2017 JEEP GRAND CHEROKEE key

While in Valet Mode the following vehicle configurations are set and
locked to prevent unauthorized modification:
• All-Wheel Drive is set to 50/50.
• Transmission locks out access to first gear and up-shifts earlier thannormal.
• Stability Control, Steering, and Suspension are set to their STREET settings.
• Steering wheel paddle shifters are disabled.
• The Drive Mode interface is not available. Pushing the SRT button on Selec-Track switch will display the unlock keypad.
• The ESC Off button is disabled.
• The Launch Control button is disabled.
• Engine limited to a lowest power output state.
To exit Valet Mode you must enter the same four digit PIN that was used
to enter the mode. The unlock keypad can be accessed by either
pushing the SRT button on Selec-Track switch, or pressing the “Valet”
button on the touchscreen.
Valet Mode Deactivation
UNDERSTANDING YOUR INSTRUMENT PANEL
30

The Valet Mode Deactivation key pad will then prompt you for your four
digit PIN code, enter your PIN code and press the “OK” button on the
touchscreen. Your vehicle will return to the default state.
NOTE:If your four digit PIN is lost or forgotten, the vehicle will exit Valet
Mode after a battery disconnect for approximately five minutes. Recon-
nect the battery and cycle the ignition to the RUN position, the vehicle
will be in Auto Mode.
ECO Mode
Push the ECO button on the center stack of the instrument panel to
enter ECO mode. ECO mode modifies the vehicle’s engine and trans-
mission settings to provide improved fuel economy at a trade-off with
acceleration performance. Increased engine exhaust noise and/or vi-
Valet Mode Deactivation PIN
Eco Mode
UNDERSTANDING YOUR INSTRUMENT PANEL
31

bration may be noticed while ECO is active. This is normal and a result
of the increased amount of operating conditions where the vehicle is
allowed to operate in four cylinder shutoff mode.
• Changing the Drive Mode will deactivate ECO.
• ECO will be disabled when another Drive Mode is selected or ECObutton is pushed.
• If ECO is activated in AUTO mode, it will remain in ECO upon activation of AUTO mode from any other mode including across key
cycles. To deactivate press the ECO button again.
UNDERSTANDING YOUR INSTRUMENT PANEL
32