2017 JEEP GRAND CHEROKEE light

FRONT VIEW
Front View
1 — Hood/Engine Compartment
2 — Windshield
3 — Headlights4 — Wheels/Tires
5 — Exterior Mirrors
6 — Doors
10 GRAPHICAL TABLE OF CONTENTS

REAR VIEW
Rear View
1 — Rear Lights
2 — Rear Windshield Wiper
3 — Liftgate
2
GRAPHICAL TABLE OF CONTENTS 11

▫Keyless Enter-N-Go — Passive Entry .........36
▫ Automatic Unlock Doors On Exit ............39
▫ Child-Protection Door Lock System —
Rear Doors ............................39
 SEATS ................................41
▫ Manual Adjustment (Front Seats) ............41
▫ Manual Adjustment (Rear Seats) ............44
▫ Power Adjustment (Front Seats) — If Equipped . .46
▫ Driver Memory Seat — If Equipped ..........48
▫ Heated Seats — If Equipped ...............51
▫ Front Ventilated Seats — If Equipped .........54
 HEAD RESTRAINTS ......................54
▫ Supplemental Active Head Restraints —
Front Seats ............................55
▫ Head Restraints — Rear Seats ...............57
 STEERING WHEEL .......................58
▫ Tilt/Telescoping Steering Column ............58▫
Power Tilt/Telescoping Steering Column — If
Equipped .............................59
▫ Heated Steering Wheel — If Equipped ........60
 MIRRORS ..............................61
▫ Inside Day/Night Mirror — If Equipped ......61
▫ Automatic Dimming Mirror — If Equipped .....61
▫ Outside Mirrors ........................62
▫ Outside Automatic Dimming Mirrors — If
Equipped .............................62
▫ Outside Mirrors Folding Feature ............62
▫ Power Mirrors .........................63
▫ Tilt Side Mirrors In Reverse (Available With
Memory Seat Only) — If Equipped ...........63
▫ Power Folding Outside Mirrors — If Equipped. . .64
▫ Illuminated Vanity Mirrors ................65
▫ Sun Visor “Slide-On-Rod” Feature —
If Equipped ...........................66
 EXTERIOR LIGHTS .......................66
16 GETTING TO KNOW YOUR VEHICLE

▫Headlight Switch .......................66
▫ Automatic Headlights — If Equipped .........67
▫ Automatic Headlight Leveling — HID Headlights
Only .................................67
▫ Parking Lights And Panel Lights .............67
▫ Headlights On Automatically With Wipers .....67
▫ Headlight Delay ........................68
▫ Lights-On Reminder ......................68
▫ Daytime Running Lights — If Equipped .......68
▫ Fog Lights — If Equipped .................69
▫ Multifunction Lever .....................69
▫ Turn Signals ...........................69
▫ Lane Change Assist — If Equipped ..........70
▫ High/Low Beam Switch ...................70
▫ Flash-To-Pass ..........................70
▫ Automatic High Beam — If Equipped ........70
▫ Battery Saver ...........................71 
INTERIOR LIGHTS ........................71
▫ Courtesy Lights .........................72
 WINDSHIELD WIPERS AND WASHERS ........74
▫ Windshield Wiper Operation ................75
▫ Intermittent Wiper System .................75
▫ Windshield Washer Operation ...............76
▫ Mist .................................77
▫ Rain Sensing Wipers — If Equipped ..........77
▫ Rear Window Wiper/Washer ...............78
 HEADLIGHT WASHERS — IF EQUIPPED ......79
 CLIMATE CONTROLS .....................80
▫ Overview .............................80
▫ Automatic Temperature Control (ATC) — If
Equipped .............................87
▫ Operating Tips .........................88
 WINDOWS .............................90
▫ Power Window Controls ..................90
3
GETTING TO KNOW YOUR VEHICLE 17

To Unlock The Doors And Liftgate
Push the interior door unlock button on the door panel.
Push and release the unlock button on the key fob once to
unlock the driver’s door or twice within five seconds to
unlock all doors and the liftgate.
The turn signal lights will flash to acknowledge the unlock
signal. The illuminated entry system will be activated.1st Push Of Key Fob Unlock Button
This feature lets you program the system to unlock either
the driver’s door or all doors on the first push of the unlock
button on the key fob. To change the current setting, refer
to “Uconnect Settings” in “Multimedia” for further infor-
mation.
NOTE:
If the vehicle is equipped with Passive Entry, refer
to “Keyless Enter-N-Go — Passive Entry” located in
“Doors” in “Getting To Know Your Vehicle” for further
information.
To Lock The Doors And Liftgate
Push and release the lock button on the key fob to lock all
doors and liftgate.
The turn signal lights will flash and the horn will chirp to
acknowledge the signal. Refer to “Uconnect Settings”
located in “Multimedia” for further programmable infor-
mation.
If the vehicle is equipped with Passive Entry, refer to
“Keyless Enter-N-Go — Passive Entry” located in “Doors”
in “Getting To Know Your Vehicle” for further information.Key Fob With Emergency Key
3
GETTING TO KNOW YOUR VEHICLE 21

3. Remove the battery by turning the back cover over(battery facing downward) and tapping it lightly on a
solid surface such as a table or similar, and then replace
the battery. When replacing the battery, match the + sign
on the battery to the + sign on the inside of the battery
clip, located on the back cover. Avoid touching the new
battery with your fingers. Skin oils may cause battery
deterioration. If you touch a battery, clean it with
rubbing alcohol.
4. To assemble the key fob case, snap the two halves together.
Programming Additional Key Fobs
Programming the key fob may be performed by an autho-
rized dealer.
Request For Additional Key Fobs
NOTE: Only key fobs that are programmed to the vehicle
electronics can be used to start and operate the vehicle.
Once a key fob is programmed to a vehicle, it cannot be
programmed to any other vehicle.
WARNING!
• Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle unattended.
• For vehicles equipped with Keyless Enter-N-Go —
Ignition, always remember to place the ignition in
the OFF mode.
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank
key fob to the vehicle electronics. A blank key fob is one
that has never been programmed.
NOTE: When having the Sentry Key Immobilizer System
serviced, bring all vehicle keys with you to an authorized
dealer.Battery Replacement
24 GETTING TO KNOW YOUR VEHICLE

NOTE:Changes or modifications not expressly approved
by the party responsible for compliance could void the
user ’s authority to operate the equipment.
SENTRY KEY
The Sentry Key Immobilizer system prevents unauthorized
vehicle operation by disabling the engine. The system does
not need to be armed or activated. Operation is automatic,
regardless of whether the vehicle is locked or unlocked.
The system uses a key fob, keyless push button ignition
and a RF receiver to prevent unauthorized vehicle opera-
tion. Therefore, only key fobs that are programmed to the
vehicle can be used to start and operate the vehicle. The
system will not allow the engine to crank if an invalid key
fob is used to start and operate the vehicle. The system will
shut the engine off in two seconds if an invalid key fob is
used to start the engine.
After turning the ignition switch to the ON/RUN position,
the Vehicle Security Light will turn on for three seconds for
a bulb check. If the light remains on after the bulb check, it
indicates that there is a problem with the electronics. In
addition, if the light begins to flash after the bulb check, it indicates that someone used an invalid key fob to start the
engine. Either of these conditions will result in the engine
being shut off after two seconds.
If the Vehicle Security Light turns on during normal vehicle
operation (vehicle running for longer than 10 seconds), it
indicates that there is a fault in the electronics. Should this
occur, have the vehicle serviced as soon as possible by an
authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not compatible
with some aftermarket remote starting systems. Use of
these systems may result in vehicle starting problems
and loss of security protection.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics.
Customer Key Programming
Programming key fobs may be performed at an authorized
dealer.
3
GETTING TO KNOW YOUR VEHICLE 31

•The turn signals will flash
• The vehicle security light in the instrument cluster will
flash
Rearming Of The System
If something triggers the alarm, and no action is taken to
disarm it, the vehicle security alarm will turn the horn off
after approximately 90 seconds, and then the vehicle
security alarm will rearm itself.
To Arm The System
Follow these steps to arm the vehicle security alarm:
1. Make sure the vehicle’s ignition is placed in the “OFF” position.
• For vehicles equipped with Keyless Entry, make sure
the vehicle’s keyless ignition system is OFF.
2. Perform one of the following methods to lock the vehicle:
• Push the lock button on the interior power door lock
switch with the driver and/or passenger door open.
• Push the lock button on the exterior Passive Entry
Door Handle with a valid key fob available in the same exterior zone (refer to
Keyless Enter-N-Go — Passive
Entry inGetting To Know Your Vehicle for further
information).
• Push the lock button on the key fob.
3. If any doors are open, close them.
To Disarm The System
The vehicle security alarm can be disarmed using any of
the following methods:
• Push the unlock button on the key fob.
• Grasp the Passive Entry Unlock Door Handle (if
equipped, refer to Keyless Enter-N-Go — Passive En-
try inGetting To Know Your Vehicle for further
information).
• Place the vehicle ignition system in the OFF position.
NOTE:
• The driver’s door key cylinder and the liftgate button on
the key fob cannot arm or disarm the vehicle security
alarm.
• The vehicle security alarm remains armed during power
liftgate entry. Pushing the liftgate button will not disarm
3
GETTING TO KNOW YOUR VEHICLE 33