2017 MAZDA MODEL MX-5 RF wheel alignment

3–59
Before Driving
Driving Tips
Running-In
No special running-in is necessary, but
a few precautions in the ¿ rst 1,000 km
(600 miles) may add to the performance,
economy, and life of the vehicle.
 


 Do not race the engine.



 Do not maintain one constant speed,
either slow or fast, for a long period of
time.
 


 Do not drive constantly at full-throttle or
high engine rpm for extended periods of
time.
 


 Avoid unnecessary hard stops.



 Avoid full-throttle starts.
Saving Fuel and
Protection of the
Environment
How you operate your Mazda determines
how far it will travel on a tank of fuel. Use
these suggestions to help save fuel and
reduce CO2.
 


 Avoid long warm-ups. Once the engine
runs smoothly, begin driving.
 


 Avoid fast starts.



 Drive at lower speeds.



 Anticipate when to apply the brakes
(avoid sudden braking).
 


 Follow the maintenance schedule (page
6-3 ) and have an expert repairer,
we recommend an Authorised Mazda
Repairer perform inspections and
servicing.
 


 Use the air conditioner only when
necessary.
 


 Slow down on rough roads.



 Keep the tyres properly inÀ ated.



 Do not carry unnecessary weight.



 Do not rest your foot on the brake pedal
while driving.
 


 Keep the wheels in correct alignment.



 Keep windows closed at high speeds.



 Slow down when driving in crosswinds
and headwinds.
/:A(.'',A'FKVKQPKPFD

6–35
Maintenance and Care
Owner Maintenance
NOTE
Because your vehicle is not equipped
with a spare tyre, you cannot do a tyre
rotation safely with the jack that comes
with your vehicle. Have an expert
repairer, we recommend an Authorised
Mazda Repairer perform tyre rotation.
Do not include (TEMPORARY USE ONLY)
spare tyre in rotation.Forward
Also, inspect them for uneven wear and
damage. Abnormal wear is usually caused
by one or a combination of the following:
 


 Incorrect tyre pressure



 Improper wheel alignment



 Out-of-balance wheel



 Severe braking
After rotation, inÀ ate all tyre pressures to
speci¿ cation (page 9-8 ) and inspect the
wheel nuts for tightness.
(With tyre pressure monitoring system)
After adjusting the tyre pressure,
initialization of the tyre pressure
monitoring system is necessary to make
the system operate normally.
Refer to Tyre Pressure Monitoring System
Initialization on page 4-143 .
CAUTION
Rotate unidirectional tyres and radial
tyres that have an asymmetrical tread
pattern or studs only from front to rear,
not from side to side. Tyre performance
will be reduced if rotated from side to
side.
(With limited-slip differential)
Do not use the following:
 
 Tyres not of the designated size 
 Tyres of different sizes or types at the
same time
  Tyres not suf¿ ciently inÀ ated
If these instructions are not followed,
the rotation of the left and right wheels
will be different and will thus apply
a constant load on the limited-slip
differential.
This will cause a malfunction.
Replacing a Tyre
WARNING
Always use tyres that are in good
condition:
Driving with worn tyres is dangerous.
Reduced braking, steering, and traction
could result in an accident.
Replace all four tyres at the same time:
Replacing just one tyre is dangerous.
It could cause poor handling and poor
braking resulting in loss of vehicle
control. Mazda strongly recommends
that you replace all four tyres at the
same time.
/:A(.'',A'FKVKQPKPFD