2017 MERCEDES-BENZ SLC transmission

Do not start the vehicl eu si ng ar apid charging device. If your vehicle's battery is discharged, the
engine can be jump-started fro ma nothe rv ehicl eorf ro mas econd battery using jumpe rc ables.
Observe the following points: R
The battery is not accessible in al lv ehicles. If the othe rv ehicle's battery is not accessible ,j ump-
start the vehicl eu si ng as econd battery or aj ump-starting device.R
Yo um ay onl yj ump-star tt he vehicl ew he nt he engine and exhaust system ar ec old.R
Do not start the engine if the battery is frozen. Let the battery tha wf irst.R
Onl yj ump-star tf ro mb at teries with a12Vv oltag er at ing.R
Onl yu se jumpe rc able sw hi ch have as uf ficient cross-sectio na nd insulate dt ermina lc lamps.R
If the battery is full yd is charged, leav et he battery tha ti sb ei ng used to jump-star tc onnected for
af ew minute sb ef or ea ttempting to start. Thi sc harge st he battery slightly.R
Make sure tha tt he two vehicles do not touch.
Make sure that: R
The jumpe rc able sa re not damaged.R
Bar ep ar ts of the termina lc lamp do not come into contact with othe rm eta lp ar ts whil et he jumper
cable sa re connected to the battery.R
The jumpe rc able sc anno tc ome into contact with parts which can mov ew he n t he engine is
running ,s uc hast he V-bel tp ulle yort he fan.X
Secure the vehicl ebya pplyin gt he electri cp ar kin gb rake.X
Shift the transmission to position P .X
Make sure tha tt he ignition is switched off .A ll indicator lamps in the instrument cluster must be
off .W he nu si ng the SmartKey, tur nt he SmartKe ytop osit ion 0 in the ignition lock and remove it
( Y
page 115).X
Switch off al le le ctrical consumers ,e .g .r ea rw in do wd ef roster ,l ig hting, etc.X
Open the hood.
Positio nn umber

wise be locked out when pushin gort owing the
vehicle.
Installing/removing th et owing eye
Installing th et owing eye
G WARNING
The exhaust tail pipe may be ver yh ot .T her ei s
ar isk of burn sw hen removin gt he rear cover.
Do not touc ht he exhaust pipe. Take particular
car ew hen removin gt he rear cover.
The bracket sf or th es crew-in towing eye are
located in th eb umpers. They are at th ef ront and
at th er ear ,b ehin dt he covers.X
Remov et he towing eye fro mt he vehicle tool
kit ( Y
page 241).X
Pres st he mark on cover C inwards in the
directio noft he arrow.X
Take cover C off th eo pening.X
Screw in th et owing eye clockwis easf ar as it
will go and tighten it.
Removing th et owing eyeX
Unscrew and remove th et owing eye.X
Attac hc over C to th eb umper and pres su ntil
it engages. X
Place th et owing eye in th ev ehicle too lk it. Towing av ehicle with both axles on
th eg round
G WARNING
You can no longer steer th ev ehicle if the
steerin gw heel lock has been engaged. There
is ar isk of an accident.
Always switch off th ei gnitio nw hen towing the
vehicle with at ow cable or at ow bar.
The automatic transmission automatically shifts
to position P when you open th ed river's or front-
passenger door or when you remove th eS ma rt-
Key fro mt he ignitio nl ock.
In orde rtoe nsure that th ea utomatic transmis-
sion stays in position N when towing th ev ehicle,
you must observe th ef ollowing points:X
Switch on th eh azar dw arning lamps
( Y
page 95). X
Turn th eS ma rtKey to position 2 in th ei gnition
lock.
On vehicles with KEYLESS-GO, use th eS ma rt-
Key instead of th eS ta rt/Stop button
( Y
page 115). X
Depress and hold th eb rak ep edal.X
Shif tt he transmission to position N .X
Release th eb rak ep edal.X
Release th ee lectric parking brake. X
Leave th eS ma rtKey in position 2 in th ei gni-
tio nl ock.
In orde rtos ignal ac hange of directio nw hen
towing th ev ehicle with th eh azar dw arning
lamps switche do n, use th ec ombination switch
as usual. In this case ,o nly th ei ndicator lamps
for th ed irectio noft ra vel flash .W hen you reset
th ec ombination switch, th eh azar dw arning
flashers start flashing again.
It is importan tt ha ty ou observe th es afety
instructions when towing away your vehicle
( Y
page 251).
Towing th ev ehicle with th er ea ra xle
raised
! The ignitio nm ust be switche do ff if you are
towing th ev ehicle with th er ear axle raised.
Interventio nbyE SP ®
could otherwise dam-
age th eb rak es ystem.252
Towing and tow-starting
Breakdown assistance

! Vehicles with automatic transmission must
not be towed with the rear axle raised. The
vehicle/trailer combination may otherwise
swerve or even roll over.
Transporting the vehicle
Vehicle sw ith automatic transmission
! When the vehicle is loade df or transport, the
front and rear axles must be stationary and on
the same transportation vehicle. Positioning
over the connection point of the transport
vehicle is not permitted. The drive train may
otherwise be damaged.
All vehicles
! You may only secure the vehicle by the
wheels, not by parts of the vehicle such as
axle or steering components. Otherwise, the
vehicle could be damaged.
The towing eye can be used to pull the vehicle
onto at railer or transporter for transporting pur-
poses. X
Turn the SmartKey to position 2 in the ignition
lock. X
Shift the transmission to position N .
As soon as the vehicl eh as been loaded:X
Prevent the vehicle from rolling awa yb y
applying the electric parking brake. X
Shift the transmission to position P .X
Turn the SmartKey in the ignition lock to posi-
tion 0 and remove the SmartKey from the
ignition lock. X
Secure the vehicle. Tow-starting (emergenc ye ngine
starting)
! Vehicles with automatic transmission must
not be tow-started. You could otherwise dam-
age the automatic transmission.
You can find information on "Jump-starting" at
( Y
page 249).
Fuses
Important safety notes
G WARNING
If you manipulate or bridge af aulty fuse or if
you replace it with af use with ah igher amper-
age, the electric cables could be overloaded.
This could result in af ire. There is ar isk of an
accident and injury.
Alway sr eplace faulty fuses with the specified
new fuses having the correct amperage.
Blown fuses must be replaced with fuses of the
same rating, which you can recognize by the
color and value .T he fuse ratings are listed in the
fuse allocation chart.
The fuse allocation chart is located in the vehicle
tool kit in the stowage compartment under the
trunk floor ( Y
page 241).
If an ewly inserted fuse also blows, have the
cause traced and rectified at aq ualified special-
ist workshop, e.g. an authorized Mercedes-Benz
Center.
! Only use fuses that have been approved for
Mercedes-Benz vehicles and which have the
correct fuse rating for the system concerned.
Otherwise, component sors ystems could be
damaged.
! Make sure that no moisture can enter the
fuse box when the cover is open.
! When closing the cover, make sure that it is
lying correctly on the fuse box. Moisture seep-
ing in or dirt could otherwise impair the oper-
ation of the fuses.
The fuses in your vehicle serve to close down
faulty circuits. If af use blows, all the compo-
nent sont he circuit and their functions stop
operating. Fuses 253
Breakdown assistance Z

An arrow on the sidewall of the tire indicates its
correct direction of rotation.
Storin gw heelsStore wheels tha ta re not being used in ac ool,
dry and preferably dark place .P rotect the tires
from oil, grease, gasoline and diesel.
Mounting aw heel
Preparin gt he vehicleX
Stop the vehicl eons olid ,n on-slippery and
level ground. X
Apply the electri cp ar king brake manually.X
Bring the front wheels into the straight-ahead
position. X
Shift the transmission to position P .X
Switch off the engine. X
Vehicles withou tK EYLESS -GO: remove the
SmartKe yf rom the ignition lock.X
Vehicles with KEYLESS-GO: open the driv-
er' sd oo r.
The vehicl ee le ctronics now have status 0 .
Thi sist he same as the SmartKe yh av ing been
removed. X
Vehicles with KEYLESS-GO: remove the
Start/Stop button from the ignition lock
( Y
page 115). X
If included in the vehicl ee quipment ,r emove
the tire-change tool kit from the vehicle. X
Safeguar dt he vehicl ea gain st rolling away.
i Due to difference sinv ehicl ee quipment ,n ot
al lv ehicles ar ee quippe dw it hat ire-change
tool kit. For informatio nonw hi ch tool sa re
required to perfor maw heel change on your
vehicle, consult an authorize dM ercedes-
Benz Center.
Necessary tire-changing tool sc an include, for
example: R
Jack R
Wheel chock R
Lu gw rench Securin gt he vehicle to preven titf rom
rolling away
If your vehicl eise quippe dw it haw heel chock, it
can be found in the tire-change tool kit
( Y
page 241).
The folding whee lc hoc ki sana ddit ional safety
measure to prevent the vehicl ef rom rolling
away ,f or exampl ew he nc hanging aw heel .X
Fol db ot hp la te su pwar ds C .X
Fol do ut lowe rp la te D .X
Guid et he lugs on the lowe rp la te full yi nto the
openings in base plate

Deviations with respect to frequency bands,
maximum transmission outputs or antenna
positions must be approved by Mercedes-Benz.
The maximum transmission outpu t( PE AK) at the
base of the antenna must not exceed the fol-
lowing values:
Frequenc yb and Maximum
transmission
output
Short wave
3-54M Hz 100 W
4mw av eband
74 -88M Hz 30 W
2mw av eband
144 -1 74 MHz 50 W
Trunked radi os ys tem/
Tetra
380 -4 60 MHz 10 W
70 cm waveband
400 -4 60 MHz 35 W
Mobil ec ommunications
(2G/3G/4G) 10 W
The following can be used in the vehicl ew it hout
restrictions: R
RF transmitters with am ax imum transmis-
sion outpu tofu pt o1 00 mWR
RF transmitters with transmitter frequencies
in the 380 -4 10 MHz waveband and am ax i-
mu mt ransmission outpu tofu pto2 W
(trunked radio/Tetra) R
Mobil ep ho ne s( 2G/3G/4G)
There ar enor estrictions when positioning the
antenna on the outside of the vehicl ef or the
following wavebands: R
Trunked radi os ys tem/TetraR
70 cm waveband R
2G/3G/4G Identificatio np lates
Vehicle identificatio np late with vehi-
cl ei dentificatio nn umber (VIN) X
Open the driver's door.
Yo uw il ls ee vehicl ei de ntification plate C .
Example: vehicl ei de ntification plate (USA only)
C
VIN D
Vehicl em odel
Example: vehicl ei de ntification plate (Canada only)
C
VIN
D
Paint code
i The data shown on the vehicl ei de ntification
plate is used onl yasane xample. Thi sd at ai s
different for every vehicl ea nd can deviateIdentificatio np lates 283
Technica ld ata Z