▫Ignition Off Operation ....................71
TO OPEN AND CLOSE THE HOOD ...........71
LIFTGATE .............................73
▫ Cargo Area Features .....................74
GARAGE DOOR OPENER — IF EQUIPPED .....77
▫ Before You Begin Programming HomeLink .....78
▫ Programming A Rolling Code ...............78
▫ Programming A Non-Rolling Code ...........80
▫ Canadian/Gate Operator Programming ........81
▫ Using HomeLink .......................82
▫ Security ..............................82 ▫
Troubleshooting Tips .....................83
▫ General Information ......................84
CONSOLE FEATURES .....................84
INTERNAL EQUIPMENT ...................85
▫ Glove Compartment And Storage Bin .........85
▫ Door Storage ...........................86
▫ Electrical Power Outlets ..................87
▫ Power Inverter — If Equipped ..............89
▫ Cupholders ............................90
ROOF LUGGAGE RACK — IF EQUIPPED ......91
18 GETTING TO KNOW YOUR VEHICLE
There are two cupholders located in the back for the rear
passengers.ROOF LUGGAGE RACK — IF EQUIPPED
The crossbars and siderails are designed to carry the cargo
on vehicles equipped with a luggage rack. The load must
not exceed 150 lbs (68 kg), and should be uniformly
distributed over the luggage rack crossbars.
NOTE:If not equipped with crossbars, your authorized
dealer can order and install MOPAR crossbars built spe-
cifically for this roof rack system.
Distribute cargo weight evenly on the luggage rack cross-
bars. The luggage rack does not increase the total load
carrying capacity of the vehicle. Be sure the total load of
cargo inside the vehicle plus that on the external rack does
not exceed the maximum vehicle load capacity.
The crossbars must also be secured in one of the seven
detent positions marked with an arrow on the siderails to
prevent movement. To move the crossbars, loosen the
thumb screws located at the upper edge of each crossbar
approximately eight turns, then move the crossbar to the
desired position, keeping the crossbars perpendicular to
the luggage rack side rails. Once the crossbar is in one of
the seven detent positions, retighten the thumb screws to
lock the crossbar into position.
Rear Cupholders
3
GETTING TO KNOW YOUR VEHICLE 91
NOTE:
•To help control wind noise when the crossbars are not in
use, place the front crossbar in the first detent from the
front of the vehicle and the rear crossbar in the second
detent from the rear of the vehicle.
• If the rear crossbar (or any metallic object) is placed over
the satellite radio antenna (if equipped), you may expe-
rience interruption of satellite radio reception. For im-
proved satellite radio reception, place the rear crossbar
in the second detent from the rear of the vehicle when
not in use.
WARNING!
Cargo must be securely tied before driving your ve-
hicle. Improperly secured loads can fly off the vehicle,
particularly at high speeds, resulting in personal injury
or property damage. Follow the roof rack cautions
when carrying cargo on your roof rack.
CAUTION!
• To prevent damage to the roof of your vehicle, DO
NOT carry any loads on the luggage rack without
crossbars installed. The load should be secured and
placed on top of the crossbars, not directly on the
roof. If it is necessary to place the load on the roof,
place a blanket or some other protection between the
load and the roof surface.
• To avoid damage to the luggage rack and vehicle, do
not exceed the maximum luggage rack load capacity
of 150 lb (68 kg). Always distribute heavy loads as
evenly as possible and secure the load appropriately.
• Long loads which extend over the windshield, such
as wood panels or surfboards, or loads with large
frontal area should be secured to both the front and
rear of the vehicle.
• Travel at reduced speeds and turn corners carefully
when carrying large or heavy loads on the roof rack.
Wind forces, due to natural causes or nearby truck
traffic, can add sudden upward lift to a load. This is
especially true on large flat loads and may result in
damage to the cargo or your vehicle.
92 GETTING TO KNOW YOUR VEHICLE
area where the SABICs inflate. Children are at an even
greater risk of injury from a deploying air bag.
WARNING!
•Do not stack luggage or other cargo up high enough
to block the deployment of the SABICs. The trim
covering above the side windows where the SABIC
and its deployment path are located should remain
free from any obstructions.
• In order for the SABICs to work as intended, do not
install any accessory items in your vehicle which
could alter the roof. Do not add an aftermarket
sunroof to your vehicle. Do not add roof racks that
require permanent attachments (bolts or screws) for
installation on the vehicle roof. Do not drill into the
roof of the vehicle for any reason.
The SABICs and SABs (Side Air Bags) are designed to
activate in certain side impacts and certain rollover events.
The Occupant Restraint Controller (ORC) determines
whether the deployment of the Side Air Bags in a particular
side impact or rollover event is appropriate, based on the
severity and type of collision. Vehicle damage by itself is
not a good indicator of whether or not Side Air Bags should
have deployed. Side Air Bags are a supplement to the seat belt restraint
system. Side Air Bags deploy in less time than it takes to
blink your eyes.WARNING!
•
Occupants, including children, who are up against or
very close to SABICs can be seriously injured or
killed. Occupants, including children, should never
lean on or sleep against the door, side windows, or
area where the side air bags inflate, even if they are
in an infant or child restraint.
• Seat belts (and child restraints where appropriate)
are necessary for your protection in all collisions.
They also help keep you in position, away from an
inflating SABIC. To get the best protection from the
SABICs, occupants must wear their seat belts prop-
erly and sit upright with their backs against the seats.
Children must be properly restrained in a child
restraint or booster seat that is appropriate for the
size of the child.
• Side Air Bags need room to inflate. Do not lean
against the door or window. Sit upright in the center
of the seat.
(Continued)
5
SAFETY 169
Electronic Serial Number/Sirius Identification
Number (ESN/SID)
Please have the following information available when
calling:
1. The Electronic Serial Number/Sirius IdentificationNumber (ESN/SID).
2. Your Vehicle Identification Number.
To access the ESN/SID, refer to the following steps:
ESN/SID Access
With the ignition switch in the ON/RUN or ACC position
and the radio on, push the SETUP button and scroll using
the TUNE/SCROLL control knob until Sirius ID is selected.
Push the TUNE/SCROLL control knob and the Sirius ID
number will display. The Sirius ID number display will
time out in two minutes. Push any button on the radio to
exit this screen.
Selecting Uconnect (Satellite) Mode
Push the SAT button until SATappears in the display. A
CD may remain in the radio while in the Satellite radio
mode.
Satellite Antenna
To ensure optimum reception, do not place items on the
roof around the rooftop antenna location. Metal objects
placed within the line of sight of the antenna will cause
decreased performance. Larger luggage items such as bikes
should be placed as far rearward as possible, within the
loading design of the rack. Do not place items directly on
or above the antenna.
Reception Quality
Satellite reception may be interrupted due to one of the
following reasons:
• The vehicle is parked in an underground parking struc-
ture or under a physical obstacle.
• Dense tree coverage may interrupt reception in the form
of short audio mutes.
• Driving under wide bridges or along tall buildings can
cause intermittent reception.
• Placing objects over or too close to the antenna can cause
signal blockage.
10
MULTIMEDIA 357
Child Protection..........................32
Door ..................................28
Power Door .............................29
Lubrication, Body ......................... .290
Luggage Rack (Roof Rack) .....................91
Lug Nuts ............................... .329
Lumbar Support ............................35
Maintenance Schedule ...................... .277
Malfunction Indicator Light (Check Engine) . . . .104, 127
Manual, Service ........................... .401
Manual Transaxle Fluid Level Check ....................... .302
Manual Transmission ....................... .298
Fluid Level Check ....................... .299
Frequency Of Fluid Change .................299
Lubricant Selection .................298, 301, 338
Map/Reading Lights .........................50
Master Cylinder (Brakes) .....................297
Methanol ............................... .331
Mini-Trip Computer .........................115
Mirrors ..................................43
Automatic Dimming .......................44
Electric Powered ..........................45
Exterior Folding ..........................45 Heated
.................................46
Outside ................................44
Rearview ...............................43
Vanity .................................46
Modifications/Alterations, Vehicle ................7
Monitor, Tire Pressure System ..................140
MOPAR Parts ............................ .401
New Vehicle Break-In Period ..................197
Occupant Restraints ........................ .147
Octane Rating, Gasoline (Fuel) .................331
Oil, Engine ....................... .286, 335, 336
Capacity .............................. .335
Change Interval ........................ .286
Checking ............................. .284
Disposal .............................. .287
Filter ............................. .287, 336
Filter Disposal .......................... .287
Identification
Logo...................... .286
Materials Added To ...................... .287
Pressure Warning Light ....................102
Recommendation .....................286, 335
Synthetic ............................. .287
Viscosity .............................. .286
12
INDEX 411