2017 MAZDA MODEL CX-5 wheel

▼Jack*
To remove the jack
1. Open the luggage board, and lift it.
2. Remove the jack.
To secure the jack
Perform the removal procedure in reverse.
Maintenance
•Always keep the jack clean.
•Make sure the moving parts are kept
free from dirt or rust.
•Make sure the screw thread is
adequately lubricated.
▼Spare Tyre*
Your Mazda has a tem
porary spare tyre.
The temporary spare tyre is lighter and
smaller than a conventional tyre, and is
designed only for emergency use and
should be used only for VERY short
periods. Temporary spare tyres should
NEVER be used for long drives or
extended periods.
WA R N I N G
Do not install the temporary spare tyre on
the front wheels (driving wheels):
Driving with the temporary spare tyre on
one of the front driving wheels is
dangerous. Handling will be affected. You
could lose control of the vehicle, especially
on ice or snow bound roads, and have an
accident. Move a regular tyre to the front
wheel and install the temporary spare tyre
to the rear.
CAUTION
 When using the temporary spare tyre,
driving stability may decrease compared
to when using only the conventional
tyre. Drive carefully.
 To avoid damage to the temporary spare
tyre or to the vehicle, observe the
following precautions:
 Do not exceed 80 km/h (50 mph).
If Trouble Arises
Flat Tyre
*Some models.7-17
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼About the Emergency Flat Tyre
Repair Kit
The emergency flat tyre
repair kit includes
the following items.

Tyre sealant Injection hose
Compressor Valve core
tool
Spare valve
core
Speed restriction
sticker
Instructions
WA R N I N G
Do not allow children to touch the tyre
sealant:

Ingestion of tyre sealant is dangerous. In
the event tyre sealant is accidentally
swallowed, drink large amounts of water
immediately and seek medical
assistance.
 Tyre sealant that comes into contact
with the eyes and skin is dangerous. If
tyre sealant enters the eyes or contacts
the skin, flush immediately with large
amounts of water and seek medical
assistance.
NOTE
•The tyre sealant cannot be reused.
Purchase new tyre sealant at an
Authorised Mazda Repairer.
•The emergency flat tyre repair kit cannot
be used in the following cases.
Consult an expert repairer, we
recommend an Authorised Mazda
Repairer.
•The period of effective use for the tyre
sealant has expired. (The period of
effectiveness is indicated on the bottle
label.)
•The tear or puncture exceeds about 4
mm (0.16 in).
•The damage has occurred to an area
of the tyre other than the tread.
•The vehicle has been driven with
nearly no air remaining in the tyre.
•The tyre has come off the wheel rim.
•Damage to the wheel rim has
occurred.
•The tyre has two or more punctures.
▼ Using the Emergency Flat Tyre
Repair Kit
1. Park on a level surface off the
right-of-way and set the parking brake.
2. Put a vehicle with an automatic
transaxle in Park (P), a manual
transaxle in Reverse (R) or 1, and turn
off the engine.
3. Turn on the hazard warning flasher.
If Trouble Arises
Flat Tyre
7-20
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

NOTE
Do not throw away the empty tyre
sealant bottle after use. Return the
empty tyre sealant bottle to an
Authorised Mazda Repairer when
replacing the tyre. The empty tyre
sealant bottle will need to be used to
extract and dispose of the used sealant
from the tyre.
12. Adhere the speed restriction sticker to
the speedometer.

WA R N I N G
Attach the speed restriction sticker in a
place where it can be viewed easily by
the driver:
Applying the speed restriction sticker
to the steering wheel is dangerous as
it could interfere with the air bag
deployment and result in serious
injury.
 Do not apply the sticker to any
position other than the position
indicated in the illustration of the
speedometer.
13. Install the compressor hose to the tyre
valve.

Valve Compressor hose
14. Insert the compressor plug into theinterior accessory socket and switch
the ignition to A CC (page 5-144).

Compressor plug
Compressor
Centre console
CAUTION
Before pulling out the compressor
plug from the electrical socket, make
sure the compressor power switch is
off.
 The compressor turns on and
off with
the push-button switch.
15. Turn the compressor switch on and inflate the tyre carefully to the correct
inflation pressure.
If Trouble Arises
Flat Tyre
7-23
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

If the tyre
inflation pressure continues
to remain low after repeating steps
13 to 20, park the vehicle on a level
surface off the right-of-way and
contact an expert repairer, we
recommend an Authorised Mazda
Repairer.
NOTE
When checking the tyre inflation
pressure with the tyre pressure gauge
on the compressor unit, make sure the
compressor switch is turned off.
20. The emergency flat tyre repair is
completed if the tyre air pressure does
not decrease. Drive the vehicle
carefully to the nearest expert repairer,
we recommend an Authorised Mazda
Repairer promptly and have the tyre
replaced. Mazda recommends that the
tyre be replaced with a new one. If the
tyre is to be repaired and reused,
consult an expert repairer, we
recommend an Authorised Mazda
Repairer.
Peel off the speed restriction sticker
after replacing the tyre.
CAUTION
For a tyre which has undergone an
emergency flat tyre repair using the
emergency
flat tyre repair kit, Mazda
recommends that the tyre be
replaced with a new one as soon as
possible. If the tyre is to be repaired
and reused, consult an expert
repairer, we recommend an
Authorised Mazda Repairer.
 The wheel can be reused after any
sealant adhering to it is wiped off
and carefully inspected. However,
replace the tyre valve with a new one.
▼ Inspecting the Emergency Flat Tyre
Repair Kit
Inspect the emergency flat tyre repair kit at
regular intervals.
•Check the tyre sealant period of
effective use.
•Check the operation of the tyre
compressor.
NOTE
The tyre sealant has a period of effective
use. Check the period of effective use
indicated on the bottle label and do not
use it if it has expired. Have the tyre
sealant replaced at an Authorised Mazda
Repairer before the period of effective use
has expired.
If Trouble Arises
Flat Tyre
7-25
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Changing a Flat Tyre(With Spare Tyre)
NOTE
If the following occurs while driving, it
could indicate a flat tyre.
•Steering becomes difficult.
•The vehicle begins to vibrate
excessively.
•The vehicle pulls in one direction.
If you have a flat tyre, drive slowly to a
level spot that is well off the road and out
of the way of traffic to change the tyre.
Stopping in traffic or on the shoulder of a
busy road is dangerous.
WA R N I N G
Be sure to follow the directions for
changing a tyre:
Changing a tyre is dangerous if not done
properly. The vehicle can slip off the jack
and seriously injure someone.
No person should place any portion of their
body under a vehicle that is supported by a
jack.
Never allow anyone inside a vehicle
supported by a jack:
Allowing someone to remain in a vehicle
supported by a jack is dangerous. The
occupant could cause the vehicle to fall
resulting in serious injury.
NOTE
Make sure the jack is well lubricated
before using it.
1. Park on a hard, level surface off the right-of-way and firml y set the parking
brake.
2. Put a vehicle with an automatic transaxle in Park (P), a manual
transaxle in Reverse (R) or 1, and turn
off the engine.
3. Turn on the hazard warning flasher.
4. Have everyone get out of the vehicle
and away from the vehicle and traffic.
5. Remove the jack, tool, and spare tyre
(page 7-15).
6. Block the wheel diagonally opposite the flat tyre. When blocking a wheel,
place a tyre block both in front and
behind the tyre.
NOTE
When blocking a tyre, use rocks or
wood blocks of sufficient size if
possible to hold the tyre in place.
If Trouble Arises
Flat Tyre
7-26
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼Removing a Flat Tyre
WA R N I N G
When jacking-up a vehicle, always shift the
shift lever to 1st or R (manual transaxle
vehicle) or shift the selector lever to P
(automatic transaxle vehicle), apply the
parking brake, and place wheel blocks in
the position diagonally opposed to the
jack:
Changing a
flat tyre without using wheel
blocks is dangerous because the vehicle
may move and fall off the jack even with
the shift lever in 1st or R, or the select lever
is in P, which could result in an accident.
1. If your vehicle is equipped with steel wheels, pry off the c entre cap with the
bevelled end of the jack lever.

CAUTION
Use the jack lever when removing the
centre cap. Using your hands to remove
it may cause an injury. In addition,
using a tool other than the jack lever
may cause damage to the wheel or the
centre cap.
2. Loosen the wheel nuts by turning them anticlockwise one turn each, but do not
remove any wheel nuts until the tyre
has been raised off the ground.

3. Place the jack on the ground.
4. Turn the jack screw in the directionshown in the figure and adjust the jack
head so that it is close to the jack-up
position.

Jack head
5. Place the jack under the jack-upposition closest to the tyre being
changed with the jack head squarely
under the jack-up point.

Jacking position
If Trouble Arises
Flat Tyre
7-27
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

6. Continue raising the jack headgradually by rotating the screw with
your hand until the jack head is
inserted into the jack-up position.

Tyre blocks
Jacking position
WARNING
Use only the front and rear jacking
positions recommended in this manual:
Attempting to jack the vehicle in
positions other than those
recommended in this manual is
dangerous. The vehicle could slip off
the jack and seriously injure or even kill
someone. Use only the front and rear
jacking positions recommended in this
manual.
Do not jack up the vehicle in a position
other than the designated jack-up
position or place any objects on or
under the jack:
Jacking up the vehicle in a position
other than the designated jack-up
position or placing objects on or under
the jack is dangerous as it could deform
the vehicle body or the vehicle could fall
off the jack resulting in an accident.
Use only the jack provided with your
Mazda:
Using a jack that is not designed for
your Mazda is dangerous. The vehicle
could slip off the jack and seriously
injure someone.
Never place objects under the jack:
Jacking the vehicle with an object
under the jack is dangerous. The jack
could slip and someone could be
seriously injured by the jack or the
falling vehicle.
7. Insert the jack l ever and attach the
wheel brace to tyre jack.

If Trouble Arises
Flat Tyre
7-28
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

8. Turn the jack handle clockwise andraise the vehicle high enough so that
the spare tyre can be installed. Before
removing the wheel nuts, make sure
your Mazda is firmly in position and
that it cannot slip or move.

WA R N I N G
Do not jack up the vehicle higher than
is necessary:
Jacking up the vehicle higher than is
necessary is dangerous as it could
destabilize the vehicle resulting in an
accident.
Do not start the engine or shake the
vehicle while it is jacked up:
Starting the engine or shaking the
vehicle while it is jacked up is
dangerous as it could cause the vehicle
to fall off the jack resulting in an
accident.
Never go under the vehicle while it is
jacked up:
Going under the vehicle while it is
jacked up is dangerous as it could result
in death or serious injury if the vehicle
were to fall off the jack.
9. Remove the wheel nuts by turning
them anticlockwise; then remove the
wheel and centre cap.
▼Mounting the Spare Tyre
1. Remove dirt and grime from the
mounting surfaces of the wheel and
hub, including the hub bolts, with a
cloth.

WA R N I N G
Make sure the mounting surfaces of the
wheel, hub and wheel nuts are clean
before changing or replacing tyres:
When changing or replacing a tyre, not
removing dirt and grime from the
mounting surfaces of the wheel, hub
and hub bolts is dangerous. The wheel
nuts could loosen while driving and
cause the tyre to come off, resulting in
an accident.
2. Mount the spare tyre.
If Trouble Arises
Flat Tyre
7-29
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2