▫Auto-Down Feature .....................90
▫ Auto-Up Feature With Anti-Pinch Protection ....91
▫ Reset Auto-Up ..........................91
▫ Window Lockout Switch ...................91
▫ Wind Buffeting .........................92
POWER SUNROOF — IF EQUIPPED ..........92
▫ Opening Sunroof ........................93
▫ Closing Sunroof .........................93
▫ Wind Buffeting .........................94
▫ Sunshade Operation ......................94
▫ Pinch Protect Feature .....................94
▫ Venting Sunroof — Express .................94
▫ Sunroof Maintenance .....................94
▫ Ignition Off Operation ....................94
▫ Relearn Procedure .......................95
COMMANDVIEW SUNROOF WITH POWER
SHADE — IF EQUIPPED ...................95 ▫
Opening Sunroof ........................96
▫ Closing Sunroof .........................97
▫ Opening Power Shade ....................97
▫ Closing Power Shade .....................97
▫ Venting Sunroof — Express .................98
▫ Pinch Protect Feature .....................98
▫ Wind Buffeting .........................98
▫ Sunroof Maintenance .....................98
▫ Ignition Off Operation ....................99
HOOD ................................99
▫ To Open The Hood ......................99
▫ Closing The Hood ..................... .100
LIFTGATE ............................ .101
▫ Opening ............................ .101
▫ Closing ............................ .102
▫ Power Liftgate — If Equipped .............103
▫ Car
go Area Features ....................105
18 GETTING TO KNOW YOUR VEHICLE
Relearn Procedure
For vehicles equipped with a single-pane sunroof, there is
a relearn procedure that allows you to calibrate the sunroof
when the “Auto Up” feature stops working. To reset the
sunroof, follow these steps:
1. Set the ignition to the ACC ON/RUN position.
2. Ensure that the sunroof is in the Fully Closed position.
3. Push and hold the Close switch. The sunroof will hit thehard stop and move to the Vent position after 10
seconds.
4. Release the Close switch, then push and hold the Close switch again within 5 seconds to begin the teaching
process. The sunroof will complete one full cycle and
return to the Fully Closed position.
NOTE: If the Close switch is released anytime during the
teach cycle, the procedure will need to be repeated starting
from the first step.
5. Once the sunroof has stopped in the Fully Closed position, release the Close switch. The sunroof is now
reset and ready to use.
COMMANDVIEW SUNROOF WITH POWER SHADE
— IF EQUIPPED
The CommandView sunroof switch is located to the left
between the sun visors on the overhead console.
The power shade switch is located to the right between the
sun visors on the overhead console.
CommandView Sunroof And Power Shade Switches
3
GETTING TO KNOW YOUR VEHICLE 95
