INSPECTION
Inspect the fuel filter housing and module for
cracks, passage blockages, and other damage. If
damage is found, replacement is mandatory.
It is recommended that you visit a NISSAN dealer
for this service.
INSTALLATION
CAUTION
Do not pre-fill the fuel filter with fuel.
Pre-filling the filter can result in debris
entering the fuel system and damaging
fuel system components.
10. Lubricate the inner seal of the fuel filter ele- ment with petroleum jelly or white lithium
grease.
11. Install a new o-ring on the housing. Lubricate the o-ring with petroleum jelly or white
lithium grease. NOTE:
If you are using a new fuel filter housing
that has not had fuel in it, lubricate the lip
seal at the bottom of the fuel filter element
with petroleum jelly or white lithium grease
before placing it into the housing.
12. Install the fuel filter element into the fuel filter
housing and make sure the four tabs
Fare
properly seated into the four slots
G.
13. Install the fuel filter housing on the module.
Fuel filter housing tightening torque: 21 ft-lb (28 N·m)
14. Connect the wiring harness to the water-in- fuel sensor.
15. Connect the batteries.
16. Prime the fuel system. For additional infor- mation, refer to “Fuel system priming” in this
section.
LDI2897
6-12Do-it-yourself
