Page 541 of 692
5417-3. Do-it-yourself maintenance
7
Maintenance and care
IS300h_EE(OM53D89E)
Remove any dirt or foreign matter
from the wheel contact surface.
If foreign matter is on the wheel contact
surface, the wheel nuts may loosen
while the vehicle is in motion, causing the tire to come off.
Install the spare tire and loosely tighte n each wheel nut by hand by approxi-
mately the same amount.
Turn the wheel nuts until the washers
come into contact with the disc
wheel.
Lower the vehicle.
Firmly tighten each wheel nut two or
three times in the order shown in the
illustration.
Tightening torque: 103 N•m (10.5 kgf•m, 76 ft•lbf)
Stow the jack and all tools.
Installing the tire
1
2
Disc wheel
Washer
3
4
5
Page 558 of 692
5587-3. Do-it-yourself maintenance
IS300h_EE(OM53D89E)
■Outer foot lights
Press the upper part of the out-
side rear view mirror to tilt the
mirror face upward, and apply
protective tape to the lower part
of the mirror cover.
Insert 2 flathead screwdrivers
wrapped in protective tape, and
disconnect the tabs behind the
mirror.
Pry the mirror out toward you, dis-
connecting the tabs 2 at a time.
Work carefully, ensuring that you do not drop the mirror.
Disconnect the connectors
behind the mirror, and remove
the mirror.
When removing the thin connectors,
make sure to mark one of the con-
nectors with a piece of tape, to avoid mixing them up when reinstalling.
Work carefully, ensuring that you do
not drop the mirror.
When handling the mirror, do not touch the parts applied with grease.
The number of connectors equipped differs by vehicle specification.
Remove the 5 screws and take off
the mirror’s outer cover and the
cover behind the mirror.
1
2
3
4
Page 565 of 692

565
8When trouble arises
IS300h_EE(OM53D89E)
8-1. Essential information
Emergency flashe rs ..................566
If your vehicle has to
be stopped in an
emergency................................. 567
8-2. Steps to take in an
emergency
If your vehicle needs to
be towed .....................................568
If you think something is
wrong ........................................... 574
If a warning light turns
on or a warning buzzer
sounds.......................................... 575
If a warning message is
displayed ..................................... 581
If you have a flat tire
(vehicles with
emergency tire puncture
repair kit) ..................................... 610
If you have a flat tire
(vehicles with run-flat
tires).............................................. 625
If the hybrid sy stem will not
start ............................................... 626
If the electronic key does
not operate properly ............. 628
If the 12-volt battery is
discharged .................................. 631
If your vehicle overheats ......... 636
If the vehicle becomes
stuck ...............................................641
Page 568 of 692
568
IS300h_EE(OM53D89E)
8-2. Steps to take in an emergency
The following may indicate a problem wi th your transmission. Contact any
authorized Lexus retailer or Lexus authoriz ed repairer, or any reliable repairer or
commercial towing service before towing.
●A warning message for the hybrid system is shown on the multi-information
display and the vehicle does not move.
●The vehicle makes an abnormal sound.
If your vehicle needs to be towed
If towing is necessary, we recommen d having your vehicle towed by any
authorized Lexus retailer or Lexus authorized repairer, or any reliable
repairer or commercial towing service, using a wheel-lift type truck or flatbed
truck.
Use a safety chain system for all towing, and abide by all state/provincial and
local laws.
Situations when it is necessary to contact dealers before towing
Page 569 of 692
5698-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
Do not tow with a sling-type truck to
prevent body damage.
Towing with a sling-type truck
Towing with a wheel-lift type truck
From the frontFrom the rear
Use a towing dolly under the rear
wheels.
Use a towing dolly under the front
wheels.
Page 570 of 692
5708-2. Steps to take in an emergency
IS300h_EE(OM53D89E)
If your vehicle is transported by a flat-
bed truck, it should be tied down at the
locations shown in the illustration.
If you use chains or cables to tie down
your vehicle, the angles shaded in black
must be 45 .
Do not overly tighten the tie downs or
the vehicle may be damaged.
If a tow truck is not available in an em ergency, your vehicle may be temporarily
towed using cables or chains secured to the emergency towing eyelets. This
should only be attempted on hard surf aced roads for short distances at under 30
km/h (18 mph).
A driver must be in the vehicle to st eer and operate the brakes. The vehicle’s
wheels, drive train, axles, steering an d brakes must be in good condition.
Using a flatbed truck
Emergency towing
Page 571 of 692
5718-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
Take out the towing eyelet. (P. 537)
Remove the eyelet cover using a flat-
head screwdriver.
To protect the bodywork, place a rag between the screwdriver and the vehi-
cle body as shown in the illustration.
Insert the towing eyelet into the hole
and tighten partially by hand.
Tighten down the towing eyelet
securely using a wheel nut wrench
or hard metal bar.
Securely attach cables or chains to the towing eyelet.
Take care not to damage the vehicle body.
Enter the vehicle being towed and start the hybrid system.
If the hybrid system does not start, turn the power switch to ON mode.
Shift the shift lever to N and release the parking brake.
When the shift lever cannot be shifted: P. 231
Emergency towing procedure
1
2
3
4
5
6
7
Page 572 of 692

5728-2. Steps to take in an emergency
IS300h_EE(OM53D89E)
■While towing
If the hybrid system is off, the power assist for the brakes and steering will not function,
making steering and braking more difficult.
■Wheel nut wrench
Wheel nut wrench is installed in the trunk. ( P. 537)
WARNING
Observe the following precautions. Failure to do so may result in death or serious injury.
■When towing the vehicle
■While towing
●When towing using cables or chains, avoid sudden starts, etc. which place excessive
stress on the towing eyelets, cables or chains. The towing eyelets, cables or chains may become damaged, broken debris ma y hit people, and cause serious damage.
●Do not turn the power switch off.
There is a possibility that the steering wheel is locked and cannot be operated.
■Installing towing eyelet to the vehicle
Make sure that towing eyel et is installed securely.
If not securely installed, towing ey elet may come loose during towing.
Be sure to transport the vehicle with all four
wheels raised off the ground. If the vehicle is
towed with the tires contacting the ground, the
drivetrain and related parts may be damaged, an accident may occur due to a change in
direction of the vehicle or electricity generated
by the operation of the motor may cause a fire to occur depending on the nature of the dam-
age or malfunction.