
184Vehicle careSidelight/Daytime running light
Sidelight and daytime running lights
are designed as LEDs. In case of
failure, have LEDs replaced by a
workshop.
Fog lights
The bulbs are accessible from the
underside of the vehicle.
1. Turn the bulb holder anticlockwise
and remove it from the reflector.
2. Disengage the bulb holder from the plug connector by pressing
the retaining lug.
3. Remove and replace the bulb holder with bulb.
4. Attach the plug connector.
5. Insert the bulb holder into the reflector.
6. Turn the bulb holder clockwise and engage.
Front turn signal lights
1. Rotate the bulb holder anticlockwise and remove it.

Vehicle care185
2. Rotate bulb anticlockwise andremove from bulb holder.
3. Replace bulb.
4. Insert the bulb holder into the reflector and rotate clockwise.
Tail lights
1. Release the cover and remove it.
2. Unscrew the two plastic securing nuts from the inside by hand.
3. Carefully withdraw the lightassembly from retaining pins and
remove. Make sure that the cable duct remains in position.
4. Detach the wiring plug from the bulb carrier.

Vehicle care1872. Press the retaining lug andremove the bulb carrier
downwards.
3. To replace the reverse light bulb (1 ), remove and replace the bulb.
To replace the tail light/rear fog
light bulb ( 2), push the bulb
slightly into the socket, rotate
anticlockwise, remove and
replace the bulb.
4. Insert the bulb carrier into the retainer.
5. Attach the cover.
6. Switch on the ignition, operate and check all lights.
For replacing the tail light bulb and
reverse light bulb on the right side of
the tailgate frame, proceed in the
same way.
Version with Light Emitting Diode
(LED):
Only the reverse light bulb can be
changed.
1. Open the tailgate and remove the
cover with a screwdriver.
2. Rotate the bulb holder anticlockwise to disengage.
Withdraw the bulb holder.
3. To replace the reverse light bulb, push the bulb slightly into the
socket, rotate anticlockwise,
remove and replace the bulb.
4. Insert bulb holder and turn clockwise.
5. Attach the cover.

188Vehicle careSide turn signal lightsTo replace bulb, remove lamp
housing:
1. On left vehicle side, slide lamp to the front and remove it out of the
front wing with the rear end.
On right vehicle side, slide lamp to
the rear and remove it out of the front wing with the front end.
2. Turn bulb holder anticlockwise and remove from housing.
3. Pull bulb from bulb holder and replace it.
4. Insert bulb holder and turnclockwise.
5. On left side: insert front end into front wing, slide forward and insert
rear end.
On right side: insert rear end into
front wing, slide rearward and
insert front end.
Number plate light
1. Insert screwdriver in recess of the
cover, press to the side and
release spring.

Vehicle care189
2. Remove lamp downwards, takingcare not to pull on the cable.
3. Remove bulb holder from lamphousing by turning anticlockwise.
4. Pull bulb from bulb holder andreplace it.
5. Insert bulb holder into lamp housing and turn clockwise.
6. Insert lamp into bumper and let engage.
Interior lights
Courtesy light, reading lights Have bulbs replaced by a workshop.
Load compartment light
Have bulbs replaced by a workshop.
Instrument panel illumination
Have bulbs replaced by a workshop.Electrical system
Fuses Data on the replacement fuse must
match the data on the defective fuse.
There are three fuse boxes in the
vehicle:
● in the front left of the engine compartment
● in left-hand drive vehicles, in the interior behind the storage
compartment, or, in right-hand
drive vehicles, behind the
glovebox
● behind a cover on the left side of the load compartment
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognized by its melted wire. Do not replace the fuse
until the cause of the fault has been
remedied.
Some functions are protected by
several fuses.
Fuses may also be inserted without existence of a function.

212Vehicle careStoring a replaced wheel in the
spare wheel well using an
extension bar
Use the extension bar placed in the
tool box. Vehicle tools 3 195.
● Turn the wing nut anticlockwise and remove temporary spare
wheel.
● Take the extension bar from the tool box and screw it on the bolt.
● Store the damaged wheel and secure it by turning the wing nut
clockwise.
The floor cover can be placed on the
projecting wheel.
Remove the extension bar before
fitting the spare wheel in the well after renewing or repairing the defective
wheel.9 Warning
Storing a jack, a wheel or other
equipment in the load
compartment could cause injury if they are not fixed properly. During a sudden stop or a collision, loose
equipment could strike someone.
Store jack and tools always in the
respective storage compartments
and secure them by fixing.
Place the damaged wheel always
in the load compartment secured
by the strap or in the spare wheel
well secured by the wing nut.
Temporary spare wheel
Caution
The use of the temporary spare
wheel could affect driveability.
Have the defective tyre renewed
or repaired as soon as possible.
Only mount one temporary spare
wheel. The permissible maximum
speed on the label on the temporary
spare wheel is only valid for the
factory-fitted tyre size.
If your vehicle gets a flat tyre in the
rear while towing another vehicle,
mount the temporary spare wheel in
the front and the full tyre in the rear.
Tyre chains 3 202.
Spare wheel with directional tyre If possible, fit directional tyres such
that they roll in the direction of travel.
The rolling direction is indicated by a
symbol (e.g. an arrow) on the
sidewall.
The following applies to tyres fitted
opposing the rolling direction:
● Driveability may be affected. Have the defective tyre renewed
or repaired as soon as possible
and fit it instead of the spare
wheel.
● Drive particularly carefully on wet
and snow-covered road
surfaces.

245Cigarette lighter ........................... 88
Climate control ............................. 16
Climate control, service ..............137
Climate control systems .............129
Clock............................................. 86
Code ........................................... 106
Collision damage repair ..............240
Control indicators.......................... 92
Control of the vehicle .................139
Controls ........................................ 82
Controls in steering wheel ............82
Convex shape .............................. 29
Coolant ....................................... 175
Coolant and antifreeze ...............221
Coolant temperature gauge ..........90
Coupling ball bar ........................168
Cruise control ....................100, 154
Cupholders .................................. 61
Curtain airbag system .................. 53
Curve lighting.............................. 123
D
Danger, Warnings and Cautions ...4
Dashboard .................................... 10
Daytime running light ..................121
Daytime running lights ...............123
Declaration of conformity ............238
Diesel fuel system bleeding .......179
Diesel particle filter ...............98, 145
Door open .................................. 100Doors............................................ 26
Driver assistance systems ..........154
Driver Information Centre ...........101
Driving characteristics and towing tips .............................. 167
Driving hints ................................ 139
E Electric adjustment ......................29
Electrical system......................... 189
Electric parking brake ...........97, 151
Electric parking brake fault ...........97
Electronic climate control system 132
Electronic driving programmes ..148
Electronic Stability Control.......... 153
Electronic Stability Control and Traction Control system ............98
Electronic Stability Control off....... 98
End-of-life vehicle recovery .......172
Engine compartment fuse box ...191
Engine coolant ........................... 175
Engine coolant temperature gauge ....................................... 90
Engine data ............................... 228
Engine exhaust .......................... 145
Engine identification ...................224
Engine oil ................... 174, 221, 225
Engine oil pressure ......................99
Entry lighting .............................. 127
Event data recorders ..................242Exhaust gases ............................ 145
Exit lighting ................................ 127
Exterior care .............................. 216
Exterior light ................................. 99
Exterior lighting ....................13, 120
Exterior mirrors ............................. 29
F
Fault ........................................... 148
First aid ......................................... 78
First aid kit ................................... 78
Fixed air vents ........................... 137
Flex-Fix system ............................ 64
Fog light ..................................... 100
Fog lights .................... 124, 125, 184
Folding mirrors ............................. 30
Folding tray .................................. 78
Front airbag system .....................52
Front fog lights ........................... 124
Front seats.................................... 37
Front storage ................................ 63
Front turn signal light ..................180
Front turn signal lights ...............184
Fuel............................................. 160
Fuel consumption - CO 2-
Emissions ............................... 165
Fuel for diesel engines ..............160
Fuel for liquid gas operation .......160
Fuel for petrol engines ...............160
Fuel gauge ................................... 90