2017 Lexus IS300h fuse

511
7
Maintenance and care
IS300h_EE(OM53D89E)
7-3. Do-it-yourself maintenance
Do-it-yourself service precautions
If you perform maintenance by yourself, be sure to follow the correct proce-
dure as given in these sections.
ItemsParts and tools
12-volt battery con-
dition ( P. 522)
•Grease
• Conventional wrench (for terminal clamp bolts)
Engine/power con- trol unit coolant level
( P. 519)
• “Toyota Super Long Life Coolant” or a similar high quality ethylene glycol-based non-silicate, non-amine, non-nitrite
and non-borate coolant with long-life hybrid organic acid
technology “Toyota Super Long Life Coolant” is pre-mixed with 50%
coolant and 50% deionized water.
• Funnel (used only for adding coolant)
Engine oil level ( P. 516)
• “Toyota Genuine Motor Oil” or equivalent
• Rag or paper towel
• Funnel (used only for adding engine oil)
Fuses (P. 552)• Fuse with same amperage rating as original
Light bulbs
( P. 556)
• Bulb with same number and wattage rating as original
• Phillips-head screwdriver•Flathead screwdriver
•Wrench
Radiators and con-
denser ( P. 521)
Tire inflation pres-
sure ( P. 543)• Tire pressure gauge• Compressed air source
Washer fluid
( P. 521)
• Water or washer fluid containing antifreeze (for winter use)
• Funnel (used only for adding water or washer fluid)

5157-3. Do-it-yourself maintenance
7
Maintenance and care
IS300h_EE(OM53D89E)
■12-volt battery
 P. 522
Engine compartment
Power control unit coolant reser-
voir ( P. 519)
Engine oil level dipstick
( P. 516)
Engine coolant reservoir
( P. 519)
Engine oil filler cap
( P. 517)
Fuse box ( P. 552)
Washer fluid tank ( P. 521)
Electric cooling fans
Condenser ( P. 521)
Power control unit coolant
radiator ( P. 521)
Engine coolant radiator
( P. 521)
1
2
3
4
5
6
7
8
9
10

5527-3. Do-it-yourself maintenance
IS300h_EE(OM53D89E)
Turn the power switch off.
Open the fuse box cover.
Engine compartment:
Remove the clips.
Push the tabs on either side to
detach the lock and lift the lid off
while pulling the lock plate.
When installing the lid, check that the
lock plate and the tabs on either side
are connected correctly.
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If
this happens, check and repl ace the fuses as necessary.
1
2

5537-3. Do-it-yourself maintenance
7
Maintenance and care
IS300h_EE(OM53D89E)
Remove the fuse with the pullout
tool.
Only type A fuses can be removed
using the pullout tool.
Left side instrument panel (left-hand
drive vehicles)
Left side instrument panel (right-
hand drive vehicles)
Remove the lid. Remove the lid.
3

5547-3. Do-it-yourself maintenance
IS300h_EE(OM53D89E)
Check if the fuse is blown.
Normal fuse
Blown fuse
Type A and B:
Replace the blown fuse with a new fuse of an appropriate amperage rating. The amperage rating can be fo und on the fuse box lid.
Type C and D:
Contact any authorized Lexus retailer or Le xus authorized repairer, or any reliable repairer.
4
1
2
Type AType B
Type CType D

5557-3. Do-it-yourself maintenance
7
Maintenance and care
IS300h_EE(OM53D89E)
■After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb may need
replacement. ( P. 556)
●If the replaced fuse blows again, have the vehicle inspected by any authorized Lexus
retailer or Lexus authorized re pairer, or any reliable repairer.
■If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
■When replacing light bulbs
Lexus recommends that you use genuine Lexus products designed for this vehicle. Because certain bulbs are connected to circui ts designed to prevent overload, non-gen-
uine parts or parts not designed for this vehicle may be unusable.
WARNING
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to th e vehicle, and possibly a fire or injury.
●Never use a fuse of a higher amperage rating than that indicated, or use any other object in place of a fuse.
●Always use a genuine Lexus fuse or equivalent.
Never replace a fuse with a wi re, even as a temporary fix.
●Do not modify the fuses or fuse boxes.
■Fuse box near the power control unit
Never check or replace the fuses as there are high voltage parts and wiring near the fuse box.
Doing so may cause electric shock, re sulting in death or serious injury.
NOTICE
■Before replacing fuses
Have the cause of electrical overload de termined and repaired by any authorized
Lexus retailer or Lexus authorized repairer, or any reliable repairer as soon as possible.

6268-2. Steps to take in an emergency
IS300h_EE(OM53D89E)
One of the following may be the cause of the problem:
●The electronic key may not be functioning properly. (P. 629)
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
●There may be a malfunction in the immobilizer system. ( P. 86)
●There may be a malfunction in the steering lock system.
●The hybrid system may be malfunctioning due to an electrical problem such
as electronic key battery depletion or a blown fuse. However, depending on
the type of malfunction, an interim meas ure is available to start the hybrid sys-
tem. ( P. 627)
One of the following may be the cause of the problem:
●The 12-volt battery may be discharged. ( P. 631)
●The 12-volt battery terminal connections may be loose or corroded.
( P. 522)
If the hybrid system will not start
Reasons for the hybrid system not starting vary depending on the situation.
Check the following and perfor m the appropriate procedure:
The hybrid system will not start even though the correct starting proce-
dure is being followed. ( P. 219)
The interior lights and headlights are dim, or the horn does not sound or
sounds at a low volume.

6318-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt
battery, you can jump start your ve hicle by following the steps below.
Confirm that the electronic key is
being carried.
When connecting the jumper (or booster) cables, depending on the situa-
tion, the alarm may activate and doors
locked. (P. 94)
Open the hood ( P. 513) and fuse
box cover.
Remove the clips.
Push the tabs on either side to
detach the lock and lift the lid off
while pulling the lock plate.
If the 12-volt battery is discharged
The following procedures may be used to start the hybrid system if the 12-volt
battery is discharged.
You can also call any authorized Lexus retailer or Lexus authorized repairer,
or any reliable repairer.
1
2
1
2