2017 KIA OPTIMA PLUG-IN HYBRID light

(Continued)
•Always check the surroundingareas near your vehicle for people,especially children, before shiftinga vehicle into D (Drive) or R (Re‐verse).
•Before leaving the driver’s seat, al‐ways make sure the shift lever isin the P (Park) position; then setthe parking brake fully and shutthe engine off. Unexpected andsudden vehicle movement can oc‐cur if these precautions are notfollowed in the order identified.
•Do not use the engine brake (shift‐ing from a high gear to lower gear)rapidly on slippery roads.The vehicle may slip causing an ac‐cident.
CAUTION
•To avoid damage to your trans‐axle, do not accelerate the enginein R (Reverse) or any forward gearposition with the brakes on.
(Continued)
(Continued)
•When stopped on an uphill grades,do not hold the vehicle stationarywith engine power. Use the brakepedal or the parking brake.
•Do not shift from N (Neutral) or P(Park) into D (Drive), or R (Reverse)when the engine is above idlespeed.
Transaxle ranges
The indicator lights in the instrument
cluster displays the shift lever position when the engine start/stop button
switch is in the ON position.
P (Park)
Always come to a complete stop before
shifting into P (Park). This position locks the transaxle and prevents the
front wheels from rotating.
To shift from P (Park), you must de‐
press firmly on the brake pedal and make sure your foot is off the acceler‐
ator pedal.
If you have done all of the above andstill cannot shift the lever out of P(Park), see L

BRAKE SYSTEM
Power brakes
Your vehicle has power-assisted brakes
that adjust automatically through nor‐ mal usage.
If the hybrid system is not on or is
turned off while driving, the power as‐
sist for the brakes will not work. You can still stop your vehicle by applying
greater force to the brake pedal than
typical. The stopping distance, however,will be longer than with power brakes.
When the hybrid system is not on, the reserve brake power is partially deple‐
ted each time the brake pedal is ap‐
plied. Do not pump the brake pedal when the power assist has been inter‐
rupted.
Pump the brake pedal only when nec‐
essary to maintain steering control on slippery surfaces.
WARNING
nBrakes
(Continued)
(Continued)
•Do not drive with your foot restingon the brake pedal. This will createabnormal high brake tempera‐tures, excessive brake lining andpad wear, and increased stoppingdistances.
•When descending a long or steephill, shift to a lower gear and avoidcontinuous application of thebrakes. Continuous brake applica‐tion will cause the brakes to over‐heat and could result in a tempo‐rary loss of braking performance.
•Wet brakes may impair the vehi‐cle’s ability to safely slow down;the vehicle may also pull to oneside when the brakes are applied.Applying the brakes lightly will in‐dicate whether they have been af‐fected in this way.Always test your brakes in thisfashion after driving through deepwater. To dry the brakes, applythem lightly while maintaining asafe forward speed until brakeperformance returns to normal.
(Continued)
(Continued)
•Always confirm the position of thebrake and accelerator pedal beforedriving. If you don’t check the posi‐tion of the accelerator and brakepedal before driving, you may de‐press the accelerator instead ofthe brake pedal. It may cause a se‐rious accident.
NOTICE
Do not depress the brake pedal con‐
tinuously without the "" indicator
ON. The battery may be discharged.
Disc brakes wear indicator
When your brake pads are worn and
new pads are required, you will hear a high-pitched warning sound from your
front brakes or rear brakes (if equip‐
ped). You may hear this sound come and go or it may occur whenever you
depress the brake pedal.

7-17
7
Driving your vehicle

Please remember that some driving
conditions or climates may cause a brake squeal when you first apply (or
lightly apply) the brakes. This is normal
and does not indicate a problem with your brakes.
CAUTION
•To avoid costly brake repairs, donot continue to drive with wornbrake pads.
•Always replace the front or rearbrake pads as pairs.
WARNING
nBrake wear
This brake wear warning soundmeans your vehicle needs service. Ifyou ignore this audible warning, youwill eventually lose braking perform‐ance, which could lead to a seriousaccident.
Foot parking brake
Applying the parking brake
0:',
To engage the parking brake, first apply
the foot brake and then depress the
parking brake pedal down as far as possible.
CAUTION
•Driving with the parking brake ap‐plied will cause excessive brakepad (or lining) and brake rotorwear.
(Continued)
(Continued)
•Do not operate the parking brakewhile the vehicle is moving exceptin an emergency situation. It coulddamage the vehicle system andmake endanger driving safety.
Releasing the parking brake
To release the parking brake, depress
the parking brake pedal a second time while applying the foot brake. The ped‐
al will automatically extend to the fully
released position.
Driving your vehicle
7-18

WARNING
•Whenever leaving the vehicle orparking, always come to a com‐plete stop and continue to depressthe brake pedal. Move the shiftlever into the P (Park) position,then apply the parking brake, andplace the Engine Start/Stop buttonin the OFF position.Vehicles with the parking brakenot fully engaged are at risk formoving inadvertently and causinginjury to yourself or others.
•Never allow anyone who is unfa‐miliar with the vehicle to touch theparking brake. If the parking brakeis released unintentionally, seriousinjury may occur.
•All vehicles should always have theparking brake fully engaged whenparking to avoid inadvertentmovement of the vehicle whichcan injure occupants or pedes‐trians.
8,@5'
Check the brake warning light by press‐
ing engine start/stop button switch ON (do not start the hybrid system). This
light will be illuminated when the park‐
ing brake is applied with the engine start/stop button switch in the START
or ON position.
Before driving, be sure the parking
brake is fully released and the brake warning light is off.
If the brake warning light remains on
after the parking brake is released
while the hybrid system is on, there may be a malfunction in the brake sys‐
tem. Immediate attention is necessary. If at all possible, cease driving the vehi‐
cle immediately. If that is not possible, use extreme caution while operating
the vehicle and only continue to drive
the vehicle until you can reach a safe location or repair shop.
Electronic parking brake (EPB)
(if equipped)
Applying the parking brake
0+'-
To apply the EPB (Electronic ParkingBrake):
1. Depress the brake pedal.
2. Pull up the EPB switch.
Make sure the warning light comes on.

7-19
7
Driving your vehicle

Also, the EPB is applied automatically if
the Auto Hold button is on when the engine is turned off.
NOTICE
On a steep incline or when pulling a
trailer if the vehicle does not stand
still, do as follows:
1.Apply the EPB.
2.Pull up the EPB switch for more
than 3 seconds.
CAUTION
Do not operate the parking brakewhile the vehicle is moving except inan emergency situation. It coulddamage the vehicle system and en‐danger driving safety.
Releasing the parking brake
0+'
To release the EPB (Electronic ParkingBrake), press the EPB switch in the fol‐lowing condition:
• Have the engine start/stop button in the ON position.
• Depress the brake pedal.
Make sure the brake warning light goes
off.
To release EPB (Electronic ParkingBrake) automatically:
• Shift lever in P (Park) With the engine running depress thebrake pedal and shift out of P (Park)
to R (Reverse) or D (Drive).
• Shift lever in N (Neutral) With the engine running depress the
brake pedal and shift out of N (Neu‐
tral) to R (Reverse) or D (Drive). 1. Start the engine.
2. Fasten the driver's seat belt.
3. Close the driver's door, engine hood and trunk.
4. Depress the accelerator pedal while the shift lever is in R (Rear),
D (Drive) or manual mode.
Make sure the brake warning light goes
off.
NOTICE
•For your safety, you can engage
the EPB even though the engine
stop/start button is in the OFF po‐
sition, but you cannot release it.
(Continued)
Driving your vehicle
7-20

(Continued)
•For your safety, depress the brake
pedal and release the parking
brake manually with the EPB
switch when you drive downhill or
when backing up the vehicle.
CAUTION
•If the parking brake warning lightis still on even though the EPB hasbeen released, we recommendthat the system be checked by anauthorized Kia dealer.
•Do not drive your vehicle with theEPB applied. It may cause exces‐sive brake pad and brake rotorwear.
EPB (Electronic Parking Brake) may beautomatically applied when:
• The EPB is overheated
• Requested by other systems
• The hybrid system is turned off with the EPB applied
NOTICE
If the driver turns the hybrid system
off while Auto Hold is operating, EPB
will be automatically applied. Howev‐
er, if you press the EPB switch with‐
in one second after the hybrid sys‐
tem is turned off, the EPB will not
be applied.
System warning
0+'-
• If you try to drive off depressing theaccelerator pedal with the EPB ap‐
plied, but doesn't release automati‐ cally, a warning will sound and a mes‐
sage will appear.
• If the driver's seat belt is not fas‐ tened and the engine hood or trunk is
opened, a warning will sound and a
message will appear.
• If there is a problem with the vehicle, a warning may sound and a message
may appear.
If the above situation occurs, depress
the brake pedal and release EPB by pressing the EPB switch.
WARNING
•To prevent unintentional move‐ment when stopped and leavingthe vehicle, do not use the shiftlever in place of the parking brake.Set the parking brake and makesure the shift lever is securelypositioned in P (Park).
(Continued)

7-21
7
Driving your vehicle

System warning
0+'-
5ZQF
"
0+'-
5ZQF
#
If the EPB is applied while Auto Hold is
activated because of ESC (Electronic Stability Control) signal, a warning will
sound and a message will appear.
EPB malfunction indicator (if
equipped)
0+'
This warning light illuminates if the en‐
gine start/stop button is changed to the ON position and goes off in approxi‐
mately 3 seconds if the system is oper‐
ation normally. If the EPB malfunction indicator re‐
mains on, comes on while driving, or
does not come on when the ignition
switch or the engine start/stop button is changed to the ON position, this indi‐
cates that the EPB may have malfunc‐
tioned.
If this occurs, we recommend that the system be checked by an authorized
Kia dealer.
The EPB malfunction indicator may illu‐
minate when the ESC indicator comes on to indicate that the ESC is not work‐
ing properly, but it does not indicate a
malfunction of the EPB.
CAUTION
•The EPB warning light may illumi‐nate if the EPB switch operatesabnormally. Shut the engine offand turn it on again after a fewminutes. The warning light will gooff and the EPB switch will oper‐ate normally. However, if the EPBwarning light is still on, we recom‐mend that the system be checkedby an authorized Kia dealer.
(Continued)

7-23
7
Driving your vehicle

(Continued)
•If the parking brake warning lightdoes not illuminate or blinks eventhough the EPB switch was pulledup, the EPB is not applied.
•If the parking brake warning lightblinks when the EPB warning lightis on, press the switch, then pull itup. Once more press it back to itsoriginal position and pull it back up.If the EPB warning does not gooff, we recommend that the sys‐tem be checked by an authorizedKia dealer.
Emergency braking
If there is a problem with the brake
pedal while driving, emergency braking is possible by pulling up and holding the
EPB switch. Braking is possible only
while you are holding the EPB switch.
WARNING
Do not operate the parking brakewhile the vehicle is moving except inan emergency situation.
NOTICE
During emergency braking by the
EPB, the parking brake warning light
will illuminate to indicate that the
system is operating.
CAUTION
If you continuously notice a noise orburning smell when the EPB is usedfor emergency braking, we recom‐mend that the system be checkedby an authorized Kia dealer.
When the EPB (Electronic ParkingBrake) does not release
If the EPB does not release normally, we recommend that you contact an au‐
thorized Kia dealer by loading the vehi‐
cle on a flatbed tow truck and have the system checked.
AUTO HOLD (if equipped)
The Auto Hold maintains the vehicle in
a standstill even though the brake ped‐ al is not depressed after the driver
brings the vehicle to a complete stop by
depressing the brake pedal.
Set up
0+'-
1. With the driver's door, engine hood closed, fasten the driver's seat belt
or depress the brake pedal and
then press the Auto Hold button.
The white AUTO HOLD indicator will
come on and the system will be in
the standby position.
Driving your vehicle
7-24