Page 35 of 54

33*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS .
To view these videos on
your mobile device, snap
these QR codes .
Refer to page 2 for more
information .
Sportmatic
® Shifting
Video
Heated and Ventilated
Seats Video
QR CODES
www.KuTechVideos.com/jf23/2017
www.KuTechVideos.com/jf23/2017
Yellow Color:
Warming Blue Color:
Ventilating
Automatic Gear Shift with Sportmatic® Shifting
P:
Park
R: Reverse
N: Neutral
D: Drive
[+]: Sport Mode Upshift
[–]: Sport Mode Downshift
Sport Mode: To enter Sport mode, move shift lever from D to left gate . To shift
while in Sport mode, move shift lever up [+] to upshift or down [–] to downshift .
Seat Warmers / Ventilated Seats*
Seat Warmers — Press top of button once for high
setting (3 LEDs lit), again for middle setting (2 LEDs
lit), again for low setting (1 LED lit) . Press again to
turn OFF .
Ventilated Seats — Press bottom of button once
for high setting (3 LEDs lit), again for middle setting
(2 LEDs lit), again for low setting (1 LED lit) . Press
again to turn OFF .
•With the seat warmer
switch in the ON
position, the heating
system in the seat turns
OFF or ON automatically
depending on the seat
temperature
•System is OFF by
default
QUICK TIPS
SHIFTLOCK
RELEASE
CENTER PANEL
Page 37 of 54
35*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS .
Driver Position Memory
System Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website .
Refer to page 2 for more
information .QR CODE
www.KuTechVideos.com/jf23/2017
Driver Position Memory System*
To store a seating position into memory, first place the shifter into P (Park)
while the ignition switch is ON . Then:
1 . Adjust the driver’s seat
2 . Press the SET button
A on the control panel . System will beep once
3 . Press one of the memory buttons
B within 5 seconds . The system will
beep twice when memory has been stored
4 . “Driver (1 or 2) set is memorized” will appear on the instrument cluster
LCD screen
C
Front Seat Headrest Adjustment
To raise headrest: Pull headrest up .
To lower headrest: Press lock
C, then press the headrest down .
SET
1
2
A
B
SEATING
Page 38 of 54
SEATING
36*IF EQUIPPED OPTIMA PLUG-IN HYBRID FEATURES & FUNCTIONS GUIDE
D
E
G
F
Seatback Lumbar
Seat Seat Cushion
Power Adjustable Driver’s Seat*
Move/Press controls to adjust Seat forward/backward, Seat Cushion tilt up/down,
Seatback forward/backward or Lumbar up/down/forward/backward
AABC
ABC
6-Way Manual Adjustable
Driver’s Seat*
Pull lever D to slide Seat forward/backward .
Pull/press lever
E to adjust Seat height .
Pull lever
F to adjust Seatback recline .
Press
G to adjust Lumbar support
When adjusting seat forward or backwards, ensure seat
clicks or locks into place before driving vehicle .
QUICK TIP
Page 39 of 54

37*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS .
Smart Key
Smart Key Fob:
A Press to lock All Doors
B Press to unlock Driver’s Door . Press twice in 4 seconds to
unlock All Doors
C Press and hold for more than 1 second to unlock Trunk .
Then lift the lid to manually open Trunk .
REMINDER:
The Trunk unlocks when the Smart Key fob is within close proximity of the vehicle .
D Press and hold more than 1 second for Panic Alarm .
To turn off Alarm, press any button
E Press to release Mechanical Key (on reverse side of fob)
Driver’s Door Lock/Unlock button
F:
• Press button once to unlock Driver’s Door
• Press again within 4 seconds to unlock All Doors
• Press again to lock All Doors
Mechanical Key
G
Use to unlock /lock Driver’s Door:
1 . Remove door handle keyhole cover
H with Mechanical Key by
pressing up into slot on the bottom of keyhole cover
2 . Insert Mechanical Key and turn right to Unlock Driver’s Door .
Turn twice within 4 seconds to Unlock all doors
3 . Insert Mechanical Key and turn left to Lock Driver’s Door
4 . Return keyhole cover to its original position
Use to lock glove box and to turn Child-Protector Rear Door Lock
Engine Start/Stop Button
& Smart Key Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website .
Refer to page 2 for more
information .QR CODE
www.KuTechVideos.com/jf23/2017
•If the Smart Key battery is weak or not working properly, hold the Smart Key fob up to the
ENGINE START/STOP button (Lock button side closest) and press to start engine
•The Smart Key’s signal can be blocked by the normal operation of a cell phone or smartphone .
To help prevent this, store each device separately
QUICK TIPS
REMINDER: Remote button configuration
may vary depending on vehicle options .
Double-Turn Lock/Unlock All
• Turn clockwise once to unlock Driver’s Door
• Turn clockwise again within 4 seconds to
unlock All Doors
• Turn counterclockwise once to lock All DoorsLock Unlock
OTHER KEY FEATURES
HOLD
F
H
A
B
C
D
G
E
H
Page 40 of 54

38*IF EQUIPPED OPTIMA PLUG-IN HYBRID FEATURES & FUNCTIONS GUIDE
Power Trunk / Smart Trunk*
Smart Key:
To open the Power Trunk, press and hold the Trunk
button
A until the Trunk begins opening . Press
again to cancel .
REMINDER: Pulling the Trunk upward by the handle or pressing
the button a second time will interrupt the automatic opening of
the Power Trunk .
HOLDA
Outside the Vehicle:
To open Power Trunk
automatically, press the Trunk
Release button
B located
underneath the Trunk lid .
Inside the Vehicle:
Press and hold the Power
Trunk Open/Close button
C
to automatically open/close
the Trunk . Smart Trunk*
When the Smart Key fob is on your person and you are near the back of
the vehicle, within close proximity, the hazard lights will blink and a chime
will sound for about 3 seconds as an alert that the Power Trunk is about
to open
. Then the alert system will blink and chime two additional times
before opening the Power Trunk .
The Smart Trunk feature is off by default . To enable the Smart Trunk, go to
User Settings in the LCD Instrument Cluster modes .
REMINDERS:
•All doors are closed and locked after about 15 seconds
•The Smart Trunk feature will not operate when:
- The doors are recently closed and locked, and the Smart Key is still detected after 15
seconds near the vehicle or within 60 inches of the door handles
- A door is not locked or closed
- The Smart Key is in the vehicle
For more information on the Smart Trunk operation, please refer to the Owner's Manual.
During the Smart Trunk alert, the Smart Trunk can be deactivated with the Smart
Key by pressing any button on the key fob . QUICK TIP
B
(Button located on Driver's Panel left of Steering Wheel)
C
OTHER KEY FEATURES
Page 41 of 54

Map/Room Lamps
Automatic turn off function*
The interior lights automatically turn off approximately 30 seconds after the
ENGINE START/STOP button is OFF .
Map/Personal Lamp
Push the lens
A to turn the Map Lamp ON/OFF . This light produces a spot
beam for convenient use as a Map Lamp or Personal Lamp for the driver or
front passenger .
Room Lamp
: When pressed B, the lamp turns ON when any door is opened .
: When pressed C, the lamp stays on continuously .
( Type A )
( Type B)
Panoramic Sunroof Operation*
The Sunroof and Sunshade operation is controlled through a multi-
directional switch/lever, and the ignition needs to be in the ON position to
operate the Sunroof/Sunshade .
Slide the Sunshade and Sunroof:
• Auto Open: Slide lever backward to the farthest position and release
• Auto Close (Sunroof only): Slide the lever
D forward to the farthest
position and release
Slide the Sunshade:
• Open: Slide the lever
D partially backward to the first detent position
• Auto Close: Slide the lever
D forward to the farthest position
Slide the Sunroof (with Sunshade open):
• Open: Slide the lever
D backward and release
• Close: Slide the lever
D partially forward to the first detent position or
pull the lever downward
Tilt the Sunroof:
• Raise: Push lever
D upward
• Lower: Push lever
D upward
• Auto Close: Slide the lever
D forward to the farthest position
REMINDER: Sunshade needs to remain OPEN while Sunroof is open and vehicle is moving .
•When doors are unlocked by the Smart Key*, the lamp turns ON for
approximately 30 seconds
•If your vehicle is equipped with the theft alarm system, the interior lights
automatically turn off approximately 3 seconds after the system is in armed stage
•Using interior lights for an extended period of time may cause battery discharge
QUICK TIPS
To stop the Sunroof/Sunshade at any position, push or pull the Sunroof control
lever in any direction .QUICK TIP
CAA
B
D
B
39*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS .
OTHER KEY FEATURES
Page 42 of 54

40*IF EQUIPPED OPTIMA PLUG-IN HYBRID FEATURES & FUNCTIONS GUIDE
Fuel Door and Trunk Release
Press the button C to release the fuel door .
Pull the button
D to open the trunk .
Hood Release Lever and Latch
Opening the Hood:
1 . Pull the Hood Release Lever
A to u nlatch the Hood
2 . In the front of the vehicle, lift the Hood slightly, pull the secondary
Latch
B inside of the Hoo d’s center and lift the Hood
Closing the Hood: Lower the Hood about halfway and then press
down to securely lock in place .
(Buttons located on Driver's Door)
C
D
(Located on Driver side kick panel) (Latch located inside hood)
A
B
One-Click Fuel Cap Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website .
Refer to page 2 for more
information .QR CODE
www.KuTechVideos.com/jf23/2017
CLICK!
Fuel Cap / Malfunction
Indicator (Check Engine Light)
Tighten for ONE CLICK to prevent Malfunction
Indicator
from illuminating .
REMINDER: The Fuel Filler Door Release button is
located on the lower part of the driver’s door panel .
REMINDERS:
•Sunvisor may not shield all direct light
• Do not operate the vehicle if Sunvisor is impairing your visibility
•
Be aware of your seating position when adjusting or swinging
Sunvisor around from the front or side windows
Sunvisor
Use the Sunvisor to shield
direct light through the front
or side windows . Slide the
Sunvisor out and adjust
as needed .
OTHER KEY FEATURES
Page 44 of 54
42*IF EQUIPPED OPTIMA PLUG-IN HYBRID FEATURES & FUNCTIONS GUIDE
Plug-In Hybrid Battery Vent (Air Intake)
The Plug-In Hybrid Battery Air Intake, located on the left side
of the rear seats, is used to cool down the hybrid battery . For
safety reasons, this vent should never be blocked . Doing so
may cause the battery to overheat .
PRECAUTION: Never clean the battery vent with a WET cloth or spill liquid over the air
intake . This could cause an electric shock, which could cause serious damage, injury
or death .
Clean the air intake for the Plug-In Hybrid battery regularly with a dry cloth QUICK TIP
(Rear Seat are shown)
OTHER KEY FEATURES