2017 MAZDA MODEL CX-5 lights

Sunvisors
When you need a sunvisor, lower it for use
in front or swing it to the side.
Sunvisor
▼Va n i t y M i r r o r s
To use the vanity mirror, lower the
sunvisor.
If your vehicle is equipped with a vanity
mirror light, it will
illuminate when you
open the cover.
To prevent the battery from being
discharged, the vanity mirror will only
illuminate in the ti lt range shown in the
figure.

offoff
on
Interior Lights
NOTE
Do not leave the lights on for long periods
while the engine is turned off. Otherwise
the battery power could be depleted.
Overhead Lights
Switch Posi-
tion Overhead Lights
Light off
•Light is on when a
ny door is open•Light is on or off when the illumi-
nated entry system is on
Light on
NOTE
The rear map lights also turn on and off
when the overhead light switch is
operated.
Interior Features
Interior Equipment
5-142
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Front Map Lights
When the overhead light switch is in the
door or off position, press the lens to
illuminate the front map lights, and then
press the lens again to turn them off.
NOTE
The front map lights will not turn off even
if the lens is pressed in the following
cases:
•The overhead light switch is in the ON
position.
•The overhead light switch is in the door
position with the door open.
•The illuminated entry system is on.
Rear Map Lights
When the overhead light switch is in the
door or off position, press the lens to
illuminate a rear map light, and then press
the lens again to turn it off.
NOTE
•Once the rear map lights have been
turned off, they wi ll turn on and off
depending on the position to which the
overhead light is switched.
•The rear map lights will not turn off
even if the lens is pressed in the
following cases:
•The overhead light switch is ON.
•The overhead light switch is in the
door position with the door open.
•The illuminated entry system is on.
Luggage Compartment Lights
Switch Posi- tion Luggage Compartment Light
Light off
Light on when the liftgate is open
Interior Features
Interior Equipment
5-143
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼Illuminated Entry System
The overhead lights turn on when any of
the following operations is done with the
overhead light switch in the DOOR
position.
•The driver's door i
s unlocked with the
ignition is switched OFF.
•The ignition is switched OFF with all
doors closed.
NOTE
•The illumination time differs depending
on the operation.
•Battery saver
If an interior light is left on with the
ignition switched OFF, the light is
turned off automatically after about 30
minutes to prevent battery depletion.
•The operation of the illuminated entry
system can be changed.
Refer to Personalisation Features on
page 9-12.
Accessory Sockets
Only use genuine Mazda accessories or
the equivalent requiring no greater than
120 W (DC 12 V, 10 A).
The ignition must be switched to ACC or
ON.
Front
Centre
Rear

Interior Features
Interior Equipment
5-144
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

*3 Flexible setting is factory preset for some countries in Europ e. Consult an Authorised Mazda Repairer for
details. Flexible setting can be s et if the vehicle is operated mainly where none of the following conditions
apply.
a) Purpose of vehicle use is poli ce car, taxi or driving school car.
b) Driving in dusty conditions
c) Extended periods of idling or low speed operation
Once the flexible maintenance is selected, the vehicle calculat es the remaining oil life based on engine
operating conditions and lets you know when an oil change is du e by illuminating the wrench indicator light in
the instrument cluster.
Reset the engine oil data wheneve r replacing the engine oil regardless of the message/wrench indicator light
display.
*4 If the vehicle is operated primarily under any of the followin g conditions, replace the engine oil and oil filter at
every 10,000 km (6,250 miles) or shorter.
a) Purpose of vehicle use is poli ce car, taxi or driving school car.
b) Driving in dusty conditions
c) Extended periods of idling or low speed operation
d) Driving for long period in cold temperatures or driving regul arly at short distance only
e) Driving in extremely hot conditions
f) Driving in mountainous conditions continually
*5 If the vehicle is operated primarily under any of the followin g conditions, replace the engine oil and oil filter at
every 5,000 km (3,125 miles) or 6 months.
a) Purpose of vehicle use is poli ce car, taxi or driving school car.
b) Driving in dusty conditions
c) Extended periods of idling or low speed operation
d) Driving for long period in cold temperatures or driving regul arly at short distance only
e) Driving in extremely hot conditions
f) Driving in mountainous conditions continually
*6 For SKYACTIV-D 2.2, r eset the engine oil data whenever replaci ng the engine oil regardless of the message/
wrench indicator light display.
*7 Implement the fuel injection amount correction.*8 Drain water in the fuel system if the indicator lights is ON.*9 Also inspect the air conditioner drive belts, if installed.
If the vehicle is operated primarily under any of the following conditions, inspect the drive belts at every
20,000 km (12,500 miles) or 12 months .
a) Driving in dusty conditions
b) Extended periods of idling or low speed operation
c) Driving for long period in col d temperatures or driving regularly at short distance only
d) Driving in extremely hot conditions
e) Driving in mountainous conditions continually
*10 Use of FL-22 is recommended wh en replacing engine coolant. Using engine coolant other than FL-22 may
cause serious damage to the engine and cooling system.
*11 Inspect the battery electrolyte level, specific gravity and o uter appearance. The sealed battery only requires an
outer appearance inspection.
*12 If the brakes are used extensi vely (for example, continuous hard driving or mountain driving) or if the vehicle
is operated in extreme ly humid climates, replace the brake flui d annually.
*13 If this component has been submerged in water, the oil should be replaced.*14 Tyre rotation is recommended every 10,000 km (6,250 miles).*15 Check the tyre repair fluid expiration date every year when performing the periodic maintenance. Replace the
tyre repair fluid bottle with new one before the expiration date.
Maintenance and Care
Scheduled Maintenance
6-5
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼Inspecting Electrolyte Level
A low level of electrolyte fluid will cause
the battery to discharge quickly.

Upper level
Lower level
Inspect the electrolyte level at least once a
week. If it is low, re move the caps and add
enough distilled water to bring the level
between the upper and lower level
(illustration).

Do not overfill.
Examine the specific gravity of the
electrolyte with a hydrometer, especially
during cold weather. If it is low, recharge
the battery.
▼ Battery Recharging
NOTE
•Before performing maintenance or
recharging the battery, turn off all
accessories and stop the engine.
•To disconnect the battery, remove the
negative lead first. Install it last when
connecting the battery.
•Be sure to remove the caps before
recharging the battery.
•(With i-stop system)
Do not quick-charge the battery.
•If the battery quickly discharges
because, for example, the lights were
left on too long with the engine off,
slow-charge it as required by battery
size and charger capacity.
•If the battery gradually discharges
because of high electric load while the
vehicle is being used, recharge it as
required by battery
size and charger
capacity.
▼ Battery Replacement
Contact an Authorised Mazda Repairer for
a battery replacement purchase.
Maintenance and Care
Owner Maintenance
6-40
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Light Bulbs
Type A
Type B
Headlights (High/Low beam)
Running lights/Position lights
Headlights (Low beam)*
Running lights*
Front fog lights*
Front direction indicator lights
Position lights
Side direction indicator lights
Brake lights
Maintenance and Care
Owner Maintenance
*Some models.6-47
2017-6-7 7:51:19Form No. CX-5 8FY4-EE-17E+L_Edition2

Brake lights/Tail lights
Rear direction indicator lights
Reverse lights
Rear fog light (Left-hand drive model)*
Rear fog light (Right-hand drive model)*
High-mount brake light
Number plate lights
Overhead lights/Front map lights
Vanity mirror lights*
Rear map lights
Luggage compartment light
WA R N I N G
Never touch the glass portion of a halogen
bulb with your bare hands and always
wear eye protection when handling or
working around the bulbs:
When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurised gas. If one is broken, it will
explode and serious injuries could be
caused by the
flying glass.
If the glass portion is touched with bare
hands, body oil could cause the bulb to
overheat and explode when lit.
Always keep halogen bulbs out of the reach
of children:
Playing with a halogen bulb is dangerous.
Serious injuries could be caused by
dropping a halogen bulb or breaking it
some other way.
CAUTION
When removing the lens or lamp unit using
a flathead screwdriver, make sure that the
flathead screwdriver does not contact the
interior terminal. If the flathead screwdriver
contacts the terminal, a short circuit may
occur.
NOTE
•To replace the bulb, contact an expert
repairer, we recommend an Authorised
Mazda Repairer.
•If the halogen bulb is accidentally
touched, it should be cleaned with
rubbing alcohol before being used.
•Use the protective cover and carton for
the replacement bulb to dispose of the
old bulb promptly and out of the reach
of children.
Maintenance and Care
Owner Maintenance
6-48*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼Replacing Exterior Light Bulbs
Headlights, Running lights/Position
lights (Type A), Ru
nning lights (Type
A), Front fog lights*, Side direction
indicator lights, Bra ke lights (Type A),
Brake lights/Tail lights (Type A),
Reverse lights, High-mount brake light
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with the
unit. We recommend an Authorised Mazda
Repairer when the replacement is
necessary.
Front direction indicator lights, Position
lights (Type B)
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Lift the bonnet. Refer to Bonnet on page 6-22.
3. Turn the socket and bulb assembly anticlockwise and remove it.
4. Disconnect the bulb from the socket. Front direction indicator lights
Position lights
5. Install the new bulb in the reverse
order of the removal procedure.
Running lights (Type B)
*
1. Make sure the ignition is switched off, and the headlight switch is off.
2. If you are changing the right bulb, start
the engine, turn the steering wheel all
the way to the left, and turn off engine.
If you are changing the left bulb, turn
the steering wheel to the right.
3. Pull the centre of each plastic retainer
using a flathead screwdriver and
remove the retainers, and then partially
peel back the over fender.
Removal
Installation
Maintenance and Care
Owner Maintenance
*Some models.6-49
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2