2 –13 Essential Safety Equipment
Seat Belt SystemsDo not modify the components or
wiring, or use electronic testing devices
on the pretensioner system:
Modifying the components or wiring
of the pretensioner system, including
the use of electronic testing devices
is dangerous. You could accidentally
activate it or make it inoperable which
would prevent it from activating in an
accident. The occupants or repairers
could be seriously injured.
Properly dispose of the pretensioner
system:
Improper disposal of the pretensioner
system or a vehicle with non-
deactivated pretensioners is
dangerous. Unless all safety
procedures are followed, injury
could result. Have an Authorized
Mazda Dealer safely dispose of
the pretensioner system or scrap a
pretensioner system equipped vehicle.
NOTE
The pretensioner system may not
operate depending on the type of the
collision. For details, refer to the SRS
Air Bag Deployment Criteria (page
2-34 ).
Some smoke (non-toxic gas) will
be released when the air bags and
pretensioners deploy. This does not
indicate a fire. This gas normally has
no effect on occupants, however, those
with sensitive skin may experience
light skin irritation. If residue from
the deployment of the air bags or the
pretensioner system gets on the skin
or in the eyes, wash it off as soon as
possible. Seat Belt Extender If your seat belt is not long enough, even
when fully extended, a seat belt extender
may be available to you at no charge from
your Authorized Mazda Dealer.
This extender will be only for you and for
the particular vehicle and seat. Even if it
plugs into other seat belts, it may not hold
in the critical moment of a crash.
When ordering an extender, only order
one that provides the necessary additional
length to fasten the seat belt properly.
Please contact your Authorized Mazda
Dealer for more information.
WARNING Do not use a seat belt extender unless it
is necessary:
Using a seat belt extender when not
necessary is dangerous. The seat belt
will be too long and not fit properly.
In an accident, the seat belt will not
provide adequate protection and you
could be seriously injured. Only use the
extender when it is required to fasten
the seat belt properly.
MX-5_8FR4-EA-16J_Edition1.indb 13 2016/08/11 20:28:23
6 –33 Maintenance and Care
Owner Maintenance
Wiper BladesCAUTION
Hot waxes applied by automatic car
washers have been known to affect the
wiper's ability to clean windows.
To prevent damage to the wiper blades,
do not use gasoline, kerosene, paint
thinner, or other solvents on or near
them.
When the wiper lever is in the AUTO
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
If the windshield above the rain
sensor is touched.
If the windshield above the rain
sensor is wiped with a cloth.
If the windshield is struck with a hand
or other object.
If the rain sensor is struck with a hand
or other object from inside the vehicle.
Be careful not to pinch hands or fingers
as it may cause injury, or damage the
wipers. When washing or servicing the
vehicle, make sure the wiper lever is in
the OFF position.
Contamination of either the windshield or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.
If the blades are not wiping properly,
clean the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary. Replacing Windshield Wiper
Blades When the wipers no longer clean well, the
blades are probably worn or cracked.
Replace them.
CAUTION To prevent damage to the wiper arms
and other components, do not try to
sweep the wiper arm by hand.
NOTE
When raising both windshield wiper arms,
raise the driver's side wiper arm first.
When lowering the wiper arms, slowly
lower the wiper arm from the passenger's
side first while supporting it with your
hand. Forcefully lowering the wiper arms
could damage the wiper arm and blade,
and may scratch or crack the windshield.
(Type A)
1. Raise the wiper arm.
2. Open the clip and slide the blade
assembly in the direction of the arrow.
MX-5_8FR4-EA-16J_Edition1.indb 33 2016/08/11 20:29:44
6 –68 Maintenance and Care
Appearance Care Plastic Part Maintenance
When cleaning the plastic lenses of the
lights, do not use gasoline, kerosene,
rectified spirit, paint, thinner, highly
acidic detergents, or strongly alkaline
detergents. Otherwise, these chemical
agents can discolor or damage the
surfaces resulting in a significant loss
in functionality. If plastic parts become
inadvertently exposed to any of these
chemical agents, flush with water
immediately.
If plastic parts such as the bumpers
become inadvertently exposed to
chemical agents or fluids such as
gasoline, oil, engine coolant, or battery
fluid, it could cause discoloration,
staining, or paint peeling. Wipe off any
such chemical agents or fluids using a
soft cloth immediately.
High water temperature and high water
pressure car washers are available
depending on the type of high pressure
car washer device. If the car washer
nozzle is put too close to the vehicle or
aimed at one area for an extended period
of time, it could deform plastic parts or
damage the paint.
Do not use wax containing compounds
(polish). Otherwise, it could result in
paint damage.
In addition, do not use an electrical or
air tool to apply wax. Otherwise, the
frictional heat generated could result
in deformation of plastic parts or paint
damage. Interior Care WARNING Do not spray water into the vehicle
cabin:
Spraying water into the vehicle cabin is
dangerous as electrical devices such as
the audio and switches could get wet
resulting in a malfunction or vehicle
fire.
NOTE
Do not wipe the interior using alcohol,
chlorine bleach, or organic solvents
such as thinner, benzene, and gasoline.
Otherwise, it may cause discoloration
or stains.
Rubbing hard with a stiff brush or cloth
may cause damage.
If the vehicle interior becomes soiled
by any of the following, wipe it off
immediately using a soft cloth.
Leaving it uncleaned could cause
discoloration, stains, cracks, or peeling
of the coating, and it will make it hard to
wipe off later.
Beverage or fragrance
Grease or oil
Soiling
Seat Belt Maintenance
1. Clean the soiled area by lightly dabbing
it with a soft cloth soaked in a mild
detergent (approx. 5%) diluted with
water.
2. Wipe off the remaining detergent using
a cloth soaked in clean water and
wrung out well.
3. Before retracting seat belts which have
been pulled out for cleaning, dry them
off thoroughly and make sure there is
no remaining moisture on them.
MX-5_8FR4-EA-16J_Edition1.indb 68 2016/08/11 20:29:53
10 –2 Index
A Accessory Socket .............................. 5-134
Adaptive Front Lighting System
(AFS) ................................................... 4-75
Add-On Non-Genuine Parts and
Accessories
......................................... 8-18
Advanced Key
Advanced keyless entry system
...... 3-8
Operational range
............................ 3-9
Air Bag/Seat Belt Pretensioner System
Warning Beep
...................................... 7-48
Air Bag Systems
................................. 2-24
Ambient Temperature Display
... 4-15, 4-22
Antilock Brake System (ABS)
............ 4-65
Audio Control Switch
Adjusting the volume
.................... 5-55
Seek switch .................................... 5-56
Audio System
...................................... 5-13
AUX/USB mode
........................... 5-57
Antenna
......................................... 5-13
Audio control switch
..................... 5-55
Audio set
[Type A (non-touchscreen)]
........... 5-22
Audio set
[Type B (touchscreen)]
................... 5-34
Operating tips for audio system
.... 5-14
Satellite radio
................................ 5-46
Automatic Transmission
..................... 4-34
Active Adaptive Shift (AAS)
........ 4-36
Direct mode
................................... 4-43
Driving tips .................................... 4-43
Manual shift mode ......................... 4-37
Shift-lock override
........................ 4-36
Shift-lock system
........................... 4-36
Shift position indication
................ 4-35
Transmission ranges
...................... 4-35
Warning light
................................. 4-35B Back Trim Storage Box ..................... 5-139
Battery
................................................. 6-36
Maintenance
.................................. 6-38
Replacement
.................................. 6-38
Specifications
.................................. 9-4
Battery Runs Out
................................. 7-23
Jump-starting
................................. 7-23
Blind Spot Monitoring (BSM)
............ 4-85
Blind Spot Monitoring (BSM) System
Warning Beep
...................................... 7-51
Bluetooth ®
........................................... 5-74
Bluetooth ®
audio (Type A) .......... 5-113
Bluetooth ®
audio (Type B) .......... 5-115
Bluetooth ®
Hands-Free (Type A) ... 5-97
Bluetooth ®
Hands-Free (Type B) ... 5-103
Troubleshooting
.......................... 5-129
Body Lubrication
................................ 6-32
Brakes
Brakes assist
.................................. 4-63
Foot brake ...................................... 4-61
Pad wear indicator
......................... 4-62
Parking brake
................................ 4-62
Warning light
................................. 4-62
Break-In Period
................................... 3-51
C Capacities .............................................. 9-5
Carbon Monoxide
............................... 3-24
Cell Phones
......................................... 8-19
Child Restraint
Child-restraint precautions
............ 2-15
Child-restraint system installation ... 2-20
Installing child-restraint systems ... 2-21
Climate Control System
........................ 5-2
Fully automatic type
........................ 5-9
Gas specifications
............................ 9-6
Manual type
..................................... 5-5
Operating tips
.................................. 5-2
Vent operation
................................. 5-3
Clock
................................................... 5-26
MX-5_8FR4-EA-16J_Edition1.indb 2 2016/08/11 20:30:24