2017 LEXUS LS600H inflation pressure

5877-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
Attach the 2 stickers as shown.
Remove any dirt and moisture from
the wheel before attaching the label. If
it is impossible to attach the label,
make sure to tell any authorized Lexus
dealer or repairer, or another duly
qualified and equipped professional
when you have them repair and
replace the tire that sealant is injected.
Check the specified tire inflation
pressure.
Tire inflation pressure is specified on
the label as shown. ( P. 630)
Start the hybrid system. (P. 247)
To inject the sealant and inflate
the tire, turn the compressor
switch on.
9
10
11
12

5887-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
Inflate the tire until the recom-
mended pressure is reached.
The sealant will be injected and
the pressure will spike to 300
kPa (3.0 kgf/cm2 or bar, 44
psi) or 400 kPa (4.0 kgf/cm2
or bar, 58 psi), then gradually
decrease.
The air pressure gauge will dis-
play the actual tire inflation
pressure about 1 minute (15
minutes at low temperature)
after the switch is turned on.
• Turn the compressor switch off
and then check the tire inflation
pressure. Being careful not to
over inflate, check and repeat
the inflation procedure until the
recommended tire inflation
pressure is reached.
• If the tire inflation pressure is still
lower than the recommended
level after inflation for 10 min-
utes (35 minutes at low tem-
perature) with the switch on, the
tire is too damaged to be
repaired. Turn the compressor
switch off and contact any
authorized Lexus dealer or
repairer, or anot her duly quali-
fied and equipped professional.
• If the tire inflation pressure
exceeds the recommended
level, let out some air to adjust
the tire inflation pressure.
( P. 592, 630)
13
1
2

5907-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
Turn the compressor switch on
and wait for several seconds, then
turn it off. Check the tire inflation
pressure.
If the tire inflation pressure is
below 130 kPa (1.3 kgf/cm
2 or
bar, 19 psi): The puncture can-
not be repaired. Contact any
authorized Lexus dealer or
repairer, or another duly quali-
fied and equipped profes-
sional.
If the tire inflation pressure is
between 130 kPa (1.3 kgf/cm
2
or bar, 19 psi) and a point
below the recommended level:
The tire can be repaired. Pro-
ceed to step .
If the tire inflation pressure is at
the recommended level: Pro-
ceed to step .
Turn the compressor switch on to inflate the tire until the recommended
tire inflation pressure is reached. Drive for about 5 km (3 miles) and
then perform step .
Attach the air release cap to the
end of the hose.
If the air release cap is not attached,
the sealant may leak and the vehicle
may get dirty.
20
1
2
21
3
22
21
19
22

5927-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
■If the tire is inflated to more than the recommended level
Disconnect the hose from the valve.
Disconnect the hose from the valve, remove the air release cap from the hose and
then reconnect the hose.
Turn the compressor switch on and wait for several seconds, then turn it off. Check
that the air pressure indicator shows the recommended level. ( P. 630)
If the air pressure is lower than the recommended level, turn the compressor
switch on again and repeat the inflation procedure until the recommended pres-
sure is reached.
■After a tire is repaired with the emergency tire puncture repair kit
●The tire pressure warning valve and transmitter should be replaced.
●Even if the tire inflation pressure is at the recommended level, the tire pressure
warning light may come on/flash.
■Note for checking the emergency tire puncture repair kit
Check the sealant expiry date occasionally.
The expiry date is shown on the bottle. Do not use sealant whose expiry date has
already passed. Otherwise, repairs conducted using the emergency tire puncture
repair kit may not be performed properly.
Install the air release cap to the end of the
hose and push the protrusion on the air
release cap into the valve to let some air
out.
1
2
3
4

5947-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
CAUTION
■When fixing the flat tire
●Stop your vehicle in a safe and flat area.
●Do not touch the wheels or the area around the brakes immediately after the
vehicle has been driven.
After the vehicle has been driven, the wheels and the area around the brakes may
be extremely hot. Touching these areas with hands, feet or other body parts may
result in burns.
●Connect the valve and hose securely with the tire installed on the vehicle.
●If the hose is not properly connected to the valve, air leakage may occur or seal-
ant may be sprayed out.
●If the hose comes off the valve while inflating the tire, there is a risk that the hose
will move abruptly due to air pressure.
●After inflation of the tire has completed, the sealant may splatter when the hose is
disconnected or some air is let out of the tire.
●Follow the operation procedure to repair th e tire. If the procedure is not followed,
the sealant may spray out.
●Keep back from the tire while it is being repaired, as there is a chance of it burst-
ing while the repair operation is being performed. If you notice any cracks or
deformation of the tire, turn off the comp ressor switch and stop the repair opera-
tion immediately.
●The kit may overheat if operated for a long period of time. Do not operate the
compressor continuously for more than 35 minutes.
●Parts of the kit become hot during operation. Be careful handling the kit during
and after operation. Do not touch the metal part around the connecting area
between the bottle and compressor. It will be extremely hot.
●Do not attach the vehicle speed warning sticker to an area other than the one
indicated. If the sticker is attached to an area where an SRS airbag is located,
such as the pad of the steering wheel, it may prevent the SRS air bag from operat-
ing properly.

5957-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
CAUTION
■Driving to spread the liquid sealant evenly
●Drive the vehicle carefully at a low speed. Be especially careful when turning and
cornering.
●If the vehicle does not drive straight or you feel a pull through the steering wheel,
stop the vehicle and check the following:
• Tire condition. The tire may have separated from the wheel.
• Tire inflation pressure. If tire inflation pressure is 130 kPa (1.3 kgf/cm2 o r b a r , 1 9
psi) or below, this may indicate severe tire damage.

6308-1. Specifications
LS600h/LS600hL_EE(OM50G20E)
*: Minimum pedal clearance when depressed with a force of 500 N (51 kgf, 112 lbf)
while the hybrid system is operating.
When performing the brake pedal inspection, also be sure to check that the
brake system warning light is not illuminated when the hybrid system is operating
(If the brake system warning light is illuminated, refer to P. 555).
Brakes
Pedal clearance*147 mm (5.8 in.) Min.
Pedal free play1.0 - 2.0 mm (0.04 - 0.08 in.)
Fluid typeSAE J1703 or FMVSS No.116 DOT 3 or,
SAE J1704 or FMVSS No.116 DOT 4
Steering
Free playLess than 30 mm (1.2 in.)
Tires and wheels
Tire size245/45R19 102Y
Tire inflation pres-
sure
(Recommended
cold tire inflation
pressure)
Vehicle speedFront wheel
kPa (kgf/cm2 or
bar, psi)
Rear wheel
kPa (kgf/cm2 or
bar, psi)
More than 210 km/h
(132 mph)290 (2.9, 42)290 (2.9, 42)
210 km/h
(132 mph) or less250 (2.5, 36)250 (2.5, 36)
Wheel size19  8 J
Wheel nut torque140 N•m (14.3 kgf•m, 103 ft•lbf)

670Alphabetical index
LS600h/LS600hL_EE(OM50G20E)
Side mirrors...............................................221
Adjusting and folding......................... 221
BSM (Blind Spot Monitor) ...........366
Linked mirror function when
reversing ............................................. 223
Mirror position memory................. 207
Side turn signal lights........................... 262
Replacing light bulbs........................ 543
Turn signal lever ................................. 262
Smart entry & start system................. 149
Antenna location..................................152
Entry functions.......................................149
Starting the hybrid system............. 247
Snow mode .............................................258
Snow tires................................................. 387
Spare tire .................................................. 567
Inflation pressure............................... 630
Storage location ................................ 568
Spark plug................................................ 627
Specifications .........................................620
Speedometer ............................................115
Sport mode.............................................. 334
Steering lock .......................................... 249
Column lock release ....................... 249
Steering wheel.........................................218
Adjustment ............................................. 218
Heated steering wheel ................... 454
Power easy access system.............190
Steering wheel position
memory .............................................. 207
Stop lights
Emergency brake signal................ 339
Replacing light bulbs ....................... 543
Storage feature .......................................431
Stuck
If the vehicle becomes stuck ......... 616
Sun shade
Rear .......................................................... 464
Rear door .............................................. 468
Roof .......................................................... 230
Sun visors ................................................. 445