2017 LEXUS RC200T ECO mode

8
RC200t_RC F_EE(OM24728E)
Please note that this manual applies to all models and explains all equipment, including options. Therefore, you may find some expl anations for equipment not installed on your vehicle.
All specifications provided in this manual are current at the time of printing. However, because of the Lexus policy of continual pr oduct improvement, we reserve the right to make changes at any time without notice.
Depending on specifications, the vehicle sh own in the illustrations may differ from your vehicle in terms of color and equipment.
Both genuine Lexus and a wide variety of other spare parts and accessories for Lexus vehicles are currently available on the market. Should it be determined that any of the
genuine Lexus parts or accessories supplied with the vehicle need to be replaced, Lexus recommends that genuine Lexus parts or acce ssories, be used to replace them. Other parts or accessories of matching quality can also be used. Lexus cannot accept any liabil-
ity or guarantee spare parts and accessories which are not genuine Lexus products, nor for replacement or installation involving such parts. In addition, damage or performance problems resulting from the use of non-genu ine Lexus spare parts or accessories may
not be covered under warranty.
The installation of an RF-transmitter system in your vehicle could affect electronic sys- tems such as:
●Multiport fuel injection system/seque ntial multiport fuel injection system
●Dynamic radar cruise control system
●Cruise control system
●Anti-lock brake system
●Vehicle dynamics integrated management
●SRS airbag system
●Seat belt pretensioner system
Be sure to check with any authorized Lexus de aler or repairer, or another duly qualified and equipped professional for precautionary measures or special instructions regarding
installation of an RF-transmitter system.
Further information regarding frequency ba nds, power levels, antenna positions and installation provisions for the installation of RF-transmitters, is available on request at any
authorized Lexus dealer or repairer, or anot her duly qualified and equipped professional.
For your information
Main Owner’s Manual
Accessories, spare parts and modification of your Lexus
Installation of an RF-transmitter system

411-1. For safe use
1
For safety and security
RC200t_RC F_EE(OM24728E)
WARNING
Observe the following precautions. Failure to do so may cause the driver’s floor mat to slip, possibly interfering with the ped-als while driving. An unexpect edly high speed may result or it may become difficult to
stop the vehicle. This could lead to an acci dent, resulting in death or serious injury.
■When installing the driver’s floor mat
●Do not use floor mats designed for other models or different model year vehicles,
even if they are Lexus Genuine floor mats.
●Only use floor mats designed for the driver’s seat.
●Always install the floor mat securely us ing the retaining hooks (clips) provided.
●Do not use two or more floor mats on top of each other.
●Do not place the floor mat bottom-side up or upside-down.
■Before driving
●Check that the floor mat is securely fixed in the correct place with all the provided retain-
ing hooks (clips). Be especially careful to per- form this check after cleaning the floor.
●With the engine stopped and the shift lever in
P, fully depress each pedal to the floor to make sure it does not interfere with the floormat.

1122. Instrument cluster
RC200t_RC F_EE(OM24728E)
Warning lights inform the driver of malfunctions in the indicated vehicle systems.
*1: These lights turn on when the engine switch is turned to IGNITION ON mode to
indicate that a system check is being performed. They will turn off after the engine is
started, or after a few seconds. There may be a malfunction in a system if a light does
not come on, or turn off. Have the vehicle inspected by any authorized Lexus dealer
or repairer, or another duly qualified and equipped professional.
*2: The light flashes to indicate a malfunction.
*3: This light illuminates on the center panel.
Warning lights
*1Brake system warning light
( P. 591)
*1 Automatic headlight leveling system warninglight ( P. 592)
*1Charging system warning light ( P. 591)Open door warning light ( P. 593)
*1Malfunction indicator lamp ( P. 591)Low fuel level warning light ( P. 593)
*1SRS warning light
( P. 591)
Driver’s and front passen- ger’s seat belt reminder light ( P. 593)
*1ABS warning light ( P. 592)
*3Rear passengers’ seat belt reminder lights ( P. 593)
*1Electric power steering sys-
tem warning light ( P. 592)
*1Master warning light ( P. 593)
*1, 2
(if equipped)
Pre-crash safety system warning light ( P. 592)
*1
Tire pressure warning light ( P. 593)
*1Slip indicator ( P. 592)

1142. Instrument cluster
RC200t_RC F_EE(OM24728E)
●Drive mode indicators
RC200t(except F SPORT models)
RC200t (F SPORT models)
RC F
*5
Low outside temperature indicator ( P. 124)
*8
“EXPERT” indicator ( P. 352)
*1Eco Driving Indicator Light ( P. 116)
*1, 7“PASSENGER AIR BAG” indicator
( P. 60)
*8Parking brake indicator ( P. 261)
Eco drive mode indicator ( P. 345) “SPORT” indicator ( P. 345)
Snow mode indicator ( P. 254)
Eco drive mode indicator ( P. 345) “SPORT S” indicator ( P. 345)
“SPORT S+” indicator
( P. 345)
Snow mode indicator
( P. 254)
“NORMAL” indicator ( P. 345) Eco drive mode indicator ( P. 345)
“SPORT S” indicator ( P. 345) “SPORT S+” indicator ( P. 345)
Snow mode indicator
( P. 254)

1152. Instrument cluster
2
Instrument cluster
RC200t_RC F_EE(OM24728E)
●TVD (Torque Vectoring Differential) control mode indicators (RC F)
*1: These lights turn on when the engine switch is turned to IGNITION ON mode to
indicate that a system check is being performed. They will turn off after the engine is
started, or after a few seconds. There may be a malfunction in a system if a light does
not come on, or turn off. Have the vehicle inspected by any authorized Lexus dealer
or repairer, or another duly qualified and equipped professional.
*2: The light flashes to indicate that the system is operating.
*3: The light comes on when the system is turn ed off. The light will flash quickly when the
system is operating.
*4: In order to confirm operation, the BSM outside rear view mirror indicators illuminate
in the following situations:
• When the engine switch is turned to IGNITION ON mode while the BSM main switch is turned on.• When the BSM main switch is turned on while the engine switch is in IGNITION
ON mode.
If the system is functioning correctly, the BSM outside rear view mirror indicators will turn off after a few seconds.
If the BSM outside rear view mirror indicators do not illuminate or do not turn off, there may be a malfunction in the system.
If this occurs, have the vehicle inspected by any authorized Lexus dealer or repairer, or another duly qualified and equipped professional.
*5: When the outside temperature is approximately 3°C (37°F) or lower, the indicator
will flash for approximately 10 seconds, then stay on.
*6: This light illuminates on the outside rear view mirrors.
*7: This light illuminates on the center panel.
*8:RC F
(if equipped)
“STANDARD” indicator
( P. 382)(if equipped)
“SLALOM” indicator
( P. 382)
(if equipped)
“TRACK” indicator ( P. 382)

1162. Instrument cluster
RC200t_RC F_EE(OM24728E)
■Eco Driving Indicator
RC200t
Eco Driving Indicator will not operate under the following conditions:
●The shift lever is in any position other than D.
●A paddle shift switch is operated.
●Neither normal mode nor Eco drive mode is selected. ( P. 345)
●The vehicle speed is approximately 130 km/h (80 mph) or higher.
RC F
Eco Driving Indicator will not operate under the following conditions:
●The shift lever is in any position other than D.
●A paddle shift switch is operated.
●Neither normal mode nor Eco drive mode is selected. ( P. 345)
●The vehicle speed is approximately 130 km/h (80 mph) or higher.
Eco Driving Indicator Light
During Eco-friendly acceleration (Eco driv- ing), the Eco Driving In dicator Light will turn on. When the acceleration exceeds the Zone
of Eco driving, or when the vehicle is stopped, the light turns off.
Eco Driving Indicator Zone Display
Suggests the Zone of Eco driving with current
Eco driving ratio based on acceleration.
Eco driving ratio based on acceleration
If the acceleration exceeds the Zone of Eco
driving, the right side of the Eco Driving Indi- cator Zone Display will illuminate.
Zone of Eco driving
During Eco-friendly acceleration (Eco driving), the Eco Driving Indicator Light will turn on.When the acceleration exceeds the Zone of
Eco driving, or when the vehicle is stopped, the light turns off.
1
2
3
4

1202. Instrument cluster
RC200t_RC F_EE(OM24728E)
■Speed indicator (F SPORT models)
When the vehicle reaches a set
speed, indicators will be displayed
on both sides of the displayed speed
unit.
The indicators will be displayed in yellow (corresponding to a speed setby a user) or red (fixed at 100 mph
[160 km/h]*1 or 200 km/h [125
mph]*2)*3.
This setting can be enabled on the multi-information display.
*1:For U.K.
*2:Except for U.K.
*3: Always observe the legal speed limit when driving on public roads.
■Rev indicator (F SPORT models)
When the engine reaches a set
speed, a ring-shaped indicator will
be displayed on the tachometer.
■Rev peak (F SPORT models)
The engine speed reaches or
exceeds 5000 r/min, an afterimage
of the tachometer will be displayed
at the highest engine speed for
approximately 0.5 seconds.

1242. Instrument cluster
RC200t_RC F_EE(OM24728E)
If the drive mode is changed, some of the meter displays and the gauge layout
will be changed.
Normal mode
Eco drive mode
Gauges and meters (RC F)