2017 JEEP COMPASS spare wheel

[x] Cancel search: spare wheel

Page 145 of 429

JEEP COMPASS 2017 2.G Owners Manual NOTE:When filling warm tires, the tire pressure may need
to be increased up to an additional 4 psi (30 kPa) above the
recommended cold placard pressure in order to turn the
Tire Pressure Monitoring Te

Page 148 of 429

JEEP COMPASS 2017 2.G Owners Manual 2. Installing some form of aftermarket window tinting thataffects radio wave signals.
3. Snow or ice around the wheels or wheel housings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not

Page 196 of 429

JEEP COMPASS 2017 2.G Owners Manual WARNING!(Continued)
position of the floor mat and may cause interference
with the accelerator, brake, or clutch pedals.
• If the vehicle carpet has been removed and re-
installed, always properly at

Page 232 of 429

JEEP COMPASS 2017 2.G Owners Manual WARNING!(Continued)
•When hauling cargo, or towing a trailer, do not
overload your vehicle or trailer. Overloading can
cause a loss of control, poor performance, or damage
to brakes, axle, engine, t

Page 254 of 429

JEEP COMPASS 2017 2.G Owners Manual WARNING!(Continued)
vehicle for service purposes. The vehicle should be
jacked on a firm level surface only. Avoid ice or
slippery areas.
Jack Location
The jack and jack-handle are stowed under the lo

Page 255 of 429

JEEP COMPASS 2017 2.G Owners Manual 6. Block both the front and rear of the wheel diagonallyopposite of the jacking position. For ex-
ample, if changing the right front tire, block
the left rear wheel.
NOTE: Passengers should not remain

Page 256 of 429

JEEP COMPASS 2017 2.G Owners Manual CAUTION!
Do not attempt to raise the vehicle by jacking on
locations other than those indicated in the Jacking
Instructions for this vehicle.
NOTE: Refer to “Tires — General Information” in “S

Page 258 of 429

JEEP COMPASS 2017 2.G Owners Manual Do not raise the vehicle until you are sure the jack is
securely engaged.
3. Turn the jack screw to the left until the jack can be placedunder the jacking location. Once the jack is positioned,
turn t
Page:   1-8 9-16 next >