2017 MAZDA MODEL CX-5 ECU

▼Jack*
To remove the jack
1. Open the luggage board, and lift it.
2. Remove the jack.
To secure the jack
Perform the removal procedure in reverse.
Maintenance
•Always keep the jack clean.
•Make sure the moving parts are kept
free from dirt or rust.
•Make sure the screw thread is
adequately lubricated.
▼Spare Tyre*
Your Mazda has a tem
porary spare tyre.
The temporary spare tyre is lighter and
smaller than a conventional tyre, and is
designed only for emergency use and
should be used only for VERY short
periods. Temporary spare tyres should
NEVER be used for long drives or
extended periods.
WA R N I N G
Do not install the temporary spare tyre on
the front wheels (driving wheels):
Driving with the temporary spare tyre on
one of the front driving wheels is
dangerous. Handling will be affected. You
could lose control of the vehicle, especially
on ice or snow bound roads, and have an
accident. Move a regular tyre to the front
wheel and install the temporary spare tyre
to the rear.
CAUTION
 When using the temporary spare tyre,
driving stability may decrease compared
to when using only the conventional
tyre. Drive carefully.
 To avoid damage to the temporary spare
tyre or to the vehicle, observe the
following precautions:
 Do not exceed 80 km/h (50 mph).
If Trouble Arises
Flat Tyre
*Some models.7-17
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

3. For vehicles equipped with asub-woofer, loosen the hold-down bolt
and remove the woofe r and spare tyre.
For vehicles not equipped with a
sub-woofer, turn the spare tyre
hold-down bolt anticlockwise and
remove the spare tyre.
Spare tyre hold-down bolt
To secure the spare tyre
Store the spare tyre in the reverse order of
removal. After storing, verify that the
spare tyre is stored securely.
Emergency Flat Tyre
Repair Kit
*
The emergency flat tyre repair kit included
with your Mazda is for a temporary repair
of a slightly damaged flat tyre resulting
from running over nails or similar sharp
objects on the road surface.
Perform the emergency flat tyre repair
without removing the nail or similar sharp
object which punc tured the tyre.
NOTE
Your vehicle is not eq uipped with a spare
tyre. In the event of a flat tyre, use the
emergency flat tyre repair kit to repair the
tyre temporarily. When doing the repair,
refer to the instruct ions included in the
emergency flat tyre repair kit. If an
emergency repair was performed on a flat
tyre using the emergency flat tyre repair
kit, have an expert repairer, we
recommend an Authorised Mazda
Repairer, repair or replace the tyre as
soon as possible.
If Trouble Arises
Flat Tyre
*Some models.7-19
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

3. Install the wheel nuts with the bevellededge inward; tighten them by hand.

WARNING
Do not apply oil or grease to wheel nuts
and bolts and do not tighten the wheel
nuts beyond the recommended
tightening torque:
Applying oil or grease to wheel nuts
and bolts is dangerous. The wheel nuts
could loosen while driving and cause
the tyre to come off, resulting in an
accident. In addition, wheel nuts and
bolts could be damaged if tightened
more than necessary.
4. Turn the wheel brace anticlockwise and lower the vehicle.
5. Use the wheel brace to tighten the nuts in the order shown.

If you are unsure of how tight the nuts
should be, have them inspected at an
expert repairer, we recommend an
Authorised Mazda Repairer.
Nut tightening torque
N·m (kgf·m, ft·lbf) 108―147 (12―14,
80―108)
WARNING
Always securely and correctly tighten
the wheel nuts:
Improperly or loosely tightened wheel
nuts are dangerous. The wheel could
wobble or come off. This could result in
loss of vehicle control and cause a
serious accident.
Be sure to reinstall the same nuts you
removed or replace them with metric
nuts of the same configuration:
Because the wheel studs and wheel
nuts on your Mazda have metric
threads, using a non-metric nut is
dangerous. On a metric stud, it would
not secure the wheel and would
damage the stud, which could cause
the wheel to slip off and cause an
accident.
6. Remove the tyre blocks and store the tools and jack.
7. Store the damaged tyre in the luggage compartment.
8. Check the inflation pressure. Refer to Tyres on page 9-9.
9. Have the flat tyre repaired or replaced as soon as possible.
If Trouble Arises
Flat Tyre
7-30
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

6.(With i-ELOOP system)
“i-ELOOP charging” is displayed in
the multi-display of the instrument
cluster after the engine is started. The
message is no longer displayed when
the engine is running and the charging
is completed. The vehicle may be
driven after the message is no longer
displayed.

NOTE
If the vehicle is driven while the
message is displayed, a beep sound is
heard.
If you turn the steering wheel while the
message is displayed, it will feel
heavier than normal, but this does not
indicate an abnormality. The steering
operation will return to normal after
the message is no longer displayed. Do
not remove the jumper leads while the
message is displayed.
7. When finished, carefully disconnect the leads in the reverse order described
in the illustration.
8. If the battery cover has been removed,
install it in the reverse order of
removal.
NOTE
•Verify that the covers are securely
installed.
If Trouble Arises
Battery Runs Out
7-34
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Towing Hooks
CAUTION
The towing eyelet should be used in an
emergency (to get the vehicle out of a
ditch or a snow ba nk, for example).
 When using the towing eyelets, always
pull the lead or chain in a straight
direction with respect to the eyelet. Never
apply a sideways force.
NOTE
When towing with chain or lead, wrap the
chain or lead with a soft cloth near the
bumper to prevent damage to the bumper.
▼ Towing Hooks
1. Remove the towing eyelet and the
wheel brace from the luggage
compartment (page 7-15).
2. Wrap a flathead screwdriver or similar tool with a soft c loth to prevent
damage to a painted bumper, and open
the cap located on the front or rear
bumper.
Front

Rear

Jack lever
CAUTION
Do not use excessive force as it may
damage the cap or scratch the painted
bumper surface.
NOTE
Remove the cap completely and store it
so as not to lose it.
3. Securely install the towing eyelet using the wheel brace or equivalent.
Consult an Authorised Mazda
Repairer.
Front

Wheel brace
Towing
eyelet
If Trouble Arises
Emergency Towing
7-41
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Rear

Towing eyelet
Wheel brace
4. Hook the towing rope to the towing eyelet.
CAUTION
If the towing eyelet is not securely
tightened, it may loosen or
disengage from the bumper when
towing the vehicle. Make sure that
the towing eyelet is securely
tightened to the bumper.
 Be careful not to damage the towing
eyelet and towing hook, vehicle body,
or transaxle system when towing
under the following conditions:
Do not tow a vehicle heavier than
yours.
 Do not suddenly accelerate your
vehicle as it will apply a severe
shock to the towing eyelet and
towing hook or rope.
 Do not attach any rope other than
to the towing eyelet and towing
hook.
If Trouble Arises
Emergency Towing
7-42
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

SignalWarning
(Amber)
KEY Warning Indi-
cation
*
“Keyless System malfunction” is displayed
This message is displayed if the advanced keyless entry & push button start system has a
problem.
Contact an expert repairer, we recommend an Authorised Mazda Repairer.
CAUTION
If the message is indicated, or the push button start indicator light (amber) flashes, the en‐
gine may not start. If the engine cannot be st arted, try starting it using the emergency oper‐
ation for starting the engine, an d have the vehicle inspected at an expert repairer, we rec‐
ommend an Authorised Mazda Repairer as soon as possible.
Refer to Emergency Operation for St arting the Engine on page 4-10.
“Set Power to OFF” is displayed
This message is displayed when the driver's door is opened with out switching the ignition
off.
“Key not found” is displayed
This message is displayed when a ny of the following operations is performed with the key
out of the operational range or placed in areas inside the cabi n where it is difficult for the
key to be detected.
•The push button start is pressed with the ignition switched off•The ignition is switched on•All doors are closed without switching the ignition off
(Red)
(Turns on)
KEY Warning
Light
*
If any malfunction o ccurs in the keyless entry system, it illum inates continuously.
CAUTION
If the key warning indicator light illuminates or the push button start indicator light (am‐
ber) flashes, the engine may not start. If the engine cannot be started, try starting it using
the emergency operation for starting the engine, and have the vehicle inspected at an ex‐
pert repairer, we recommend an Authoris ed Mazda Repairer as soon as possible.
Refer to Emergency Operation for Starting the Engine on page 4- 10.
Security Indicator
Light If the engine does not start with the correct key, and the secu
rity indicator light remains
illuminated or flashing, try the following:
Make sure the key is within the operational range for signal transmission. Switch the igni-
tion off, and then restart the engine. If the engine does not s tart after 3 or more tries, con-
tact an expert repairer, we reco mmend an Authorised Mazda Repai rer.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.7-51
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

SignalWarning Action to be taken
Low Washer Fluid
Level Warning Indica-
tion/Warning Light
*
This warning light indicates that little wash-
er fluid remains. Add washer fluid (page 6-32).
Door-Ajar/Lift-
gate-Ajar Warning In-
dication/Warning Light The light turns on if a
ny door/liftgate is not
closed securely. Close the door/liftgate securely.
Tyre Pressure Monitoring System Warning Light (Turns on)*
Take the appropriate action and verify that the warning light t
urns off.
Wa r n i n g
When the warning light illuminate s, and the warning beep sound is heard when tyre pressure is too low in one
or more tyres.
WARNING
If the tyre pressure monitoring system warning light illuminates or flashes, or the tyre pressure warning beep
sound is heard, decrease vehicle speed immediately and avoid sudden manoeuvring and braking:
If the tyre pressure monitoring system warning light illuminates or flashes, or the tyre pressure warning beep
sound is heard, it is dangerous to drive the vehicle at high speeds, or perform sudden manoeuvring or braking.
Vehicle drivability could worsen and result in an accident.
To determine if you have a slow leak or a flat, pull over to a safe position where you can check the visual condition
of the tyre and determine if you have enough air to proceed to a place where air may be added and the system
monitored again by an expert repairer, we recommend an Authorised Mazda Repairer or a tyre repair station.
Do not ignore the TPMS Warning Light:
Ignoring the TPMS warning light is da ngerous, even if you know why it is illuminated. Have the problem taken
care of as soon as possible before it develops into a more serious situation that could lead to tyre failure and a
dangerous accident.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-56*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2