2017 NISSAN JUKE heater

CAUTION
.Do not force the USB device into the
USB port. Inserting the USB device
tilted or up-side-down into the port
may damage the port. Make sure
that the USB device is connected
correctly into the USB port.
. Do not grab the USB port cover (if
so equipped) when pulling the USB
device out of the port. This could
damage the port and the cover.
. Do not leave the USB cable in a
place where it can be pulled unin-
tentionally. Pulling the cable may
damage the port.
Refer to your device manufacturer’s owner
information regarding the proper use and care
of the device.
To connect an iPod
Što the vehicle so that the
iPodŠcan be controlled with the audio system
controls and display screen, use the USB port
located on the lower center of the instrument
panel. Connect the iPod
Š-specific end of the
cable to the iPodŠand the USB end of the cable
to the USB port on the vehicle. If your iPodŠ
supports charging via a USB connection, its battery will be charged while connected to the
vehicle with the ignition switch in the ACC or
ON position.
While connected to the vehicle, the iPod
Šmay
only be able to be operated by the vehicle audio
controls.
To disconnect the iPod
Šfrom the vehicle,
remove the USB end of the cable from the
USB port on the vehicle, then remove the cable
from the iPod
Š.
iPodŠis a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility:
The following models are compatible:
. iPod Classic
Š5th generation (firmware
version 1.3.0 or later)
. iPod Classic
Š6th generation (firmware
version 2.0.1 or later)
. iPod Classic
Š6th (6.1) generation (firmware
version 2.0.1 or later)
. iPod Classic
Š6th (6.2) generation (firmware
version 2.0.4 or later)
. iPod Touch
Š2nd generation (firmware ver-
sion 4.2.1 or later)*
. iPod Touch
Š3rd generation (firmware ver-
sion 5.1.1 or later) .
iPod Touch
Š4th generation (firmware ver-
sion 6.1.3 or later)
. iPod Touch
Š5th generation (firmware ver-
sion 6.1.3 or later)
. iPod nano
Š- 2nd generation (firmware
version 1.1.3 or later)
. iPod nano
Š- 3rd generation (firmware
version 1.1.3 or later)
. iPod nano
Š- 4th generation (firmware
version 1.0.4 or later)
. iPod nano
Š- 5th generation (firmware
version 1.0.2 or later)
. iPod nano
Š- 6th generation (firmware
version 1.2 or later)
. iPod nano
Š- 7th generation (firmware
version 1.2 or later)
. iPhone
Š3G (firmware version 4.2.1 or later)
. iPhoneŠ3GS (firmware version 5.1.1or
later)
. iPhone
Š4 (firmware version 6.1.3 or later)
. iPhoneŠ4S (firmware version 6.1.3 or later)
. iPhoneŠ5 (firmware version 6.1.3 or later)
* Some features of this iPodŠmay not be fully
functional.
Make sure that your iPod
Šfirmware is updated
to the version indicated above.
Heater, air conditioner, audio and phone systems4-69

4-70Heater, air conditioner, audio and phone systems
JVH0746X
Audio main operation:
Place the ignition switch in the ACC or ON
position. Push the AUX button repeatedly to
switch to the iPod
Šmode.
If the system has been turned off while the iPodŠ
was playing, pushing the ON·OFF button will
start the iPodŠ.
AUX button:
When the AUX button is pushed with the system
off and the iPod
Šconnected, the system will turn
on. If another audio source is playing and the
iPod
Šis connected, push the AUX button
repeatedly until the center display changes to
the iPod
Šmode.
JVH0747X
Interface:
The interface for iPodŠoperation shown on the
vehicle’s audio system display screen is similar
to the iPod
Šinterface. Use the touch-screen,
BACK button or the TUNE knob to navigate the
menus on the screen.
When the iPod
Šis playing, touch the “Menu”
key to bring up the iPodŠinterface.
Depending on the iPodŠmodel, the following
items may be available on the menu list screen.
For further information about each item, see the
iPod
ŠOwner’s Manual.
. Playlists .
Artists
. Albums
. Genres
. Songs
. Composers
. Audiobooks
. Podcasts
Shuffle and repeat play mode:
While the iPod
Šis playing, the play pattern can
be altered so that songs are repeated or played
randomly.
. Shuffle:
Touch the “Shuffle” key to apply a random
play pattern to the iPod
Š. When the Shuffle
mode is active, the text is highlighted. To
cancel Shuffle mode, touch the “Shuffle” key
again until the text is no longer highlighted.
. Repeat:
Touch the “Repeat” key to apply a repeat
play pattern to the iPod
Š. When the repeat
mode is active, the text is highlighted. To
cancel Repeat mode, touch the “Repeat”
key again until the text is no longer high-
lighted.
Seek button:
Push the seek button
orto skip
backward or forward one track.

Push and hold the seek buttonorfor
1.5 seconds while a track is playing to reverse or
fast forward the track being played. The track
plays at an increased speed while reversing or
fast forwarding. When the button is released,
the track returns to normal play speed.
JVH0748X
Scrolling menus:
While navigating long lists of artists, albums or
songs in the music menu, it is possible to scroll
the list by the first character in the name. To
activate character indexing, touch the “A-Z” key
in the upper right corner of the screen. Turn the
TUNE knob to choose the number or letter to
jump to in the list and then push the AUDIO
button.
BluetoothŠstreaming audio
If you have a compatible BluetoothŠaudio
device that is capable of playing audio files,
the device can be connected to the vehicle’s
audio system so that the audio files on the
device play through the vehicle’s speakers.
Heater, air conditioner, audio and phone systems4-71

4-72Heater, air conditioner, audio and phone systems
JVH0735X
Connecting BluetoothŠaudio:
To connect your BluetoothŠaudio device to the
vehicle, follow the procedure below:
1. Push the
button.
2. Touch the “Settings” key.
3. Touch the “Phone & Bluetooth” key.
JVH0750X
4. Touch the “Connect New Device” key.
5. The system acknowledges the command and asks you to initiate connecting from the
phone handset. The connecting procedure
of the cellular phone varies according to
each cellular phone model. See the cellular
phone Owner’s Manual for details. You can
also visit www.nissanusa.com/bluetooth for
instructions on connecting NISSAN recom-
mended cellular phones.
Audio main operation:
To switch to the Bluetooth
Šaudio mode, push
the AUX button repeatedly until the BluetoothŠ
audio mode is displayed on the screen. The controls for the Bluetooth
Šaudio are
displayed on the screen.

SAA0451
CD/USB MEMORY CARE AND
CLEANING
CD
.Handle a CD by its edges. Never touch the
surface of the disc. Do not bend the disc.
. Always place the discs in the storage case
when they are not being used.
. To clean a disc, wipe the surface from the
center to the outer edge using a clean, soft
cloth. Do not wipe the disc using a circular
motion.
Do not use a conventional record cleaner or
alcohol intended for industrial use. .
A new disc may be rough on the inner and
outer edges. Remove the rough edges by
rubbing the inner and outer edges with the
side of a pen or pencil as illustrated.
USB memory
.Do not touch the terminal portion of the USB
memory.
. Do not place heavy objects on the USB
memory.
. Do not store the USB memory in very humid
locations.
. Do not expose the USB memory to direct
sunlight.
. Do not spill any liquids on the USB memory.
Refer to the USB memory Owner’s Manual for
the details.
SAA3383
1. SOURCE select switch
2. Tuning switch
3. VOLUME control switch
STEERING WHEEL SWITCH FOR
AUDIO CONTROL
The audio system can be operated using the
controls on the steering wheel.
SOURCE select switch
Push the SOURCE select switch to change the
mode to available audio source.
Heater, air conditioner, audio and phone systems4-73

4-74Heater, air conditioner, audio and phone systems
VOLUME control switch
Push up or down the VOLUME control switch to
increase or decrease the volume.
Tuning switch
AM and FM radio:
.Push the tuning switch for less than 1.5
seconds to change the next or previous
radio preset.
. Push the tuning switch for more than 1.5
seconds to seek the next or previous radio
station.
SXM operation (if so equipped):
. Tilt up/down for less than 1.5 seconds to
increase or decrease the preset station.
. Tilt up/down for more than 1.5 seconds to
go to the next or previous category.
iPod
Š:
. Push the tuning switch for less than 1.5
seconds to return to the beginning of the
present program or skip to the next program.
Push several times to skip back or skip
through programs.
. This system searches for the blank intervals
between selections. If there is a blank
interval within one program or there is no
interval between programs, the system may not stop in the desired or expected location.
CD:
. Push the tuning switch for less than 1.5
seconds to return to the beginning of the
present program or skip to the next program.
Push several times to skip back or skip
through programs.
. This system searches for the blank intervals
between selections. If there is a blank
interval within one program or there is no
interval between programs, the system may
not stop in the desired or expected location.
. Push the tuning switch for more than 1.5
seconds to change the folders (if there are
any folders) .
USB:
. Push the tuning switch for less than 1.5
seconds to return to the beginning of the
present program or skip to the next program.
Push several times to skip back or skip
through programs.
. This system searches for the blank intervals
between selections. If there is a blank
interval within one program or there is no
interval between programs, the system may
not stop in the desired or expected location.
. If there are any folders, push the tuning
switch for more than 1.5 seconds to change the folders (if so equipped) .
Bluetooth
ŠAudio operation:
. Tilt up/down for less than 1.5 seconds to
skip ahead or back to the next song.
. Tilt up/down for more than 1.5 seconds to
reverse or fast forward the current track.

SAA2102
Type A (if so equipped)
SAA2374Type B (if so equipped)
ANTENNA
To remove the antenna, hold the bottom of the
antenna and turn it counterclockwise.
To install the antenna, turn the antenna clock-
wise and tighten.
CAUTION
.To avoid damaging or deforming the
antenna, be sure to fold down (if so
equipped) or remove the antenna
under the following conditions.
— The vehicle enters a garage with
a low ceiling.
— The vehicle is covered with a car cover.
. Be sure that antenna is removed
before the vehicle enters an auto-
matic car wash.
. Always properly tighten the antenna
rod during installation. Otherwise,
the antenna rod may break during
vehicle operation. This vehicle is equipped with Smartphone
Integration technology. This allows many com-
patible Smartphone applications to be displayed
and easily controlled through the vehicle’s
touchscreen.
NOTE:
A compatible smartphone and registration
is required to use mobile applications or to
access connected features of certain vehi-
cle applications.
REGISTERING WITH NISSANCON-
NECTSMAPP
To use the Smartphone Integration feature, it is
necessary for the user to register. In order to
register, visit the NissanConnect
SMwebsite and
sign up or create an account through the
prompts on the NissanConnect
SMApp. Once
registered, download the NissanConnectSMApp
from your compatible phone’s application down-
load source and then log into the application. If
you already have an account created through
the App, please log in.
NissanConnect
SMwebsite:
For U.S.
www.nissanusa.com/connect/
For Canada
Canada.NissanConnect.com
Heater, air conditioner, audio and phone systems4-75
NISSANCONNECTSMAPP
SMARTPHONE INTEGRATION

4-76Heater, air conditioner, audio and phone systems
CONNECT PHONE
To use this feature, a compatible smartphone
must be connected via BluetoothŠor USB to
the vehicle. For more information on connecting
your phone, see “Bluetooth
ŠHands-Free Phone
System (models without navigation system)”
(P.4-80) or “Bluetooth
ŠHands-Free Phone
System (models with navigation system)” (P.4-
89) .
NOTE:
. For Apple iPhones
Š, NissanConnectSM
Apps REQUIRES the phone to be
plugged in via USB.
. For Android phones, NissanConnect
SM
Apps REQUIRES the phone to be
paired via BluetoothŠ.
APPLICATION DOWNLOAD
Once connected, the NissanConnectSMApp
will search your phone to determine which
compatible applications are currently installed.
The user will then choose which apps they want
to bring into their vehicle from the list of apps
within the “Manage My Apps” section of the
NissanConnect
SMApp on their smartphone. The
vehicle will then download the in-vehicle inter-
face for each of these compatible applications.
Once downloaded, the user can access their
selected smartphone applications through the
vehicle touchscreen. For more information on application availability see NissanConnect
SM
website.
NissanConnectSMwebsite:
For U.S.
www.nissanusa.com/connect/
For Canada
www.Nissan.ca/NissanConnect (English)
www.Nissan.ca/NissanConnect/fr (French)
GENERAL INFORMATION
Apple SiriŠEyes Free personal assistant can be
accessed from the vehicle. SiriŠEyes Free can
be accessed in SiriŠEyes Free mode to reduce
user distraction. In this mode, SiriŠEyes Free is
available for interaction by voice control. After
connecting a compatible Apple device by using
Bluetooth
Š, SiriŠEyes Free can be activated
using theTALK switch on the steering
wheel.
Siri
Šis a trademark of Apple Inc., registered in
the U.S. and other countries.
INFO:
. Some Siri
ŠEyes Free functions, such as
opening apps, may not be available during
driving.
. For best results, always update your device
to the latest software version.
. Keep the interior of the vehicle as quiet as
possible. Close the windows to eliminate the
surrounding noises (traffic noises, vibration
sounds, etc.) , which may prevent the system
from recognizing the voice commands cor-
rectly.
. For functions that can be used in Siri
ŠEyes
Free, please refer to the Apple website.
SIRIŠEYES FREE