2017 LEXUS RX200T fuel

7088-2. Steps to take in an emergency
RX350/RX200t_EE_OM48F32E
One of the following may be the cause of the problem:
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
●The engine may be flooded.
Try to restart the engine again following correct starting procedures.
( P. 246)
●There may be a malfunction in the engine immobilizer system. (P. 77)
One of the following may be the cause of the problem:
●The battery terminal connections may be loose or corroded.
●The battery may be discharged. ( P. 714)
The engine starting system may be malfunctioning due to an electrical problem
such as electronic key battery depletion or a blown fuse. However, an interim
measure is available to start the engine. ( P. 709)
If the engine will not start
If the engine will not start even though correct starting procedures are being
followed ( P. 246), consider each of the following points:
The engine will not start even though the starter motor operates nor-
mally
The starter motor turns over slowly, the interior lights and headlights
are dim, or the horn does not so und or sounds at a low volume.
The starter motor does not turn over

725
9Vehicle specifications
RX350/RX200t_EE_OM48F32E
9-1. Specifications
Maintenance data
(fuel, oil level, etc.) .................. 726
Fuel information.......................... 739
9-2. Customization
Customizable features ............ 740
9-3. Initialization
Items to initialize ......................... 752

726
RX350/RX200t_EE_OM48F32E
9-1. Specifications
*1: Unladen vehicle
*2: Vehicles without roof antenna
*3: Vehicles with roof antenna
*4: 2WD models
*5: AWD models
*6: Vehicles with towing package
*7:RX200t
*8:RX350
Maintenance data (fuel, oil level, etc.)
Dimensions and weights
Overall length4890 mm (192.5 in.)
Overall width1895 mm (74.6 in.)
Overall height*11690 mm (66.5 in.)*2
1710 mm (67.3 in.)*3
Wheelbase2790 mm (109.8 in.)
TreadFront1640 mm (64.6 in.)
Rear1630 mm (64.2 in.)
Gross vehicle mass2500 kg (5511 lb.)*4
2575 kg (5676 lb.)*5
Maximum permissible axle
capacity
Front1360 kg (2998 lb.)
Rear1590 kg (3505 lb.)
Drawbar load*680 kg (176 lb.)
Towing capacity*6
Without brake750 kg (1653 lb.)
With brake1500 kg (3307 lb.)*7
2000 kg (4409 lb.)*8

729
9
9-1. Specifications
Vehicle specifications
RX350/RX200t_EE_OM48F32E
RX200t
*: The engine oil capacity is a reference quantity to be used when changing the engine
oil. Warm up the engine and turn off the engine, wait more than 5 minutes, and check
the oil level on the dipstick.
Model8AR-FTS
Type4-cylinder in line, 4-cycle, gasoline
(with turbocharger)
Bore and stroke86.0  86.0 mm (3.39  3.39 in.)
Displacement1998 cm3 (121.9 cu. in.)
Valve clearance (engine cold)Automatic adjustment
Drive belt tensionAutomatic adjustment
Fuel
Fuel type
EU area
Unleaded gasoline conforming to European stan-
dard EN228 only
Except EU area
Unleaded gasoline only
Research octane number95 or higher
Fuel tank capacity (Reference)72 L (19.0 gal., 15.8 lmp. gal.)
Lubrication system
Oil capacity
(Drain and refill reference*)
With filter
Without filter
RX350
5.5 L (5.8 qt., 4.8 Imp. qt.)
RX200t
4.9 L (5.2 qt., 4.3 Imp. qt.)
RX350
5.3 L (5.6 qt., 4.7 Imp. qt.)
RX200t
4.7 L (5.0 qt., 4.1 Imp. qt.)

7309-1. Specifications
RX350/RX200t_EE_OM48F32E
■Engine oil selection
RX350
“Toyota Genuine Motor Oil” is used in your Lexus vehicle. Lexus recom-
mends the use of approved “Toyota Genuine Motor Oil”. Another motor oil of
matching quality can also be used.
Oil grade:
0W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving ”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or IL SAC multigrade engine oil
15W-40:
API grade SL, SM or SN multigrade engine oil
Recommended viscosity (SAE):
SAE 0W-20 is filled into your Lexus
vehicle at manufacturing, and the
best choice for good fuel economy
and good starting in cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used. How-
ever, it should be replaced with SAE
0W-20 at the next oil change.
If you use SAE 10W-30 or a higher
viscosity engine oil in extremely low
temperatures, the engine may
become difficult to start, so SAE
0W-20 or 5W-30 engine oil is rec-
ommended.
Preferred
Temperature range anticipated
before next oil change

731
9
9-1. Specifications
Vehicle specifications
RX350/RX200t_EE_OM48F32E
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows cold
startability. Oils with a lower value before the W allow for easier starting of
the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when the
oil is at high temperature. An oil with a higher viscosity (one with a higher
value) may be better suited if the vehicle is operated at high speeds, or
under extreme load conditions.
How to read oil container labels:
Either or both API registered marks are added to some oil containers to help
you select the oil you should use.
API Service Symbol
Top portion: “API SERVICE SN” means the oil quality designation by
American Petroleum Institute (API).
Center portion: “SAE 0W-20” means the SAE viscosity grade.
Lower portion: “Resource- Conserving” means that the oil hasfuel-saving and environmental pro-
tection capabilities.
ILSAC Certification Mark
The International Lubricant Specificatio n Advisory Committee (ILSAC) Certifica- tion Mark is displayed on the front of the container.
1
2

7329-1. Specifications
RX350/RX200t_EE_OM48F32E
RX200t
“Toyota Genuine Motor Oil SAE 0W -20 for Downsized Turbo Gasoline
Engines” is used in your Lexus vehicl e. Use Lexus approved “Toyota Genuine
Motor Oil SAE 0W-20 for Downsized Turbo Gasoline Engines” or equiva-
lent to satisfy the following grade and viscosity.
Oil grade:
“Toyota Genuine Motor Oil SAE 0W -20 for Downsized Turbo Gasoline
Engines” or API grade SL “Energy-Co nserving”, SM “Energy-Conserving” or
SN “Resource-Conserving”; or ILSAC multigrade engine oil
Viscosity grade:
SAE 0W-20 and 5W-30
Recommended viscosity (SAE):
“Toyota Genuine Motor Oil SAE
0W-20 for Downsized Turbo Gaso-
line Engines” is filled into your Lexus
vehicle at manufacturing, and SAE
0W-20 is the best choice for good
fuel economy and good starting in
cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used. How-
ever, it should be replaced with SAE
0W-20 at the next oil change.
Temperature range anticipated
before next oil change
Preferred

733
9
9-1. Specifications
Vehicle specifications
RX350/RX200t_EE_OM48F32E
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows cold startability. Oils with a lower value before the W allow for easier starting of
the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when the
oil is at high temperature. An oil with a higher viscosity (one with a higher
value) may be better suited if the vehicle is operated at high speeds, or
under extreme load conditions.
How to read oil container labels:
Either or both API registered marks are added to some oil containers to help
you select the oil you should use.
API Service Symbol
Top portion: “API SERVICE SN”
means the oil quality designation by
American Petroleum Institute (API).
Center portion: “SAE 0W-20”
means the SAE viscosity grade.
Lower portion: “Resource-
Conserving” means that the oil has
fuel-saving and environmental pro-
tection capabilities.
ILSAC Certification Mark
The International Lubricant Specificatio n Advisory Committee (ILSAC) Certifica-
tion Mark is displayed on the front of the container.
1
2