2017 MERCEDES-BENZ SLC-Class mirror

When indicator lamp:flashes green: pro-
gramming was successful. The next step is to
synchronize the rolling code.
XRelease button Bof remotec ontrolAof the
garage door drive.
If indicator lamp :lights up red: repeat the
programmingp rocess for the corresponding
button on the rear-view mirror. When doing
so, vary the distanc ebetween remotec ontrol
A and the rear-view mirror.
The required distanc ebetween remotec on-
trol Aand the integrated garage door opener
depends on the garage door drive system.
Several attempts might be necessary. You
should test every position for at least
25 seconds before trying another position.
Problems when programming
If you are experiencing problems programing
the integrated garage door opener on the rear-
view mirror, take not eofthe following instruc-
tions:
RCheck the transmitter frequenc yused by
garage door drive remotec ontrolAand
whether it is supported. The transmitter fre-
quency can usually be found on the back of
remotec ontrolAfor the garage door drive.
The integrated garage door opener is com-
patible with devices that have units which
operate in the frequenc yrange of 280 to
433 MHz.
RReplace the batteries in garage door remote
control A.This increases the likelihood that
garage door remotec ontrolAwill transmit a
stron gand precise signal to the integrated
garage door opener.
RWhen programming, hold remotec ontrolA
at varying distances and angles and from but-
tons ;to? which you are programming. Try
various angles at adistanc ebetween 2and
8i nches (5to 20 cm) or at the same angle but
at varying distances.
RIf another remotec ontrolAis available for
the same garage door drive, repeat the same
programmings teps with this remotec ontrol
A.B eforep erforming these steps, make sure
that new batteries have been installed in
garage door drive remotec ontrolA.
RNote that some remotec ontrols only transmit
for alimited amount of time (the indicator
lamp on t
he remotec
ontrol goes out). Press button
Bon remotec ontrolAagain before
transmission ends.
RAlign the antenna cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performst he function of the
garage door system remotec ontrol. Please also
read the operating instruction sfor the garage
door system.
XTurn the SmartKey to position 2in the ignition
lock (Ypage 115).
XPress buttons ;,=or? which you have
programmed to operate the garage door.
Garage door system with afixed code: indi-
cator lamp :lights up green.
Garage door system with arolling code: indi-
cator lamp :flashes green.
The transmitter will transmit asignal as long
as the button is pressed. The transmission is
halted after amaximum of ten seconds and
indicator lamp :lights up yellow.
XPress button ;,=or? again if necessary.
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling the
vehicle.
XTurn the SmartKey to position 2in the ignition
lock (Ypage 115).
XPress and hold buttons ;and ?.
The indicator lamp initially lights up yellow
and then green.
XRelease buttons ;and ?.
The memory of the integrated garage door
opener in the rear-view mirror is cleared.
228Features
Stowage and features

Do not usepower washers with circular jet
nozzles to clean the vehicle. Hav edamaged
tire sorc hassiscomponents replaced imme-
diately.
!Do not us eacidi cwheel cleaning products
to remove brake dust. Thi scould damage
whee lbolts and brake components.
!Do not park your vehicl efor alon gp eriodo f
time directl yafter cleaning, particularly after
cleaning the whee lrim with whee lcleaner.
Whee lcleane rcan lead to the increased cor-
rosio nofthe brake discs and pads .Therefore,
drive for afew minute safter cleaning. By
heating up the brakes ,the brake discs and
pads dry .The vehicl ecan thenb eparked for a
long perio doftime.
Cleanin gthe windows
GWARNING
Yo uc ould become trapped by the windshield
wipers if theys tart moving whil ecleaning the
windshiel dorwiperblades. There is arisko f
injury.
Alway sswitch off the windshiel dwiper sand
the ignition befor ecleaning the windshiel dor
wipe rblade s.
!Do not us edry cloths, abrasive products,
solvents or cleaning agents containing sol-
vents to clean the insid eofthe windows .Do
not touch the insides of the windows with
hard objects ,e.g.ani ce scrape rorring. There
is otherwis eariskofd amagin gthe windows.
!Clea nthe water drainage channel softhe
windshiel dand the rea rwindo watr egular
intervals .Deposits such as leaves, petal sand
pollen mayu nder certain circumstances pre-
vent water fromd raining away.Thisc an lead
to corrosion damage and damage to elec-
troni ccomponents.
XClea nthe insid eand outside of the windows
with adam pcloth and acleaning product that
is recommende dand approved by Mercedes-
Benz.
Cleanin gwiper blades
GWARNING
Yo uc ould become trapped by the windshield
wipers if theys tart moving whil ecleaning the
windshiel dorwiperblades. There is arisko f
injury.
Alway sswitch off the windshiel dwiper sand
the ignition befor ecleaning the windshiel dor
wipe rblade s.
!Do not pull the wipe rblade .Otherwise, the
wipe rblade could be damaged.
!Do not clean wipe rblade stoo ofte nand do
not rubt hemtoo hard. Otherwise, the graph-
ite coating could be damaged. Thi scould
cause wipe rnoise.
!Hol dthe wipe rarm securel ywhenf olding
back. The windshiel dcould be damage difthe
wipe rarm smacks against it suddenly.
XFoldthe windshiel dwiper arms away fromt he
windshield.
XCarefully clean the wipe rblade swithad amp
cloth.
XFol dthe windshiel dwiper arms back again
befor eswitching on the ignition.
Cleanin gthe exterior lighting
!Onlyu secleaning agents or cleaning cloths
which ar esuitabl efor plastic light lenses.
Unsuitabl ecleaning agents or cleaning cloths
could scratch or damage the plastic light len- ses.
XClea nthe plastic lensesoft he exteriorlights
with awetspong eand am ildc leaning agent,
e.g .M ercedes-Benz car shampo oorcleaning
cloths.
Cleanin gthe mirrort urn signals
!Onlyusecleaning agents or cleaning cloths
thata resuitabl efor plastic lenses. Unsuitable
cleaning agents or cleaning cloths could
scratch or damage the plastic lensesoft he
mirror tur nsignals.
XClea nthe plastic lensesoft he mirror turnsig-
nal sint he exterio rmirror housing using awet
spong eand mil dcleaning agent, e.g.
Care239
Maintenance and care
Z

The vehicle will then use very little energy, thus
conserving battery power.
If the power supply has been interrupted, e.g. ifyou reconnect the battery, you will have to:
Rreset the function for automatically folding
the exterior mirrors in/out by folding the mir-
rors out once (
Ypage 89)
Rset the clock (see the Digital Operator's Man-
ual)
On vehicles with amultimedia system, the
time is set automatically.
Charging the battery
GWARNING
During charging and jump-starting, explosive
gases can escape from the battery. There is a risk of an explosion.
Particularly avoid fire, open flames, creating
sparks and smoking. Ensure there is sufficient
ventilation while charging and jump-starting.
Do not lean over abattery.
GWARNING
Battery acid is caustic. There is arisk of injury.
Avoid contact with skin, eyes or clothing. Do
not inhale any battery gases. Do not lean over
the battery. Keep children away from batter-
ies. Wash away battery acid immediately with
plenty of clean water and seek medical atten-
tion.
GWARNING
Ad ischarged battery can freeze at tempera-
tures below freezin gpoint. When jump-start-
ing the vehicle or charging the battery, gases can escape from the battery. There is arisk of
an explosion.
Allow the frozen battery to thaw out before
charging it or jump-starting.
!Only use battery chargers with amaximum
charging voltage of 14.8 V.
!Only charge the battery using the jump-
starting connection point.
The jump-starting connection point is in the
engine compartment. If the indicator/warning lamps do not light up at
low temperatures, it is very likely that the dis-
charged battery has frozen. In this case, you
may neither charge the battery nor jump-start
the vehicle. The service life of
athawed-out bat-
tery may be shorter .The starting characteristics
can be impaired, particularly at low tempera-
tures. Have the thawed-out battery checked at a
qualified specialist workshop.
Read the battery charger's operating instruc-
tions before charging the battery.
XOpen the hood.
XConnectt he battery charger to the positive
terminal and ground point in the same order
as when connectin gthe donor battery in the
jump-starting procedure (
Ypage 249).
248Battery (vehicle)
Breakdown assistance

Refrigerant instructionlabel
Example:refrigerant instruction label
:
Warning symbol
;Refrigerant filling capacity
=Applicabl estandards
?PAG oilp artn umber
AType of refrigerant
Warning symbol :advises yo uabout:
RPossible dangers
RHaving service work carrie doutataq uali fied
specialist workshop
Fillin gcapacities
Missing value sweren ot available at time of
going to print.
ModelRefrigerant
Mercedes ‑Benz
SLC43A MG
Allo the rm odels19.4 ±0.4 oz
(550 ±10g )
ModelPAG oil
Mercedes‑Benz
SLC 43 AMG
All other models2.8 oz
(80 g)
Vehicl edata
General notes
Please note thatf or the specified vehicl edata:
Rthe heights specified mayv aryasar esultof
-tires
-load
-condition of the suspension
-optional equipment
Roptional equipment reduce sthe maximum
payload.
Dimension sand weights
Model:Opening height
Mercedes ‑Benz
SLC43A MG70.7 in
(1796 mm)
Al lo the rm odels70.5 in
(1790 mm)
Missing value sweren ot available at time of
going to print.
Mercedes ‑Benz
SLC43A MG
Vehiclelengt h162.7 in (4133 mm)
Vehicl elengt h
when opening/clos-
in gt he roof
Vehicl ewidth
includin gexterior
mirrors
Vehicl eheight51.3 in (130 4mm)
Vehicl edata289
Technica ldata
Z

Mercedes‑Benz
SLC 43 AMG
Vehicle height,
whe nopening/clos-
ing the roof61.7 in (1566 mm)
Wheelbase95.7 in (2432 mm)
Turning radius
Maximum trunk
load220 lb (100 kg)
All other models
Vehicle length162.7 in (4133 mm)
Vehicle length
whe nopening/clos-
ing the roof170.2 in (4324 mm)
Vehicle width
includin gexterior
mirrors79.0 in (2006 mm)
Vehicle height51.1 in (1297 mm)
Vehicle height,
whe nopening/clos-
ing the roof61.2 in (1555 mm)
Wheelbase95.7 in (2430 mm)
Turning radius34.5 ft (10.52 m)
Maximum trunk
load220 lb (100 kg)
290Vehicle data
Technical data