2017 KIA OPTIMA PLUG-IN HYBRID tire pressure

(Continued)
Do not use the tire sealant after thesealant has expired (i.e. past the ex‐piration date on the sealant contain‐er). This can increase the risk of tirefailure.
WARNING
nSealant
•Keep out of reach of children.
•Avoid contact with eyes.
•Do not swallow.
Strictly follow the specified sequence,
otherwise the sealant may escape un‐ der high pressure.
0+'
CAUTION
Before using the tire repair kit,please read carefully the instructionattached on the sealant case. Detachthe speed limit label on the sealantcase and put it on a highly visibleplace. Always drive within the speedlimit.
Using the TMK
Carefully follow below steps.
05".
1. Shake the sealant case.
0+')
2. Screw connection hose (10) onto the connector of the sealant bottle.

8-17
8
What to do in an emergency

3. Ensure that button (9) on the com‐pressor is not pressed.
0+')
4. Unscrew the valve cap from thevalve of the flat tire and screw fill‐
ing hose (3) of the sealant bottle
onto the valve.
5. Insert the sealant bottle into the housing (5) of the compressor so
that the bottle is upright.
6. Ensure that the compressor is switched off, position 0.
WARNING
If sealant is dispersed when the in‐jection hose and tire air injectionvalve have not been fully connected,the sealant may overflow and clogthe valve.
0+'"
7. Connect between compressor andthe vehicle power outlet using the
cable and connectors (4).
8. With the engine start/stop button position on or ignition switch posi‐
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to L

WARNING
nCarbon monoxide
Carbon monoxide poisoning and suf‐focation is possible if the engine isleft running in a poorly ventilated orunventilated location (such as insidea building).
Distributing the sealant
11. Immediately drive approximately7~10 km (4~6 miles or, about 10
min) to evenly distribute the seal‐
ant in the tire.
CAUTION
Do not exceed a speed of 80 km/h(50 mph). If possible, do not fall be‐low a speed of 20 km/h (12 mph).While driving, if you experience anyunusual vibration, ride disturbanceor noise, reduce your speed anddrive with caution until you cansafely pull off of the side of theroad. Call for road side service ortowing.
(Continued)
(Continued)
When you use the Tire Mobility Kit,the tire pressure sensors and wheelmay be stained by sealant. There‐fore, remove the tire pressure sen‐sors and wheel stained by sealantand we recommend to have it in‐spected by an authorized Kia dealer.
Checking the tire inflation
pressure
0+')
1. After driving approximately 7~10 km (4~6 miles, or about 10
minutes), stop at a suitable loca‐
tion. 2. Connect connection hose (10) of
the compressor directly to the tire
valve.
3. Connect between compressor and the vehicle battery using the cable
and connectors.
4. Adjust the tire inflation pressure to 200 kPa (29 psi). With the ignition
switched on, proceed as follows. -
To increase the inflation pres‐sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly switch off the compressor.
WARNING
Do not let the compressor run formore than 10 minutes, otherwisethe device will overheat and may bedamaged.
-To reduce the inflation pressure:
Press the button (9) on the com‐
pressor.

8-19
8
What to do in an emergency

CAUTION
If the inflation pressure is not main‐tained, drive the vehicle a secondtime, refer to Distributing the seal‐ant. Then repeat steps 1 to 4.Use of the TMK may be ineffectualfor tire damage larger than approxi‐mately 4 mm (0.16 in).We recommend that you contact anauthorized Kia dealer if the tire can‐not be made roadworthy with theTire Mobility Kit.
WARNING
The tire inflation pressure must beat least 200 kPa (29 psi). If it is not,do not continue driving.Call for road side service or towing.
Notes on the safe use of the
Tire Mobility Kit
• Park your car at the side of the roadso that you can work with the TMK
away from moving traffic. Place your warning triangle in a prominent place
to make passing vehicles aware of
your location. • To be sure your vehicle will not move,
even when you're on fairly level
ground, always set your parking brake.
• Only use the TMK for sealing/inflation passenger car tires. Do not use on
motorcycles, bicycles or any other
type of tires.
• Do not remove any foreign objects such as nails or screws -that have
penetrated the tire.
• Before using the TMK, read the pre‐ cautionary advice printed on the seal‐ ant bottle!
• Provided the car is outdoors, leave the engine running. Otherwise oper‐
ating the compressor may eventually
drain the car battery.
• Never leave the TMK unattended while it is being used.
• Do not leave the compressor running for more than 10 min. at a time or it
may overheat.
• Do not use the TMK if the ambient temperature is below -30°C (-22°F).
• When the tire and wheel are dam‐ aged, do not use Tire Mobility Kit foryour safety.
Technical data
System voltage: DC 12 V
Working voltage: DC 10 - 15 VAmperage rating: max. 15 A
Suitable for use at temperatures:
-30 ~ +70°C (-22 ~ +158°F)
Max. working pressure: 6 bar (87 psi)Size
Compressor: 168 x 150 x 68 mm (6.6 x 5.9 x 2.7 in)
Sealant bottle: 104 x 85 ø mm
(4.1 x 3.3 ø in.)
Compressor weight: 1.05 kg (2.31 lbs)
Sealant volume: 300 ml (18.3 cu. in.) ❈ Sealant and spare parts can be ob‐
tained and replaced at an author‐
ized vehicle or tire dealer. Empty
sealant bottles may be disposed of
at home. Liquid residue from the
sealant should be disposed of by
your vehicle or tire dealer or in ac‐
cordance with local waste disposal
regulations.
What to do in an emergency
8-20

EMERGENCY COMMODITY (IF EQUIPPED)
There are some emergency commodi‐ ties in the vehicle to help you respond
to the emergency situation.
First aid kit
There are some items such as scissors,
bandage and adhesive tape and etc. in the kit to give first aid to an injured
person.
Triangle reflector
Place the triangle reflector on the road
to warn oncoming vehicles during emergencies, such as when the vehicle
is parked by the roadside due to any
problems.
Tire pressure gauge (if
equipped)
Tires normally lose some air in day-to-
day use, and you may have to add a few pounds of air periodically and it is
not usually a sign of a leaking tire, but
of normal wear. Always check tire pres‐ sure when the tires are cold because
tire pressure increases with tempera‐
ture.
To check the tire pressure, take the fol‐ lowing steps: 1. Unscrew the inflation valve cap that is located on the rim of the
tire. 2. Press and hold the gauge against
the tire valve. Some air will escape
as you begin and more will escape
if you don't press the gauge in
firmly.
3. A firm non-leaking push will acti‐ vate the gauge.
4. Read the tire pressure on the gauge to know whether the tire
pressure is low or high.
5. Adjust the tire pressures to the specified pressure. Refer to L

Wiper blades...............................................................................9-36Blade inspection.................................................................... 9-36
Blade replacement................................................................ 9-36
Battery........................................................................................9-39 For best battery service...................................................... 9-39
Battery capacity label.......................................................... 9-40
Battery recharging................................................................9-41
Reset items............................................................................ 9-41
Tires and wheels....................................................................... 9-43 Tire care.................................................................................. 9-43
Recommended cold tire inflation pressures..................... 9-43
Checking tire inflation pressure.......................................... 9-44
Tire rotation........................................................................... 9-45
Wheel alignment and tire balance...................................... 9-46
Tire replacement................................................................... 9-46
Wheel replacement............................................................... 9-47
Tire traction........................................................................... 9-48
Tire maintenance.................................................................. 9-48
Tire sidewall labeling............................................................ 9-48
Low aspect ratio tire ........................................................... 9-51
Fuses........................................................................................... 9-52 Inner panel fuse replacement............................................. 9-53
Engine compartment fuse replacement........................... 9-54
Fuse/relay panel description............................................... 9-56
Light bulbs.................................................................................. 9-70 Bulb replacement precaution.............................................. 9-70
Light bulb position (front)................................................... 9-72
Light bulb position (rear)..................................................... 9-73
Light bulb position (side)......................................................9-73
Headlamp (HID type) bulb replacement............................ 9-74 Headlamp (low beam) bulb replacement.......................... 9-74
Headlamp (high beam) bulb replacement......................... 9-75
Headlamp (high/low beam) LED replacement..................9-76
Front turn signal lamp bulb replacement......................... 9-76
Position lamp + DRL (LED type) bulb replacement..........9-77
Side repeater lamp bulb replacement............................... 9-77
Rear turn signal lamp bulb replacement........................... 9-77
Stop and tail lamp (LED type) bulb replacement............. 9-79
Back-up lamp bulb replacement........................................ 9-79
License plate lamp bulb replacement................................ 9-80
High mounted stop lamp bulb replacement..................... 9-81
Map lamp bulb replacement................................................ 9-81
Vanity mirror lamp bulb replacement............................... 9-81
Room lamp bulb replacement............................................. 9-82
Personal lamp bulb replacement........................................ 9-83
Glove box lamp bulb replacement...................................... 9-83
Trunk lamp bulb replacement............................................. 9-83
Appearance care........................................................................9-85 Exterior care.......................................................................... 9-85
Interior care........................................................................... 9-89
Emission control system ........................................................ 9-91 Crankcase emission control system.................................. 9-91
Evaporative emission control system............................... 9-91
Exhaust emission control system...................................... 9-91


9

OWNER MAINTENANCE
The following lists are vehicle checks
and inspections that should be per‐
formed at the frequencies indicated to help ensure safe, dependable operation
of your vehicle.
Any adverse conditions should be
brought to the attention of your dealer as soon as possible.
These Owner Maintenance Checks are
generally not covered by warranties
and you may be charged for labor, parts and lubricants used.
Owner maintenance schedule
When you stop for fuel:
• Check the engine oil level.
• Check the coolant level in the coolant reservoir.
• Check the windshield washer fluid level.
• Look for low or under-inflated tires.
WARNING
Be careful when checking your en‐gine coolant level when the engine ishot. Scalding hot coolant and steam
(Continued)
(Continued)
may blow out under pressure. Thiscould cause burns or other seriousinjury.
While operating your vehicle:
• Note any changes in the sound of the exhaust or any smell of exhaust
fumes in the vehicle.
• Check for vibrations in the steering wheel. Notice any increased steering
effort or looseness in the steering
wheel, or change in its straight-
ahead position.
• Notice if your vehicle constantly turns slightly or L

MAINTENANCE INTERVALS
Normal Maintenance Schedule - For Gasoline Engine [For Europe (Except Russia)]
Number of months or driving distance, whichever comes first
Months1224364860728496
Miles×1,0001020304050607080
Km×1,000153045607590105120
MAINTENANCE ITEM
Fuel additives (Gasoline) *3
Add every 15,000 km (10,000 miles) or 12 months
Fuel filter (Gasoline) - I - R - I - R
Fuel lines, hoses and connections - - - I - - - IFuel tank air filter - I - R - I - R
HSG (Hybrid Starter & Generator) belt *4
I I I I I I R I
Parking brake - I - I - I - I
Spark plugs *5
Nu 2.0L GDI Replace every 150,000 km (100,000 miles) or 120 months
Steering gear rack, linkage and boots I I I I I I I I
Suspension ball joints I I I I I I I I
Tire (pressure & tread wear) I I I I I I I I
Vacuum hoses and crankcase ventilation hoses I I I I I I I I
Vapor hose and fuel filler cap - - - I - - - I
I: Inspect and if necessary, adjust, correct, clean or replace.
R: Replace or change.


9-11
9
Maintenance