2017 KIA K900 light

35
Move/press controls to adjust headrest, seat forward/backward position, seat cushion length, seatback
angle or lumbar support.
Headrest Height Adjustment*: Move button
A up/down to adjust headrest height
Seatback Angle Adjustment: Move button
B forward/backward to adjust seatback angle
Seat Sliding, Seat Height and Cushion Length* Adjustments:
§
Move button C forward/backward to slide seat
§
Move front part of button D up/down to raise/lower front part of seat
§
Move back part of button E up/down to raise/lower back part of seat
§
Move button F forward/backward to increase/decrease cushion length*
Lumbar Support Adjustment:
§
Press G to increase support
§
Press H to decrease support
§
Press I to move lumbar support up/down
Power Adjustable Driver’s Seat
A
B
ED
F
C
GH
I
I
(Buttons located on left side of seat cushion)
(Controls located on door panel)
Power Height Adjustment* – To adjust the height, move
the seat control button A up/down.
Manual Tilt Adjustment – To adjust the headrest forward/
backward, tilt the lower part of the headrest at a slight angle.
Power Front Seat Headrest Adjustment*
S E AT I N G
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

38
Smart Power Trunk
The Smart Trunk automatically unlocks and opens the trunk
hands-free when the Smart Key fob is detected near the rear
of the vehicle.
When the Smart Key fob is on your person and you are within
close proximity to the rear of the vehicle, the hazard lights
will blink and a chime will sound for approximately three
seconds to alert you that the Smart Trunk is about to open.
The alert system will blink and chime two additional times
before the Smart Trunk opens.
The Smart Trunk feature is OFF by default. To enable the
Smart Trunk, go to User Settings in the LCD instrument
cluster modes and select Smart Trunk.
Quick Tip
The Smart Trunk can be deactivated with the Smart
Key by pressing any button on the key fob.
REMINDERS:
- The Smart Trunk feature will not operate within 15 seconds after the doors are closed and locked
or if the Smart Key is within 60 inches from the
front door handles
- Doors must be closed and locked for the Smart Trunk to operate
- The Smart Key must be outside of the vehicle for the Smart Trunk to operate
For more information on Smart Trunk operation, please
refer to the Owner’s Manual.
OTHER KEY FEATURES
*IF EQUIPPED
OTHER KEY FEATURES
*IF EQUIPPED

42
Map/Room Lamps
Automatic Turn Off Function
The interior lights automatically turn off approximately 20
seconds after the ENGINE START/STOP button is turned OFF.
Map/Room Lamp Operation
Map Lamps – These lights produce spot beams for
convenient use as map lamps or as personal lamps for the
driver or the front passenger. Press the buttons
A to turn the
map lamps ON/OFF.
ROOM button – Press the button
B to turn the front and
rear lamps ON/OFF.
REAR ROOM button – Press the button
C to turn the rear
lamp ON/OFF.
DOOR button – When the DOOR button
D is pressed (LED
lit) the front and rear lamps will turn ON as follows:
§
When a door is opened or doors are unlocked with the
Smart Key, the lamps will turn ON for approximately
30 seconds
§
If the ENGINE START/STOP button is in the ACC/OFF
position and a door is open, the lamps will stay ON for
approximately 20 minutes
§
If the ENGINE START/STOP button is in the ACC/ON
position and a door is open, the lamps will stay ON
The lamps will turn OFF immediately if the ENG INE STA RT/
STOP button is turned ON or all doors are locked.
PRIVACY button – When button
E is pressed (LED lit) and
a door is opened, that door lamp will turn ON.
REMINDER: When room lamp lens is pressed ON it
will remain ON, even when the map lamp switch is in
the OFF position. Quick Tips
- When doors are unlocked by the Smart Key, the
lamp turns ON for approximately 30 seconds
- If your vehicle is equipped with the theft alarm
system, the interior lights automatically turn off
approximately 3 seconds after the system is in
armed stage
- Using interior lights for an extended period of time
may cause battery discharge
BC
D
E
AA
OTHER KEY FEATURES
*IF EQUIPPED
OTHER KEY FEATURES
*IF EQUIPPED

44
ABC
DE
FGH
A eServices Guide button B UVO Luxury Services Voice Local Search button C Roadside Assist button D Auto dimming ON/OFF
E Glare detection sensorF HomeLink® button G HomeLink® button
H HomeLink® button
Auto-Dimming Rearview Mirror with HomeLink®
The Auto-Dimming Rearview Mirror is designed to help reduce glare from a vehicle’s headlights located in
the rear and also connect up to three electronic transmitters in one location. To turn automatic dimming ON
or OFF, press button
D.
UVO Luxury Services Rearview Mirror Key Functions
A UVO Luxury Services Guide button: Provides information about UVO Luxury Services features within the
vehicle. Press button A and follow the voice prompts to use the eServices Guide.
B UVO Luxury Services Voice Local Search button: Uses Google® to locate points of interest in the
surrounding area. Press button B and follow the voice prompts to use UVO Luxury Services Voice
Local Search.
C Roadside Assist button: Connects to Roadside Assist and provides services including emergency
assistance and vehicle towing. Press button C to connect to Roadside Assist.
REMINDER: Mirror indicator light will illuminate when automatic dimming is ON.
OTHER KEY FEATURES
*IF EQUIPPED
OTHER KEY FEATURES
*IF EQUIPPED

45
How to Sync Transmitter with HomeLink®
If programming for the first time, begin with step 1 (repeating
this step will delete all information).
To program non-rolling and rolling code garage door openers
and other devices:
1. Press and hold the left F and center G buttons
simultaneously until the indicator light begins to flash (to
reprogram buttons, skip this step)
2. Press and hold the desired button F, G or H and hold
the button on the transmitter while it is approximately 1 to
3 inches away from the mirror. The HomeLink
® indicator
light will flash rapidly once the frequency signal has been
successfully programmed
To finish programming rolling code garage door openers,
complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s
motor head unit. Press and release the button and complete
step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink®
button up to three times
Quick Tips
- You can reprogram a single HomeLink® button by
repeating step 2
- Erasing programmed buttons will delete all
trained transmitters
Operating HomeLink®:
Press one of the programmed HomeLink
® buttons.
Erasing programmed buttons:
Press and hold the left
F and center H buttons
simultaneously for approximately 20 seconds, and then
release both buttons within 30 seconds.
If your garage door opener was manufactured in 2011
or later, and you are unable to program your vehicle’s
HomeLink
® system, you may need to purchase a
HomeLink® Repeater Kit. For more information, go to
www.HomeLink.com or call (800) 355-3515.
OTHER KEY FEATURES
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

46
Hood Release Lever and Latch
Opening the Hood:
1. Pull the hood release lever A to unlatch the hood
2. In the front of the vehicle, lift the hood slightly, push the secondary latch inside of the hood (center) B
to the left and lift the hood
Closing the Hood:
Lower the hood about halfway and then press down to securely lock in place.
A
B
Sunvisor
Use the sunvisor to shield direct light through the front or
side windows.
Slide the sunvisor out and adjust as needed.
REMINDERS:
- Sunvisor may not shield all direct light
- Sunvisor may impair visibility if not adjusted
properly
- Be aware of seating position when adjusting or swinging sunvisor around to or from the front or
side windows
OTHER KEY FEATURES
*IF EQUIPPED
OTHER KEY FEATURES
*IF EQUIPPED

47
Fuel Cap / Malfunction Indicator (Check Engine Light)
Tighten until ONE CLICK to prevent malfunction indicator
from illuminating.
www.KuTechVideos.com/kh13/2017
ONE-CLICK FUEL
CAP VIDEO
To view a video on
your mobile device,
snap this QR Code or
visit the listed website.
Refer to page 2 for
more information.
REMINDER:
The fuel filler door release button is located on the driver’s panel to
the left of the steering wheel.
Child Safety Locks
Located on the rear edge of the rear passenger doors, move the Child Safety Lock to
the lock position
to disable the inner door handles from opening the rear doors.
REMINDER: Child Safety Lock is located on rear passenger door jamb.
OTHER KEY FEATURES
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

48
Seat Belts
Pre-Safe Seat Belt (PSB)*
To properly fasten your safety belts:
1. Insert the belt tongue plate A into the buckle until it clicks
2. Position the lap portion of the belt across your lap as LOW
ON THE HIPS as possible. Adjust the belt to a SNUG FIT by
pulling up on the shoulder portion B
Seat Belt Retractor Locks
Retractor locks allow lap/shoulder safety belts to remain
unlocked during normal vehicle operation for freedom of
movement and in creased comfort.
During a STRONG STOP, SUDDEN TURN OR CERTAIN
COLLISIONS, seat belt retractors will automatically lock
the belts to help reduce the risk of injury.
The Pre-Safe Seat Belt (PSB) will activate and pull the seat
belt into tighter contact against the occupant’s body if a
collision is detected or during certain driving maneuvers.
The PSB system operates as below:
§
The seat belt may tighten when:
- The vehicle senses a collision
- An emergency braking situation occurs
- There’s a loss of vehicle control
For more detailed information regarding your vehicle’s
s afety belts, please refer to your Owner’s Manual
and the separate brochure titled “Understanding Your
S afety Belt & Supplemental Restraint System.”
Quick Tip
The
seat belt warning chime operates for the
driver’s seat only.
A
B
REMINDERS:
The Pre-Safe Seat Belt warning light will illuminate on LCD screen if there is a problem with the system.
Have the system checked if:
- The warning light does not turn on briefly when you turn the ENGINE START/STOP button to the
ON position
- The warning light stays on after illumination for approximately 3 seconds
- The warning light comes on while the vehicle is in motion
SAFETY FEATURES
*IF EQUIPPED
SAFETY FEATURES
*IF EQUIPPED