Page 556 of 595
Maintenance
94 7
• 4 Door, 2 Door
Back up lamp
1. Take the lamp assembly out.
2. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.3. Remove the bulb by pulling it out.
4. Insert a new bulb by inserting it
into the socket.
5. Install the light assembly to the
trunk.
6. Reinstall the nuts and connector
and then the trunk lid cover by
pushing in the screw.
• 5 Door
1. Turn off the engine.
2. Open the liftgate.
3. Remove the service cover.
OYDDMC3065
OYDDMC3070 • 5 Door
OYDDMC2023
OYDDMC2024 ■Type A
■Type B
Page 557 of 595

795
Maintenance
4. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
6. Insert a new bulb by inserting it
into the socket and rotating it until
it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
8. Install the service cover by putting
it into the service hole.
Stop/tail light (LED type)
If the light does not operate, we rec-
ommend that the system be checked
by an authorized Kia dealer.High mounted stop lamp
replacement
• 4 Door
1. Open the trunk.
2. Remove the socket by turning it
counterclockwise until the tabs on
the socket align with the slots.3. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
4. Insert a new bulb by inserting it
into the socket and rotating it until
it locks into place.
5. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
OYD046058
OYDDMC2025 • 4 Door
Page 559 of 595
797
Maintenance
• 2 Door
If the light bulb does not operate, we
recommend the vehicle be checked
by an authorized Kia dealer. A skilled
technician should check or repair the
high mounted stop light, for it may
affect the performance of the curtain
airbags or damage related interior
parts of the vehicle.
License plate lamp bulb
replacement
1. Remove the cover by pressing it
as direction of the arrows.
2. Remove the socket by turning it
counterclockwise.
3. Remove the bulb by pulling it
straight out.
4. Install a new bulb.
5. Reinstall the bulb assembly
securely with the retaining screws.
OVG079034 • 2 Door
OYDDMC2032
Page 560 of 595
Maintenance
98 7
Interior lamp bulb replacement
1. Using a flat-blade screwdriver,
gently pry the lens from the interi-
or light housing.
2. Remove the bulb by pulling it
straight out.
3. Install a new bulb in the socket.
Vanity mirror lamp
Front map lamp
OVG079040Glove box lamp
OYDEMC2065
OJF075144LLuggage lamp (if equipped)
• 4 Door, 2 Door
Room lamp
OMD070045Luggage lamp (if equipped)
• 5 Door
OYDDMC3076
OMD070043
WARNING
Prior to working on the Interior
Lamps, ensure that the “OFF”
button is depressed to avoid
burning your fingers or receiv-
ing an electric shock.
Page 561 of 595
799
Maintenance
4. Align the lens tabs with the interior
lamp housing notches and snap
the lens into place.
CAUTION- Interior lights
Use care not to dirty or damage
lens, lens tab, and plastic hous-
ings.
Page 562 of 595

Maintenance
100 7
APPEARANCE CARE
Exterior care
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning
and caution statements that appear
on the label.
Finish maintenance
Washing
To help protect your vehicle’s finish
from rust and deterioration, wash it
thoroughly and frequently at least
once a month with lukewarm or cold
water.If you use your vehicle for off-road
driving, you should wash it after each
off-road trip. Pay special attention to
the removal of any accumulation of
salt, dirt, mud, and other foreign mate-
rials. Make sure the drain holes in the
lower edges of the doors and rocker
panels are kept clear and clean.
Insects, tar, tree sap, bird droppings,
industrial pollution and similar
deposits can damage your vehicle’s
finish if not removed immediately.
Even prompt washing with plain water
may not completely remove all these
deposits. A mild soap, safe for use on
painted surfaces, may be used.
After washing, rinse the vehicle thor-
oughly with lukewarm or cold water.
Do not allow soap to dry on the finish.
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water. If
braking performance is impaired, dry
the brakes by applying them lightly
while maintaining a slow forward
speed.
CAUTION - Headlight
Lens
To prevent damage, do not
clean headlight lens with chem-
ical solvents or strong deter-
gents.
CAUTION
• Do not use strong soap, chem-
ical detergents or hot water,
and do not wash the vehicle in
direct sunlight or when the
body of the vehicle is warm.
• Be careful when washing the
side windows of your vehicle.
Especially, with high-pressure
water. Water may leak through
the windows and wet the inte-
rior.
• To prevent damage to the
plastic parts and lamps, do
not clean with chemical sol-
vents or strong detergents.
Page 575 of 595
83
BULB WATTAGESpecifications & Consumer information
* : If equippedLight Bulb Wattage Bulb type
FrontHeadlamps (Low) 55 H7
Headlamps (Low)- HID * 25 D5S
Headlamps (High)4 Door, 5 Door 60 9005HL+
2 Door 55 H1
Front turn signal lamps 28 PY28/8W
Front position lamps * 5 W5W
Front position lamps (LED type)* LED LED
Front fog lamps * 35 H8
Side Repeater lamps 5 WY5W
Side Repeater lamps (Outside Mirror) * LED LED
Daytime running lamps * LED LED
RearRear Stop/Tail lamps (outside)
Bulb type28 P28/8W
Rear tail lamps (Inside) 8 P28/8W
Rear Stop/Tail lamps (outside)
LED typeLED LED
Rear Stop/tail lamps (Inside) LED LED
Rear turn signal lamps 27 PY27W
Back-up lamps 16 W16W
High mounted stop lamp *4 Door *Bulb type 21 P21W
LED type LED LED
5 Door, 2 Door LED type LED LED
License plate lamps 5 W5W
Page 576 of 595
4 8
Specifications & Consumer information
(Continued)
* : If equippedLight Bulb Wattage Bulb type
InteriorMap lamps * 8 FESTOON
Room lamps 8 FESTOON
Vanity mirror lamps * 5 FESTOON
Luggage lamp *4 Door, 2 Door 5 FESTOON
5 Door 8 FESTOON