2017 KIA OPTIMA PLUG-IN HYBRID lock

(Continued)
•When you operate the steering
wheel in a low temperature, ab‐
normal noise could occur. If the
temperature rises, the noise will
disappear. This is a normal condi‐
tion.
Tilt & telescopic steering
A tilt and telescopic steering wheel al‐
lows you to adjust the steering wheel before you drive. You can also raise it
to give your legs more room when you
exit and enter the vehicle.
The steering wheel should be posi‐ tioned so that it is comfortable for you
to drive, while permitting you to see
the instrument panel warning lights and gauges.
WARNING
•Never adjust the angle of thesteering wheel while driving. Youmay lose steering control andcause severe personal injury,death or accidents.
(Continued)
(Continued)
•After adjusting, push the steeringwheel both up and down to be cer‐tain it is locked in position.
0+'
To change the steering wheel angle,
pull down the lock release lever (1), ad‐ just the steering wheel to the desired
angle (2) and height (3), then pull up
the lock-release lever (4) to lock the steering wheel in place. Be sure to ad‐
just the steering wheel to the desired
position before driving.
NOTICE
After adjustment, sometimes the
lock-release lever may not lock the
steering wheel.
It is not a malfunction. This occurs
when two gears engage. In this case,
adjust the steering wheel again and
then lock the steering wheel.

5-41
5
Features of your vehicle

Remote control
0+'-
The electric remote control mirror
switch allows you to adjust the position of the left and right outside rearview
mirrors. To adjust the position of either
mirror, press the R or L button (1) to select the right side mirror or the left
side mirror, then press a corresponding
point (
) on the mirror adjustment
control to position the selected mirror
up, down, left or right.
After adjustment, press the R or L but‐
ton again to prevent inadvertent ad‐ justment.
CAUTION
•The mirrors stop moving whenthey reach the maximum adjustingangles, but the motor continues tooperate while the switch is press‐ed. Do not press the switch longerthan necessary, the motor may bedamaged.
•Do not attempt to adjust the out‐side rearview mirror by hand. Do‐ing so may damage the parts.
Folding the outside rearview mirror
0+'
Manual type
To fold the outside rearview mirror,
grasp the housing of the mirror and then fold it toward the rear of the vehi‐
cle.
0+'-
Electric type
The outside rearview mirror can be fol‐
ded or unfolded by pressing the switch as below.
Left (1) : The mirror will unfold.Right (2) : The mirror will fold.Center (AUTO, 3) : The mirror will fold or
unfold automatically as follows: • Without smart key system - The mirror will fold or unfold whenthe door is locked or unlocked by the smart key.
Features of your vehicle
5-46

• With smart key system- The mirror will fold or unfold whenthe door is locked or unlocked by
the smart key.
- The mirror will fold or unfold when the door is locked or unlocked by
the button on the outside door
handle.
- The mirror will unfold when you approach the vehicle (all doors
closed and locked) with a smartkey in possession (if equipped).
CAUTION
The electric type outside rearviewmirror operates even though the En‐gine Start/Stop button is in the OFFposition. However, to prevent unnec‐essary battery discharge, do not ad‐just the mirrors longer than neces‐sary while the engine is not running.
CAUTION
In case it is an electric type outsiderearview mirror, don’t fold it byhand. It could cause motor failure.
Reverse parking aid function (if
equipped)
0+'
When you shift the shift lever to the R
(Reverse) position, the outside rearview mirror(s) will move downward to aid re‐
verse parking.
According to the position of the outside
rearview mirror switch, the outside
rearview mirror(s) will operate as fol‐
lows:
Left or Right
When the remote control outside rear‐ view mirror switch is in the left or right
position, both outside rearview mirrors
will move downward.
Neutral
When neither switch is selected, the
outside rearview mirrors will not move.
The outside rearview mirrors will auto‐
matically revert to their original posi‐ tion under the following conditions: 1. The Engine Start/Stop button is turned to the ACC or OFF position.
2. The shift lever is moved to any po‐ sition except R (Reverse).
3. The remote control outside rear‐ view mirror switch is not selected.

5-47
5
Features of your vehicle

Door/trunk
ItemsExplanation
Automatically Lock • Disable: The auto door lock operation will be deactivated.
• Enable on Speed: All doors will be automatically locked when the vehicle speed ex‐
ceeds 15 km/h (9.3 mph).
• Enable on Shift: All doors will be automatically locked if the automatic transaxle/ dual clutch transmission shift lever is shifted from the P (Park) position to the R(Reverse), N (Neutral), or D (Drive) position.
Automatically Unlock • Disable: The auto door unlock operation will be canceled.
• Vehicle Off/On key out: All doors will be automatically unlocked when the Engine
Start/Stop button is set to the OFF position.
• Driver Door Unlock: All doors will be automatically unlocked if the driver's door is unlocked.
On Shift to P: All doors will be automatically unlocked if the automatic transaxle/dual clutch transmission shift lever is shifted to the P (Park) position.
Door Lock Sound (if equipped) If this item checked, the door lock sound function will be activated when lockingdoors.
Smart Trunk (if equipped) To activate or deactivate the Smart Trunk system.
For more details, refer to L

• At this time, the Engine Start/StopButton turns to the ACC position (If
you press the Engine Start/Stop But‐ ton once more, it will turn to the ON
position).
Low key battery (for smart key
system)
• This warning message illuminates if the battery of the smart key is dis‐
charged when the Engine Start/Stop Button changes to the OFF position.
Press START button while turning
wheel (for smart key system)
• This warning message illuminates if the steering wheel does not unlock
normally when the Engine Start/Stop Button is pressed.
• It means that you should press the Engine Start/Stop Button while turn‐
ing the steering wheel right and left.
Steering wheel unlocked (for smart
key system)
• This warning message illuminates if the steering wheel does not lock
when the Engine Start/Stop Button changes to the OFF position.
Check steering wheel lock system
(for smart key system)
• This warning message illuminates if the steering wheel does not lock nor‐
mally when the Engine Start/Stop
Button changes to the OFF position.
Press brake pedal to start engine
(for smart key system)
• This warning message illuminates if the Engine Start/Stop Button
changes to the ACC position twice by pressing the button repeatedly with‐
out depressing the brake pedal.
• It means that you should depress the brake pedal to start the engine.
Key not in vehicle (for smart key
system)
• This warning message illuminates if the smart key is not in the vehicle
when you press the Engine Start/ Stop Button.
• It means that you should always have the smart key with you.
Key not detected (for smart key
system)
• This warning message illuminates if the smart key is not detected when
you press the Engine Start/Stop But‐
ton.
Press start button again (for smart
key system)
• This warning message illuminates if you cannot operate the Engine Start/
Stop Button when there is a problem with the Engine Start/Stop Button
system.
• It means that you could start the en‐ gine by pressing the Engine Start/
Stop Button once more.
• If the warning illuminates each time you press the Engine Start/Stop But‐ton, we recommend that you have
the vehicle inspected by an author‐
ized Kia dealer.
Press start button with key (for
smart key system)
• This warning message illuminates if you press the Engine Start/Stop But‐
ton while the warning message L

If the brakes fail while you are driving,
shift to a lower gear for additional en‐ gine braking and stop the vehicle as
soon as it is safe to do so.
WARNING
nParking Brake & Brake FluidWarning Light
Driving the vehicle with a warninglight ON is dangerous. If the ParkingBrake & Brake Fluid Warning Light il‐luminates with the parking brake re‐leased, it indicates that the brakefluid level is low.In this case, we recommend that youhave the vehicle inspected by an au‐thorized Kia dealer.
Regenerative brake
warning light
This warning light illumi‐nates:
When the regenerative
brake does not operate and the brake does not performwell. This causes the Brake
Warning light (red) and Regenerative Brake Warning Light (yellow) to illumi‐
nate simultaneously.
SFE
DPMPS

ZFMMPX
DPMPS

In this case, drive safely and we recom‐
mend that you have your vehicle in‐ spected by an authorized Kia dealer.
The operation of the brake pedal may
be more difficult than normal and the
braking distance can increase.
Anti-lock brake system
(ABS) warning light
This warning light illumi‐nates:
• Once you set the Engine Start/Stop Button to the ON position.- It illuminates for approximately 3 seconds and then goes off.
• When there is a malfunction with the ABS (The normal braking system will
still be operational without the assis‐
tance of the anti-lock brake system).
In this case, we recommend that you have the vehicle inspected by an au‐
thorized Kia dealer.
Electronic brake force
distribution (EBD)
system warning light
These two warning lights il‐luminate at the same timewhile driving:
• When the ABS and regular brake system may not
work normally.
In this case, we recommend that you have the vehicle inspected by an au‐
thorized Kia dealer.
NOTICE
nElectronic Brake force Distri‐
bution (EBD) System Warning
Light
When the ABS Warning Light is on or
both ABS and Parking Brake & Brake
Fluid Warning Lights are on, the
speedometer, odometer, or tripme‐
ter may not work. Also, the EPS
Warning Light may illuminate and
the steering effort may increase or
decrease.
(Continued)
Features of your vehicle
5-80

CAUTION
•This system can only sense objects within the range and location of the sensors.It cannot detect objects in other areas where sensors are not installed. Also, small or slim objects, such as poles or ob‐jects located between sensors may not be detected by the sensors.Always visually check behind the vehicle when backing up.
•Be sure to inform any drivers of the vehicle that may be unfamiliar with the system regarding the systems capabilitiesand limitations.

Non-operational conditions of
parking assist system
Parking assist system may not
operate normally when:
1. Moisture is frozen to the sensor. (Itwill operate normally when mois‐
ture melts.)
2. Sensor is covered with foreign mat‐ ter, such as snow or water, or the
sensor cover is blocked. (It will op‐
erate normally when the material
is removed or the sensor is no lon‐
ger blocked.)
3. The parking assist button is off.
There is a possibility of parking
assist system malfunction when:
1. Driving on uneven road surfaces such as unpaved roads, gravel,
bumps, or gradient.
2. Objects generating excessive noise such as vehicle horns, loud motor‐
cycle engines, or truck air brakes
can interfere with the sensor.
3. Heavy rain or water spray.
4. Wireless transmitters or mobile phones present near the sensor.
5. Sensor is covered with snow.
Detecting range may decrease
when:
1. Outside air temperature is ex‐ tremely hot or cold. 2. Undetectable objects smaller than
1 m and narrower than 14 cm in di‐
ameter.
The following objects may not be
recognized by the sensor:
1. Sharp or slim objects such as ropes,chains or small poles.
2. Objects, which tend to absorb sen‐ sor frequency such as clothes,
spongy material or snow.
Features of your vehicle
5-92

LIGHTING
Battery saver function
• The purpose of this feature is to pre‐vent the battery from being dis‐
charged. The system automatically
turns off the parking lights when the driver removes the ignition key and
opens the driver-side door.
• With this feature, the parking lights will turn off automatically if the driv‐
er parks on the side of the road at
night.
If necessary, to keep the lights on when the ignition key is removed,
perform the following: 1. Open the driver-side door.
2. Turn the parking lights OFF and ON again using the light switch on the
steering column.
CAUTION
If the driver gets out of the vehiclethrough other doors (except driver'sdoor), the battery saver functiondoes not operate. Therefore, It cau‐ses the battery to be discharged. Inthis case, make sure to turn off thelamp before getting out of the vehi‐cle.
Headlight escort function (if
equipped)
If you turn the ignition switch to the
ACC or OFF position with the headlights ON, the headlights remain on for about
5 minutes. However, if the driver's door
is opened and closed, the headlights are turned off after 15 seconds.
The headlights can be turned off by
pressing the lock button on the trans‐
mitter (or smart key) twice or turning the light switch to the OFF position.
Daytime running light (if
equipped)
The Daytime Running Lights (DRL) can
make it easier for others to see the front of your vehicle during the day.
DRL can be helpful in many different
driving conditions, and it is especially helpful after dawn and before sunset.
The DRL system will turn the dedicated
lamp OFF when: 1. The headlight or fog lamp switch is ON.
2. The engine is OFF.
❈
Traffic Change (For Europe)
The low beam light distribution is
asymmetric. If you go abroad to a
country with opposite traffic direc‐ tion, this asymmetric part will daz‐
zle oncoming car driver. To prevent
dazzle, ECE regulation demand sev‐
eral technical solutions (ex. auto‐ matic change system, adhesive
sheet, down aiming). This head‐
lamps are designed to adjust in
user setting mode in cluster.
Lighting control
The light switch has a Headlight and a
Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions: 1. OFF position
2. Auto light / AFLS position
Features of your vehicle
5-114