Page 119 of 568

4 –5 When Driving
Start/Stop EngineON
This is the normal running position after
the engine is started. The indicator light
(amber) turns off. (The indicator light
(amber) illuminates when the ignition
is switched ON and the engine is not
running.)
Some indicator lights/warning lights
should be inspected before the engine is
started (page 4-18 ).
NOTE
When the push button start is pressed to
ON, the sound of the fuel pump motor
operating near the fuel tank can be heard.
This does not indicate an abnormality.
Starting the Engine WARNING Radio waves from the key may affect
medical devices such as pacemakers:
Before using the key near people who
use medical devices, ask the medical
device manufacturer or your physician
if radio waves from the key will affect
the device.
NOTE
The key must be carried because the key
carries an immobilizer chip that must
communicate with the engine controls at
short range.
The engine can be started when the
push button start is pressed from off,
ACC, or ON.
The push button start system functions
(function which can start the engine
by only carrying the key) can be
deactivated to prevent any possible
adverse effect on a user wearing a
pacemaker or other medical device. If
the system is deactivated, you will be
unable to start the engine by carrying
the key. Consult an Authorized Mazda
Dealer for details. If the push button
start system functions have been
deactivated, you can start the engine by
following the procedure indicated when
the key battery goes dead.
Refer to Engine Start Function When
Key Battery is Dead on page 4-8 .
MX-5_8FR4-EA-16J_Edition1.indb 5 2016/08/11 20:28:41
Page 128 of 568

4 –14 When Driving
Instrument Cluster and Display NOTE
The temperature unit (Centigrade/
Fahrenheit) of the engine coolant gauge
display changes in conjunction with
the temperature unit of the outside
temperature display.
Refer to Personalization Features on
page 9-9 .
During normal driving, the engine
coolant temperature stabilizes at
100 °C (210 °F) or less, and the gauge
indicates a range lower than 100 °C
(210 °F).
If the engine load increases and the
engine coolant temperature exceeds
100 °C (210 °F), the gauge indicates the
engine coolant temperature. Fuel Gauge (Without Multi-
information Display) The fuel gauge shows approximately
how much fuel is remaining in the tank
when the ignition is switched ON. We
recommend keeping the tank over 1/4 full. Full
1/4 Full
Empty
If the low fuel warning light illuminates or
the fuel level is very low, refuel as soon as
possible.
Refer to Warning Lights on page 4-26 .
NOTE
After refueling, it may require some
time for the indicator to stabilize. In
addition, the indicator may deviate
while driving on a slope or curve since
the fuel moves in the tank.
The display indicating a quarter or less
remaining fuel has more segments to
show the remaining fuel level in greater
detail.
The direction of the arrow ( ) indicates
that the fuel-filler lid is on the left side
of the vehicle.
MX-5_8FR4-EA-16J_Edition1.indb 14 2016/08/11 20:28:44
Page 140 of 568
4 –26 When Driving
Instrument Cluster and Display
*Some models.Warning/Indicator LightsInstrument Cluster varies depending on model and specifications.
Center of Dashboar d
Warning/Indicator lights will appear in any of the highlighted areasType A
(With Multi-information Display) Type B
(Without Multi-information Display)Instrument Cluster
Warning Indication/Warning LightsThese lights turn on or flash to notify the user of the system o peration status or a system
malfunction. Signal Warning Lights Page
Brake System Warning Light *1*2
7-33
Charging System Warning Indication/Warning Light *1
7-33
Engine Oil Warning Light *1
7-33
(Red) High Engine Coolant Temperature Warning Indication/Warning
Light *1
7-33
Power Steering Malfunction Indicator Light *1
7-33*
Master Warning Indication/Warning Light *1
7-36
MX-5_8FR4-EA-16J_Edition1.indb 26 2016/08/11 20:28:47
Page 141 of 568
4 –27 When Driving
Instrument Cluster and Display
*Some models.Signal Warning Lights Page
Electric Vacuum Pump Warning Light *1
7-36
ABS Warning Light *1
Electronic Brake Force
Distribution System
Warning
7-33
ABS warning
7-36
Check Engine Light *1
7-36*
Automatic Transmission Warning Indication/Warning Light *1
7-36
Air Bag/Seat Belt Pretensioner System Warning Light *1
7-36*
Tire Pressure Monitoring System Warning Light *1
Flashing
7-36
Illuminate
7-41
(Red) *
KEY Warning Indication/Warning Light *1
Malfunction
7-36
Except malfunction
7-41
(Amber) *
KEY Warning Indication 7-36*
Lane Departure Warning System (LDWS) Warning Indication/
Warning Light *1
Illuminated
7-36
Flashing
4-83
(Amber) *
High Beam Control System (HBC) Warning Indication/
Warning Light *1
7-36*
Blind Spot Monitoring (BSM) Warning Indication 7-36*
Retractable Fastback Warning Indication 7-36
LED Headlight Warning Light *1
7-36
MX-5_8FR4-EA-16J_Edition1.indb 27 2016/08/11 20:28:48
Page 142 of 568

4 –28 When Driving
Instrument Cluster and Display
*Some models.Signal Warning Lights Page
Seat Belt Warning Light 7-41*
Door-Ajar Warning Light 7-41*
Door-Ajar Warning Indication 7-41*
Trunk lid-Ajar Warning Indication 7-41*
Low Fuel Warning Indication/Warning Light 7-41
Check Fuel Cap Warning Light *1
7-41*
Low Washer Fluid Level Warning Indication/Warning Light 7-41
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or
when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an
Authorized Mazda Dealer.
*2 The light turns on continuously when the parking brake is applied.
Indication/Indicator Lights
These lights turn on or flash to notify the user of the system o peration status or a system
malfunction. Signal Indicator Lights Page*
Passenger Air Bag Deactivation Indicator Light *1
2-37
(White/Green) *
KEY Indicator/Indicator Light 3-8
MX-5_8FR4-EA-16J_Edition1.indb 28 2016/08/11 20:28:48
Page 143 of 568
4 –29 When Driving
Instrument Cluster and Display
*Some models.Signal Indicator Lights Page
Security Indicator Light *1
3-48*
Retractable Fastback Operation Indicator Light 3-42*
Wrench Indication/Indicator Light *1
4-30
(Blue) Low Engine Coolant Temperature Indicator Light 4-30*
Shift Position Indication 4-35
Lights-On Indicator Light 4-45
Headlight High-Beam Indicator Light Headlight High-Low
Beam
4-48
Flashing the Headlights
4-48
Turn Signal/Hazard Warning Indicator Lights Turn and Lane-Change
Signals
4-50
Hazard Warning Flasher
4-57
TCS/DSC Indicator Light *1
Traction Control System
(TCS)
4-66
Dynamic Stability
Control (DSC)
4-67
(Turns on)
7-36
DSC OFF Indicator Light *1
4-68*
Select Mode Indication 4-72
(White) *
Tire Pressure Monitoring System Indication 4-108
MX-5_8FR4-EA-16J_Edition1.indb 29 2016/08/11 20:28:48
Page 144 of 568

4 –30 When Driving
Instrument Cluster and Display
*Some models.Signal Indicator Lights Page
(Green) *
High Beam Control System (HBC) Indicator Light 4-78*
Blind Spot Monitoring (BSM) OFF Indicator Light *1
4-90*
Lane Departure Warning System (LDWS) OFF Indicator
Light *1
4-82
(White/Amber) Cruise Main Indication/Indicator Light 4-101
(Green) Cruise Set Indication/Indicator Light 4-101
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or
when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an
Authorized Mazda Dealer.
Wrench Indication/Indicator
Light *
Type A instrument cluster
Perform maintenance in accordance with
the message.
Type B instrument cluster
When the ignition is switched ON, the
wrench indicator light is illuminated and
then turns off after a few seconds.
The wrench indicator light is illuminated
when the preset maintenance period
arrives. Verify the content and perform
maintenance.
Refer to Maintenance Monitor on page
6-20 . Low Engine Coolant Temperature
Indicator Light (Blue)
The light illuminates continuously when
the engine coolant temperature is low and
turns off after the engine is warm.
If the low engine coolant temperature
indicator light remains illuminated after
the engine has been sufficiently warmed
up, the temperature sensor could have
a malfunction. Consult an Authorized
Mazda Dealer.
MX-5_8FR4-EA-16J_Edition1.indb 30 2016/08/11 20:28:49
Page 149 of 568

4 –35 When Driving
Transmission Shift Position Indication
The selector position is indicated when the
ignition is switched ON.
Gear position indication
In manual shift mode, the “M” of the shift
position indication illuminates and the
numeral for the selected gear is displayed.
Warning LightThe warning light turns on when the
system has a malfunction.
Refer to Warning Indication/Warning
Lights on page 4-26 .
Transmission Ranges
The shift position indicator light in the
instrument cluster illuminates. Refer to
Warning/Indicator Lights on page
4-26 .
The selector lever must be in P or N to
operate the starter.
P (Park)
P locks the transmission and prevents the
rear wheels from rotating.
WARNING Always set the selector lever to P and set
the parking brake:
Only setting the selector lever to the
P position without using the parking
brake to hold the vehicle is dangerous.
If P fails to hold, the vehicle could move
and cause an accident. CAUTION
Shifting into P, N or R while the vehicle is
moving can damage your transmission.
Shifting into a driving gear or reverse
when the engine is running faster than
idle can damage the transmission.
R (Reverse)
In position R, the vehicle moves only
backward. You must be at a complete
stop before shifting to or from R, except
under rare circumstances as explained in
Rocking the Vehicle (page 3-53 ).
N (Neutral)
In N, the wheels and transmission are not
locked. The vehicle will roll freely even
on the slightest incline unless the parking
brake or brakes are on.
WARNING If the engine is running faster than idle,
do not shift from N or P into a driving
gear:
It's dangerous to shift from N or P
into a driving gear when the engine
is running faster than idle. If this is
done, the vehicle could move suddenly,
causing an accident or serious injury.
Do not shift into N when driving the
vehicle:
Shifting into N while driving is
dangerous. Engine braking cannot
be applied when decelerating which
could lead to an accident or serious
injury.
MX-5_8FR4-EA-16J_Edition1.indb 35 2016/08/11 20:28:50