing vehicle, switch on the
air recirculation system 3 127 and
close the windows.
Page 240 of 247

238Customer information● Vehicle reactions in particulardriving situations (e.g. inflation of
an airbag, activation of the
stability regulation system)
● Environmental conditions (e.g. temperature)
These data are exclusively technical
and help identifying and correcting
errors as well as optimizing vehicle
functions.
Motion profiles indicating travelled
routes cannot be created with these
data.
If services are used (e.g. repair
works, service processes, warranty cases, quality assurance),
employees of the service network
(manufacturer included) are able to
read out this technical information
from the event and error data storage
modules applying special diagnostic
devices. If required, you will receive
further information at these
workshops. After an error has been
corrected, the data are deleted from
the error storage module or they are
constantly overwritten.When using the vehicle, situations
may occur in which these technical
data related to other information
(accident report, damages on the
vehicle, witness statements etc.) may be associated with a specific person -possibly, with the assistance of an
expert.
Additional functions contractually
agreed upon with the client (e.g.
vehicle location in emergency cases)
allow the transmission of particular
vehicle data from the vehicle.
Radio Frequency
Identification (RFID)
RFID technology is used in some
vehicles for functions such as tyre
pressure monitoring and ignition
system security. It is also used in
connection with conveniences such
as radio remote controls for door
locking/unlocking and starting, and in-
vehicle transmitters for garage door
openers. RFID technology in Opel
vehicles does not use or record
personal information or link with any
other Opel system containing
personal information.
Page 244 of 247

242Heated rear window ..................... 36
Heated steering wheel .................77
Heating ........................................ 43
Heating and ventilation system . 126
High beam ........................... 96, 116
High beam assist ..................96, 117
Hill start assist ........................... 149
Horn ....................................... 14, 78
I
Identification plate .....................220
Ignition switch positions .............135
Immobiliser ............................ 31, 95
Indicators ...................................... 84
Info display ................................. 101
Information displays...................... 97
Initial drive information.................... 6 Instrument panel fuse box .........192
Instrument panel illumination control .................................... 123
Instrument panel overview ........... 10
Interior care ............................... 216
Interior lighting ............................ 123
Interior lights .............................. 123
Interior mirrors .............................. 33
Interruption of power supply ......145
Introduction .................................... 3
ISOFIX child restraint systems ....57
J
Jump starting ............................. 210K
Key, memorised settings ..............24
Keys ............................................. 20
Keys, locks ................................... 20
L Lane departure warning .......94, 165
Lashing eyes ............................... 73
Lighting features .........................124
Light switch ................................ 115
Load compartment ................29, 71
Load compartment cover .............73
Load compartment fuse box ......194
Loading information .....................74
Low fuel ....................................... 95
M
Malfunction indicator light ............93
Manual anti-dazzle ......................33
Manual mode ............................. 144
Manual transmission .................. 146
Manual windows ..........................34
Memorised settings ......................24
Midlevel display ............................ 97
Mirror adjustment ........................... 8
Misted light covers .....................123
N New vehicle running-in ..............134
Number plate light .....................189O
Object detection systems ...........158
Odometer ..................................... 84
Oil, engine .......................... 218, 222
OnStar ........................................ 109
Outside temperature ....................80
Overrun cut-off ........................... 138
P Parking ................................ 19, 140
Parking assist ............................ 158
Parking brake ............................ 148
Particulate filter ........................... 142
Performance .............................. 227
Performing work ........................179
Pollen filter ................................. 131
Power button .............................. 135
Power outlets ............................... 83
Power steering fluid ....................181
Power windows ............................ 35
Preheating ................................... 94
Puncture ..................................... 206
R Radio Frequency Identification (RFID) ..................................... 238
Radio remote control ...................21
Reading lights ............................ 124
Rear carrier system ......................61
Rear floor storage cover ..............73
Rear fog light ....................... 96, 122