2017 KIA OPTIMA PLUG-IN HYBRID engine

HEV POWERTRAIN
By following a few simple precautions for the first 1,000 km (600 miles) you
may add to the performance, economy
and life of your vehicle. • Do not race the engine.
• Avoid hard stops, except in emergen‐ cies, to allow the brakes to seatproperly.

2-07
2
Introduction

Exterior overview...................................................................... 3-02
Interior overview....................................................................... 3-04
Instrument panel overview......................................................3-05
Engine compartment................................................................ 3-07
Your vehicle at a glance

3

INSTRUMENT PANEL OVERVIEW
❈
5IF
BDUVBM
TIBQF
NBZ
EJGGFS
GSPN
UIF
JMMVTUSBUJPO
1. Steering wheel audio controls................ ................ p. 6-03
2. Driver’s front air bag........................ ........................ p. 4-51
3. Horn...................................... ...................................... p. 5-42
4. Instrument cluster.......................... .......................... p. 5-48
5. Wiper and washer control lever............................ p. 5-122
6. Engine start/stop button.................... .................... p. 7-06
7. Cruise control.............................. .............................. p. 7-47
Speed limit control.......................... .......................... p. 7-55
Advanced smart cruise control system........ ........ p. 7-59
8. Audio...................................... ...................................... p. 6-02
9. Hazard warning flasher...................... ...................... p. 8-02
10. Automatic climate control system........... ........... p. 5-137
11. Shift lever A/T.............................. .............................. p. 7-11
12. Heated steering wheel button................ ................ p. 5-42
13. Drive mode button.......................... .......................... p. 7-75 Active Eco button........................... ........................... p. 7-75
14. Seat warmer.............................. .............................. p. 5-155 Air ventilation seat.................................................. p. 5-156
15. Electronic parking brake (EPB) switch......... ......... p. 7-19
16. Auto Hold On/Off button.......................................... p. 7-24

3-05
3
Your vehicle at a glance

ENGINE COMPARTMENT
(BTPMJOF
&OHJOF
/V
-

(%*

5IF
BDUVBM
FOHJOF
SPPN
JO
UIF
WFIJDMF
NBZ
EJGGFS
GSPN
UIF
JMMVTUSBUJPO
1. Engine coolant reservoir..................... ..................... p. 9-28
2. Engine oil filler cap.......................... .......................... p. 9-24
3. Engine oil dipstick........................... ........................... p. 9-24
4. Brake fluid reservoir.................................................. p. 9-30
5. Air cleaner................................. ................................. p. 9-33
6. Fuse box................................... ................................... p. 9-52
7. Inverter coolant reservoir.................... .................... p. 9-27
8. Radiator cap............................... ............................... p. 9-28
9. Windshield washer fluid reservoir............. ............. p. 9-31

3-07
3
Your vehicle at a glance

Lumbar support (if equipped)
The lumbar support can be adjusted by
pressing the lumbar support switch on the side of the Driver's seat. 1. Press the front portion of the switch to increase support, or the
rear portion of the switch, to de‐
crease support.
2. Release the switch once it reaches the desired position.
Front seat adjustment - power
(if equipped)
The front seat can be adjusted by usingthe control switches located on the
outside of the seat cushion. Before
driving, adjust the seat to the proper position so you can easily control the
steering wheel, pedals and switches on
the instrument panel.
WARNING
The power seat is operable with theengine start/stop button in OFF.Therefore, children should never beleft unattended in the vehicle.
CAUTION
•The power seat is driven by anelectric motor. Stop operating oncethe adjustment is completed. Ex‐cessive operation may damage theelectrical equipment.
(Continued)
(Continued)
•When in operation, the power seatconsumes a large amount of elec‐trical power. To prevent unneces‐sary charging system drain, don’tadjust the power seat longer thannecessary while the engine is notrunning.
•Do not operate two or more powerseat control switches at the sametime. Doing so may result in powerseat motor or electrical compo‐nent malfunction.
Safety features of your vehicle
4-06

Lumbar support (if equipped)
0+'-
The lumbar support can be adjusted by
pressing the lumbar support switch on the side of the seat. 1. Press the front portion (1) of the switch to increase support, or the
rear portion (2) of the switch, to
decrease support.
2. Release the switch once it reaches the desired position.
3. Press the upper portion (3) of the switch to move the support posi‐
tion up, or press the lower portion
(4) of the switch, to move the sup‐
port position down. 4. Release the switch once it reaches
the desired position.
Driver position memory system
(if equipped, for power seat)
0+'-
A driver position memory system is
provided to store and recall the driver seat and outside rearview mirror posi‐
tion with a simple button operation. By
saving the desired position into the system memory, different drivers can
reposition the driver seat based upon
their driving preference. If the battery is disconnected, the position memory
will be erased and the driving position
should be restored in the system.
WARNING
Never attempt to operate the driverposition memory system while thevehicle is moving.This could result in loss of control,and an accident causing death, seri‐ous injury, or property damage.
Storing positions into memory
using the buttons on the door
Storing driver's seat positions
1. Shift the shift lever into P (for Au‐ tomatic transaxle) while the engine
start/stop button is ON.
2. Adjust the driver’s seat and outside rearview mirror comfortable for
the driver.
3. Press SET button on the control panel. The system will beep once.
4. Press one of the memory buttons (1 or 2) within 5 seconds after
pressing the SET button. The sys‐ tem will beep twice when memory
has been successfully stored.
Safety features of your vehicle
4-08

Recalling positions from memory
1. Shift the shift lever into P (for Au‐ tomatic transaxle) while the engine
start/stop button is ON.
2. To recall the position in the memo‐ ry, press the desired memory but‐
ton (1 or 2). The system will beep
once, then the driver’s seat will au‐
tomatically adjust to the stored po‐
sition.
Adjusting the control switch for the
driver’s seat while the system is recall‐
ing the stored position will cause the movement to stop and move in the di‐
rection that the control switch is
moved.
WARNING
Use caution when recalling the ad‐justment memory while sitting inthe vehicle. Push the seat positioncontrol switch to the desired positionimmediately if the seat moves toofar in any direction.
Easy access function (if equipped)
The system will move the driver's seat
automatically as follows: • With smart key system
- It will move the driver’s seat rear‐ward when the engine start/stop
button is changed to the OFF posi‐
tion and front driver’s door is
opened.
- It will move the driver’s seat for‐ ward when the engine start/stop
button is changed to the ACC or
START position.
- It will move the driver's seat for‐ ward when you get in your vehicle
with the smart key after closing
the driver's door.
You can activate or deactivate this fea‐
ture. Refer to L

CAUTION
nRear seat belts
When returning the rear seatbacksto the upright position, remember toreturn the rear shoulder belts totheir proper position.
WARNING
nCargo
Cargo should always be secured toprevent it from being thrown aboutthe vehicle in a collision and causinginjury to the vehicle occupants. Donot place objects in the rear seats,since they cannot be properly se‐cured and may hit the front seat oc‐cupants in a collision.
WARNING
nCargo loading
Make sure the engine is off, the au‐tomatic transaxle is in P (Park) and
(Continued)
(Continued)
the parking brake is securely appliedwhenever loading or unloading cargo.Failure to take these steps may al‐low the vehicle to move if the shiftlever is inadvertently moved to an‐other position.

4-17
4
Safety features of your vehicle