2017 LEXUS RX200T emergency towing

6598-2. Steps to take in an emergency
8
When trouble arises
RX350/RX200t_EE_OM48F32E
Towing with a wheel-lift type truck
From the front (2WD models)From the front (AWD models)
Release the parking brake. Use a towing dolly under the rear
wheels.
From the rear
Use a towing dolly under the front
wheels.

6608-2. Steps to take in an emergency
RX350/RX200t_EE_OM48F32E
If your vehicle is transported by a flat-
bed truck, it should be tied down at the
locations shown in the illustration.
If you use chains or cables to tie down
your vehicle, the angles shaded in black
must be 45 .
Do not overly tighten the tie downs or
the vehicle may be damaged.
If a tow truck is not available in an emergency, your vehicle may be temporarily
towed using cables or chains secured to the emergency towing eyelets. This
should only be attempted on hard surfac ed roads for at most 80 km (50 miles)
at under 30 km/h (18 mph).
A driver must be in the vehicle to steer and operate the brakes. The vehicle’s
wheels, drive train, axles, steering and brakes must be in good condition.
Using a flatbed truck
Front
Emergency towing

6618-2. Steps to take in an emergency
8
When trouble arises
RX350/RX200t_EE_OM48F32E
Take out the towing eyelet. (P. 680, 695)
Remove the eyelet cover.
Insert the towing eyelet into the hole
and tighten partially by hand.
Tighten down the towing eyelet
securely using a wheel nut wrench
or hard metal bar.
Securely attach cables or chains to the towing eyelet.
Take care not to damage the vehicle body.
Enter the vehicle being towed and start the engine.
If the engine does not start, turn the engine switch to IGNITION ON mode.
Shift the shift lever to N and release the parking brake.
When the shift lever cannot be shifted: P. 256
Emergency towing procedure
1
2
Except F SPORT modelsF SPORT models
3
4
5
6
7

6628-2. Steps to take in an emergency
RX350/RX200t_EE_OM48F32E
■While towing
If the engine is not running, the power assist for the brakes and steering will not function, making steering and braking more difficult.
■Wheel nut wrench
Wheel nut wrench is installe d in luggage compartment. (P. 680, 695)
WARNING
Observe the following precautions. Failure to do so may result in death or serious injury.
■When towing the vehicle
2WD models
Be sure to transport the vehicle with the front
wheels raised or with all four wheels raised off the ground. If the vehicle is towed with thefront wheels contacting the ground, the
drivetrain and related parts may be dam- aged.
AWD models
Be sure to transport the vehicle with all four wheels raised off the ground. If the vehicle istowed with the tires contacting the ground,
the drivetrain or related parts may be dam- aged, the vehicle may fly off the truck.

6638-2. Steps to take in an emergency
8
When trouble arises
RX350/RX200t_EE_OM48F32E
WARNING
■While towing
●When towing using cables or chains, avoid sudden starts, etc. which place excessive stress on the towing eyelets, cables or ch ains. The towing eyelets, cables or chains
may become damaged, broken debris ma y hit people, and cause serious damage.
●Do not turn the engine switch off. There is a possibility that the steering wheel is locked and cannot be operated.
■Installing towing eyelets to the vehicle
Make sure that towing eyelets is installed securely. If not securely installed, towing ey elets may come loose during towing.
NOTICE
■To prevent damage to the vehicle when towing using a wheel-lift type truck
●Do not tow the vehicle from the rear when the engine switch is off. The steering lock mechanism is not strong enough to hold the front wheels straight.
●When raising the vehicle, ensure adequate ground clearance for towing at the oppo-
site end of the raised vehicle. Without adequate clearance, the vehicle could be dam- aged while being towed.
■To prevent body damage to the vehi cle towing with a sling-type truck
Do not tow with a sling-type truck, either from the front or rear.
■To prevent damage to the vehicle during emergency towing
Do not secure cables or chains to the suspension components.
■When towing a vehicle equipped with the Stop & Start system (RX200t)
When it is necessary to tow the vehicle with all 4 wheels contacting the ground, per- form the following procedure before towing the vehicle to protect the system.
Turn the engine switch off once, and then start the engine. If the engine does not start, turn the engine switch to IGNITION ON mode.

6808-2. Steps to take in an emergency
RX350/RX200t_EE_OM48F32E
Vehicles with a compact spare tire
Location of the spare tire, jack and tools
Jack handle
Wheel nut wrench
Spare tire
Jack
Towing eyelet
1
2
3
4
5

6818-2. Steps to take in an emergency
8
When trouble arises
RX350/RX200t_EE_OM48F32E
Vehicles with a full-size spare tire
Jack handle
Wheel nut wrench
Spare tire
Jack
Towing eyelet
1
2
3
4
5

6958-2. Steps to take in an emergency
8
When trouble arises
RX350/RX200t_EE_OM48F32E
*: Use of the jack (P. 682, 683)
Location of the emergency tire puncture repair kit, jack and tools
Towing eyelet
Jack handle
Wheel nut wrench
Emergency tire puncture repair kit
Jack*
1
2
3
4
5