In the vehicle Operator's Manual, information and recommendations can be found on: R
using automatic climate control R
using the rear control panel R
the individual functions
Observe these notes for optimal use of the automatic climate control.
The "Cooling with air dehumidification" function is even available when the engine is not running
( Y
page 17).
Use the residual heat function if you want to heat or ventilate the vehicle interior when the ignition
is switched off. The residual heat function can only be activated or deactivated with the ignition
switched off. When the ignition is switched on, the residual heat function is switched off
( Y
page 17).
Operating the climate control sys-
tems
Switching cooling with air dehumidi-
fication on/off If you deactivate the "Cooling with air-dehumid-
ification" function, the air inside the vehicle will
not be cooled. The air inside the vehicle will also
not be dehumidified. The windows can fog up
more quickly. Therefore, deactivate the cooling
with air-dehumidification function only briefly.
The "Cooling with air dehumidification" function
is available even when the engine is not running.
The air inside the vehicle is cooled and dehu-
midified according to the temperature selected.
Condensation may drip from the underside of
the vehicle when it is in cooling mode. This is
normal and not a sign that there is a malfunc-
tion. X
To activate: press the Z or V button.
The indicator lamp in the Z or V button
lights up. X
To deactivate: press the Z or V but-
ton.
The indicator lamp in the Z or V button
goes out. The "Cooling with air dehumidifica-
tion" function has a delayed switch-off fea-
ture.
Switching the residual heat on or off
It is possible to make use of the residual heat of
the engine to continue heating the stationary
vehicle for up to 30 minutesafter the engine has
been switched off. The heating time depends on
the set interior temperature. X
To activate: press the K or V button.
The indicator lamp in the K or V button
lights up. X
To deactivate: press the K or V but-
ton.
The indicator lamp in the K or V button
goes out.
The blower will run at a low speed regardless of
the airflow setting.
If you activate the residual heat function at high
temperatures, only the ventilation will be acti-
vated. The blower runs at medium speed.
Residual heat is deactivated automatically: R
after approximately 30 minutes R
when the ignition is switched on R
if the battery voltage drops
Pre-entry climate control via Smart-
Key
General notes Before getting in, the vehicle interior can be
briefly warmed or ventilated in advance and the
air from the air vents can be pre-cooled.
The high-voltage battery must be sufficiently
charged before "Pre-entry climate control via
SmartKey" can be activated.
When the vehicle is pre-cooled, the following
functions are activated if required: R
Climate control system R
Blower R
Seat ventilationOperating the climate control systems 17
Climate control
