2017 MERCEDES-BENZ CLA light

[x] Cancel search: light

Page 82 of 318

MERCEDES-BENZ CLA 2017  Owners Manual X
To open: pull remote operating switch �C for
the trunk lid until the trunk lid opens.
Emergency release for the trunk
General notes
! The trunk lid swings upwards when opened.
Therefore, make sure t

Page 83 of 318

MERCEDES-BENZ CLA 2017  Owners Manual body becomes trapped, release the switch or
pull the switch to close the side window again.
G WARNING
While closing the side windows, body parts in
the closing area could become trapped. There
is a ri

Page 85 of 318

MERCEDES-BENZ CLA 2017  Owners Manual On vehicles with a panorama roof with power
tilt/sliding panel: X
Press and hold the �7 button again until the
roller sunblind of the panorama roof with
power tilt/sliding panel closes. X
To interrupt

Page 86 of 318

MERCEDES-BENZ CLA 2017  Owners Manual Problem
Possible causes/consequences and �P Solutions
A side window cannot be
closed because it is
blocked by objects, e.g.
leaves in the window
guide. X
Remove the objects. X
Close the side window.
A

Page 87 of 318

MERCEDES-BENZ CLA 2017  Owners Manual sure fluctuations in the vehicle interior.
Change the position of the sliding sunroof or
open a side window slightly to reduce or elim-
inate these noises.
Sliding sunroof reversing feature In the fol

Page 88 of 318

MERCEDES-BENZ CLA 2017  Owners Manual If contact is made with a roof carrier approved
by Mercedes-Benz, the sliding sunroof lowers
slightly but remains raised at the rear.
Rain-closing feature The rain-closing feature is only available fo

Page 90 of 318

MERCEDES-BENZ CLA 2017  Owners Manual Problems with the panorama roof with power tilt/sliding panel
G WARNING
If you do not reset the sliding sunroof after a malfunction or voltage supply interruption, then the
backing up function will ma

Page 96 of 318

MERCEDES-BENZ CLA 2017  Owners Manual Problems with the seat heating Problem
Possible causes/consequences and �P Solutions
The seat heating has
switched off prematurely
or cannot be switched
on. The on-board voltage is too low because too